Answered: Source TH Carnot HE net,out 800 Btu/min

Engineering

Mechanical Engineering

Source TH Carnot HE net,out 800 Btu/min

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

None
The maximum thermal efficiency (in %) possible for a power cycle operating between 1323 °F and 217°F is:
What is the power plant maximum demand if the dermand factor is equal to Plant Load Factor with average load of 1,012 kw and total connected load of 2,110 KW 1,025.5 MW 1,050.21 MW (C) 1,067.66 MW 1,091.76 MW
Numerical answers shall be in four (4) decimal places. Box your final answers
QN 44 A Cframe subjected to a force of 15 kN is shown in Figure. It is made of grey cast iron FG 300 d the factor of safety is 2.5 Determine the dimensions of the crosssection of the frame. (t = 15.81 mm) 15 kN -7,5t- 15 kN QN 45 The principal stresses induced at a point in a machine component made of steel 50C4 (Syt = 460 N/mm) are as follows:s1= 200N/mm s2 = 150 N/mm2 s3 = 0 Calculate the factor of safety by (i) the maximum shear stress theory, and (ii) the distortion energy theory. 1) 2.3 (ii) 2.55] 2806 ON 46 The
a student, observed that she can focus more in her lessons if the air conditioning unit in her spacious room is opened. She usually set the temperature to be maintained in her room at 10 C. The temperature outside of her room is 40 C. The refrigerant of her AC unit is HFC-134 a. What is the coefficient of performance of her AC unit if it is operating on a Vapor Compression refrigeration cycle? The compressor efficiency is 0.7.
Required information Refrigerant-134a enters the condenser of a steady-flow Carnot refrigerator as a saturated vapor at 65.0 psia, and it leaves with a quality of 0.05. The heat absorption from the refrigerated space takes place at a pressure of 30 psia. Determine the coefficient of performance. (Round the final answer to three decimal places.) The coefficient of performance is
NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. The gas-turbine cycle of a combined gas–steam power plant has a pressure ratio of 8. Air enters the compressor at 290 K and the turbine at 1400 K. The combustion gases leaving the gas turbine are used to heat the steam at 15 MPa to 450°C in a heat exchanger. The combustion gases leave the heat exchanger at 247°C. Steam expands in a high-pressure turbine to a pressure of 3 MPa and is reheated in the combustion chamber to 500°C before it expands in a low-pressure turbine to 10 kPa. The mass flow rate of steam is 12 kg/s. Assume isentropic efficiencies of 100 percent for the pump, 85 percent for the compressor, and 90 percent for the gas and steam turbines. A.) Determine the mass flow rate of air in the gas-turbine cycle. Use steam tables and the table containing the ideal-gas properties of air. The mass flow rate of air in the gas-turbine cycle is ___?___kg/s…
Enumerate the four processes comprised in the cycle of a typical heat engine
Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. A commercial refrigerator with refrigerant-134a as the working fluid is used to keep the refrigerated space at -30°C by rejecting its waste heat to cooling water that enters the condenser at 18°C at a rate of 0.29 kg/s and leaves at 26°C. The refrigerant enters the condenser at 1.2 MPa and 65°C and leaves at 42°C. The inlet state of the compressor is 60 kPa and -34°C and the compressor is estimated to gain a net heat of 430 W from the surroundings. The heat exchanger loses no heat to the environment. 26°C 42°C ↓ Condenser 3 Expansion valve Water 18°C Evaporator QL (2) 1.2 MPa 65°C lin Win Compressor 60 kPa -34°C Determine the COP of the refrigerator. (You must provide an answer before moving on to the next part.) The COP of the refrigerator is
A refrigerator uses refrigerant-134a as the working fluid and operates on an ideal vapor compression refrigeration cycle between 0.18 and 0.7 MPa. The mass flow rate of the refrigerant is 72.4 g/s. Determine the power input to the compressor (in kW). Do not answer in image format
a student, observed that she can focus more in her lessons if the air conditioning unit in her spacious room is opened. She usually set the temperature to be maintained in her room at 10 C. The temperature outside of her room is 40 C. The refrigerant of her AC unit is HFC-134 a. What is the coefficient of performance of her AC unit if it is operating on a Carnot refrigeration cycle? The compressor efficiency is 0.7