support, C. E !+- 300 mm B 250 mm RE 00 00

Q: On the drawing (attached , apply a datum feature symbols to create a datum axis A-B by using the…

A: The given data is: For left side: Shaft Diameter Upper Limit=9 6.40 mmShaft Diameter Lower Limit=ϕ…

Q: Draw the sectional front view (front section) and draw the orthographic projection (sideand top…

A: Asked: To draw the orthographic projection views of the given object.   The orthographic projection…

Q: 8 Share - 24 - A A A EE- E E li Text Direction Align Text OFind A几1→0G (i Arrange Quick A Shape Fill…

A: Given:- Δσ=50 KN/m2Cc=0.009LL-10 To find :- Settlement

Q: The hinge support at B, of beam AB shown below, has the magnified front view and sic view shown. The…

A: To fund diameter of pin B subjected to shear and double shear

Q: Assignm R= Station 18+26 18+00 17+00 16+00 15+68 3: For Arc 0 Deflection Angle (DMS) 0°0'0" Chord…

A: Horizontal Curve :  In order to transition between two tangent strips of road, a horizontal curve is…

Q: Explain what a kinematic contraint is.

A: The constraints between the rigid bodies are called as kinematic constraints. Due to kinematic…

Q: hat about pin d?

A: We know that Forces acting at Joint D are shown in figure below Forces moving away from joints are…

Q: A line has a bearing of S 33 deg. 24° 54" E. What is its azimuth? Show diagram

A: The Azimuth of line A can be calculated by subtracting the given bearing to 180°. Calculation:…

Q: 65 degree 6' - 17 degree 54'

A: 1 degree = 60' 65 degree 6' = 64 degree 66'

Q: P4-7) Create an orthographic projection of the following object. Draw the three standard views. SLOT…

A: This view is Orthographic projection. Model after completing in AutoCAD has been presented in next…

Q: Based on the attached enlarged floor plan, how many sq. m. of 16mm (5/8") plywood backing is…

A: Grab bars are graspable bars to help maintain balance and lessen fatigue while standing. They are…

Q: What are the commonly available switch actions?

A: Commonly available switch actions? ON-OFF, SPST. SPST = Single Pole, Single Throw.  (ON)-OFF,…

Q: If Ax B = = A.B then the angle between A and B will be %3D a) п b) π/2 ) π/3 TE e) None of the above…

A: To find angle between A and B

Connections

In steel structures, connections are the members that join two or more steel members. The connections are the most important members of any steel structure, and hence, they are designed more carefully. The majority of the construction cost of steel structures is incurred due to the connections. The design of connections is done as per the recommendations and specifications of the American Institute of Steel Construction (AISC).