SThe 4-mm-diameter cable BC is made of a steel with E = 200 GPa. Knowing that the maximum stress in the cable must not exceed 190 MPa and that the elongation of the cable must not exceed 6 mm, find the maximum load P that can be applied as

Q: (a) If the rope is subjected to a vertical force of P = 500 N, determine the normal stress at points…

A: Diameter of the wooden post - 40 mm = 0.04 mVertical force, P =500 N

Q: Determine the value of Q so that the deformation at A is zero.

A: Given:E = 70 GPaP = 3.5 kNDiagram is givenTo find:Value of Q so that the deformation at A is zero

Q: A tensile stress is to be applied along the axis of a cylindrical brass rod that has a diameter of…

A: given; diameter (d)=10mmchange in diameter (δd)=2.5*10-3mmelasticity(E)=10.1*104MPapoisson's…

Q: The steel frame (E = 200 GPa) shown has a diagonal brace BD with an area of 1920 mm². Determine the…

A: Given Data- Area A =1920mm2 E=200GPa Change in length of BD =1.9mm We have to find Load P

Q: ogeth le of 25° with the horizontal. Knowing that the allowable str 0 kPa and t = 600 kPa, determine…

A:

Q: The 4-mm-diameter cable BC is made of a steel with E= 200 GPa. Knowing that the maximum stress in…

A: Given:Cable diameter = 4mmE =200 GPaMax Stress 190

Q: The 4-mm-diameter cable BC is made of a steel with E = 200 GPa. Knowing that the maximum stress in…

A: Step 1: Step 2: Step 3: Step 4:

Q: Two tempered-steel bars, each in. thick, are bonded to a 1/2 -in. mild-steel bar. This composite bar…

A:

Q: 2. Link BD is made of brass ( E = 103 GPa ) and has a cross-sectional area of 258 mm?. Link CE is…

A: Answer: The maximum force P that can be applied vertically at point A is 13.37815 kN.

Q: A 8-mm-diameter wire (E = 90 GPa) supports a tension load of 5 kN. If the total elongation of the…

A:

Q: The rigid bar ABD is connected to the rod BD which consists of a single bar with a width of 25,0 mm…

A:

Q: A 12-kN tensile load will be applied to a 50-m length of steel wire with E= 200 GPa. Determine the…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.