Answered: Steam enters an isothermal compressor…

Steam enters an isothermal compressor at 350°C and 100 kPa. The exit pressure is 10 MPa. Determine the change of enthalpy.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Steam enters an isothermal compressor at 400 0C and 400 kPa. The exit pressure is 10 MPa,determine the change of enthalphy.
Determine the exit pressure of steam which enters an isentropic turbine at 500°C and 2 MPa, and leaves as a saturated gas. (Give your answer in kPa to 1 decimal place).
In the compressed liquid region, the specific enthalpy is estimated by h = uf+ Pvf, where uf and vf are taken at the given temperature.True or False?
A 550 L at 1,400 kPa and 30 C compressed nitrogen storage has a leaky valve. resulting in gas to very slowly leak from the storage. It is noticed that after several days, the pressure in the tank has dropped to 600 kPa. Assuming that the leak happens slowly and under adiabatic conditions, determine the amount of nitrogen escaped from container in kg. Your Answer:
Steam at 110.546 kPa and 140.546oC is compressed isothermally until the quality of steam is 70%. determine the change in volume, change of specific internal energy, the change of specific entropy, and heat.
A piston cylinder contains 1.25 kg water at 25°C with a constant load on the piston such that the pressure is 300 kPa. A nozzle in a line to the cylinder is opened to enable flow to the outside atmosphere at 100 kPa and 25°C. The process continues until 85% of the initial mass has flowed out. At this point, the temperature of water increased by 10°C. Assume that the process is done in an Water isobaric manner. Write the mass and energy balance equations and calculate the work (kJ) and heat (kJ) involved in the process if the exit velocity is 40 m/s. For compressed liquid, assume the substance is a saturated liquid at the given temperature.
Determine the ratio of work steady flow for isobaric process to the work steady flow for polytropic process of 390.43 kg of saturated steam at 250°C until it reaches 1.5 MPa. Consider n = 1.86 for polytropic process.
Determine the change in enthalpy (Qinput/output kJ), using the specific heats at the average temperature from table B-6 for 2.5kg air is heated from 103°C to 451°C
Refrigerant 134a enters a compressor at 600 kPa as a saturated vapor. It exits at 60°C and 1.4 MPa. Determine the entropy change and the isentropic efficiency. Show the process on a T-s diagram with respects to the saturation lines.
Propane initially at 300 K and 100 kPa is is compressed to 1 MPa in a reversible, steady-flow, and compressor. Determine the amount of work in kJ/kg if the process is isothermal. Round your answer to one decimal place
Refrigerant 134a enters a compressor at 600 kPa as a saturated vapor. It exits at 60°C and 1.4 MPa. Determine the entropy change and the isentropic efficiency. Show the process on a T-s diagram with respects to the saturation lines. (30)