Steam enters a horizontal turbine at 350 lbf/in2 absolute, 580°C, and 12 ft/s and is discharged at 110 ft/s and 25°C saturated conditions. The mass flow is 2.5 lbm/s, and the heat losses are 187 Btu/lb of steam. The enthalpies h₁ and h2 are 3.92E7 ft·lbf/slug and 2.74E7 ft·lbf/slug, respectively. If head losses are negligible, how much horsepower does the turbine develop? hp

Steam enters a horizontal turbine at 350 lbf/in2 absolute, 580°C, and 12 ft/s and is discharged at 110 ft/s and 25°C saturated conditions. The mass flow is 2.5 lbm/s, and the heat losses are 187 Btu/lb of steam. The enthalpies h₁ and h2 are 3.92E7 ft·lbf/slug and 2.74E7 ft·lbf/slug, respectively. If head losses are negligible, how much horsepower does the turbine develop? hp

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Answer the following questions about air flowing through a nozzle as shown in the schematic below. The air enters the nozzle at 2.2 kg/m³ and 34 m/s and leaves at 0.72 kg/m³ and 130 m/s. The nozzle inlet area is 60 cm². The mass flow rate is 4.5 kg/s. The outlet cross-sectional area is 1 cm². P1 Nozzle V₂ P2
Air enters a gas turbine steadily at pressure 20 kPa, volumetric flowrate 1,000 m3/s, and temperature 300 oC. If the air exits the turbine at pressure 7 kPa and temperature 80 oC, determine the power generation in the turbine assuming changes in the kinetic energy and potential energy at the inlet and outlet condition is negligible. Determine the volumetric flowrate of air out of the turbine.
Four pounds of air gain 0.491 BTU/R of entropy during a nonflow isothermal process. If P1=120 psia and V2 = 42.5 ft3. What is the heat transfer?
8. Air enters a nozzle steadily at 2.21 kg/m³ and 30 m/s and leaves at 0.762 kg/m³ and 180 m/s. If the inlet area of the nozzle is 80 cm², determine the mass flow rate through the nozzle in kg/s.
a- In the fig shown air entering a diffuser at 70 kpa , 27 °C , with a velocity of 100 m/s. and leaves at 20 m/s. If Air the inlet cross section area of 1cm? and the outlet 8.6 cm determine the exit pressure and temperature of air.( 1 kJ/kg = 1,000 m/s²) consider the case of ideal gas and CP = 1.004 kJ/kg.
In a steady flow apparatus, 135 kJ of work is done on each kg of fluid. The specific volume of the fluid, pressure, and speed at the inlet are 0.37 m /kg, 600 kPag, and 160 m/s. The inlet is 32 m below the floor, and the discharge pipe is at floor level. The discharge conditions are 0.62 m /kg, 100kPag, and 27 m/s. The total heat gained between the inlet and discharge is 9 kJ/kg of fluid. In flowing through this apparatus, by how much does the specific internal energy increase or decrease? O 290.8 (increase) 2.79 (increase) O 2.79 (decrease) O20.79 (increase) Next Previour
Steam (water vapor) enters a stainless steel tube with inner diameter 4cm at 300°C and 60 bar absolute pressure, with a velocity of 8.00 m/s. The steam exits the tube at 300°C and 40 bar absolute pressure. a. Assuming the water vapor behaves as an ideal gas, calculate the steam mass flow rate and the change in kinetic energy (in Watts). b. Using the specific volume values from table B.7, calculate the steam mass flow rate and the change in kinetic energy (in Watts).
The entropy (s) of steam at pressure P = 18 MPa and internal energy (u) = 1699.1 kJ/kg is approximately: O 5.1064 kJ/kg. K O 1.2343 kJ/kg. K O 3.8720 kJ/kg. K
A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty pound- mass per minute of air at 285 psf, and 270 degrees Fahrenheit. The fluid is discharged from a point five meters above the datum/ reference point at 4,255 psf and 750 degrees Fahrenheit. Assuming that the velocity found at the inlet is 6,285 feet per minute and the Heat supplied is 580 BTU/min. During the process the density decreases by 15 percent and the internal energy is decreased by 1.05 horsepower. Determine the Work done in (a) Horsepower and BTU/s. (b) Considering the given on 3a, if the Work done is doubled, determine the Heat supplied during the process? (c) Considering the given on 3b, if Heat is doubled, what is the work done after 6 minutes?
A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty pound- mass per minute of air at 220 psf, and 250 degrees Fahrenheit. The fluid is discharged from a point five meters above the datum/ reference point at 4,275 psf and 750 degrees Fahrenheit. Assuming that the velocity found at the inlet is 8,275 feet per minute and the Heat supplied is 580 BTU/min. During the process the density decreases by 15 percent and the internal energy is decreased by 1.05 horsepower. Determine the Work done in (a) Horsepower and BTU/s. (b) Considering the given on 3a, if the Work done is doubled, determine the Heat supplied during the process? (c) Considering the given on 3b, if Heat is doubled, what is the work done after 7 minutes?
A wind tunnel is considered to be a steady-state operation, the system receives one hundred fifty pound- mass per minute of air at 200 psfg and 240 degrees Fahrenheit. The fluid is discharged from a point five meters above the datum/ reference point at 4,155 psf and 550 degrees Fahrenheit. Assuming that the velocity found at the inlet is 7,005 feet per minute and the Heat supplied is 515 BTU/min. During the process the density decreases by 15 percent and the internal energy is decreased by 1.05 horsepower. Determine the Work done in (a) Horsepower and BTU/s. (b) Considering the given on 3a, if the Work done is doubled, determine the Heat supplied during the process? (c) Considering the given on 3b, if Heat is doubled, what is the work done after 9 minutes?
Q8. A gas enter a turbine with a velocity of 300 m/s and a temperature of 527 °C and specific internal energy of 688 kJ/kg and density of 2.7 kg/m³ . The gas expand adiabatically from a pressure of 620 kN/m² to 130 kN/m² .The gas leaves the turbine with velocity of 150 m/s. Determine the power output from the turbine in kilowatt. Take the mass flow rate of 4 kg/s. 00 limite through ongine Qvel 300 °C ond 50 9C tho hoot roiootod tompooretur