suing motions of the plank

Q: What is the part’s over all length?_______________________ 6. Whatisthe part’s over all…

A: considering the detailed drawing of an object to find out the answers of the given questions.

Q: could you pls provide part D and E

A:

Q: What does the internal moment cause?

A: Internal moment are actually the moments due to the resisting forces generated when the cross…

Q: Identify the following sectioning views (a, b, and c). a O Removed, Revolved and Removed O All…

A:

Q: Solidworks. Units are IPS. 24 threads per inch. Primarily just need help designing the threads after…

A: It is asked to draw thread by using Solidworks software

Q: R L2 (Side view) (End view)

A: Given data: α (Bend angle) =70° Kba (Strecth factor) =0.33  t  (Stock thickness) = 0.3" R (Width…

Q: a) The maximum force P that can be applied to the system based solely on the boards is most nearly…

A:

Q: Name 3 types of fits?

A: The different types of fits are : 1) Clearance fit 2) Interference fit 3) Transition fit

Q: What is the lowest allowable dimension for the flats?

A: Solution:

Q: Anonymous answered this 221 answers a. area of wheel = pi*R² area of 6 cutouts = 6*pi*(R/5)² =…

A: Area of wheel= pi*R^2  Area of 6 cutouts= 6*pi*(R/5)^2 = 0.24*pi*R^2

Q: 12 mm wrench fit over the head of a bolt that is 1/2" across

A: Given: Wrench size =12 mm Bolt size =1/2" AF (across the flat) To determine: Whether the wrench is…

Q: Name the 2 types of axial loading?

A: Two types of axial loading are tensile and compressive stress. Both kinds of stresses arise within…

Q: What do the beams represent?

A: Beams are defined as the structural member which has the loading perpendicular to the major axis of…

Q: Describe the method of sections?

A: Method of section In this method we deal with the non-concurrent forces. Here, we get three…

Q: many hours did the carpenter work on the job? 6. What is the area of a rectangular floor that is…

A: Q.6 Given data as per question Length of floor = 7’-3” Width of floor = 4’-2”

Q: When utilizing pins to assemble rigging components, the "grip" area of the pin is  A. diameter of…

A: Rigging pins are generally measured by the diameter and the grip length. Given diameter can be…

Q: the main diference between the prick punch and center punch?

A: Prick punch is a mechanical tool, which is made up of steel and it is used to mark points on the…

Q: What is the sliding block?

A: To Define: Sliding block

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.