Solve this h.w. with the following requirements: 1) Cl is a Capacitive impedances in uf and ZI = 30|90°. 2) LI is an Inductive impedance in mH, Z2 =50|-90° and lastly, R1 is a resistor. 3) Sl is a sinusoidal voltage source with a frequency of 6 kHz and a phase shift of 50°. Find the Current I and voltages of all impedances in sinusoidal form? ci zi 5uf IOV si Z2 RI LI 3 2mH Ohm Sı=10 v SI=I0 V Cl=5 uf RI=3 Ohm LI=2 mH

Solve this h.w. with the following requirements: 1) Cl is a Capacitive impedances in uf and ZI = 30|90°. 2) LI is an Inductive impedance in mH, Z2 =50|-90° and lastly, R1 is a resistor. 3) Sl is a sinusoidal voltage source with a frequency of 6 kHz and a phase shift of 50°. Find the Current I and voltages of all impedances in sinusoidal form? ci zi 5uf IOV si Z2 RI LI 3 2mH Ohm Sı=10 v SI=I0 V Cl=5 uf RI=3 Ohm LI=2 mH

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q5)-a)For this figure shown below the phase relationship between the sinusoidal waveform Of this set. -10sin(wt+80) V=15sin (wt+40) Q5)-b) for this circuit find the max energy if XL=100 Vm-300v,L=0.3H V= Vm Sinwt
Introduction to Ac circuits. show detailed illustration and step by step solution
Sketch or lay out the diagram of the system. The specificities are as follows: Resistors 2 and 3 are laid out in parallel with each other; Resistor 1 and Capacitor 1 are in series with each other and with Resistor 2; The loop is traced so that the value of resistor's voltage is negative. Determine the current flowing in the RC series circuit. Find the voltages used by each resistor.
In the circuit in Figure 2, the capacitor and The circuit of resistance is defined as a load circuit. A) Find the average power dissipated by the load circuit. B) how much of the average power calculated in a) by the resistance in the load circuit and how much spent by the capacitor? Comment on the results obtained? C) In the circuit in Figure 2, 2 / 3? A coil of is connected in series. In this case, Calculate the transformer ratio (n) to optimize power distribution to the load? Obtained comment on the result? D) Calculate the complex power and reactive power dissipated by the load in the newly created circuit.
A sinusoidal current of 1.5 Arms is flowing through a capacitor of capacitance 20 uF. Find the Voltage across the capacitor at a frequency of 250HZ. Select one: O a. 0.471 O b. 0.047 O. 47.746 O d. 0.181
Consider a drcuk where an ideal inductor L=D.144H is connected in parallel to a resistor R=1.00k. This combination is connected in series with a capacitor C=3.67e-07. This combination in connected to a power supply source of frequency f-3.4kHz. To study this circuit you need to drawa phasor diagram. Note the sum cf the current phasors through the resistor and the inductor must be equal to the phasor representing the current through the capacitor fie. the total current). You should draw the phasor for the current through the capadtor on the horizontal axis, since this is also the total ourrent delivered by the supply. The angie between this phasor and that of the power supply represents the phase angle o. Note that the voltage across the inductor equals the voltage aoross the resistor since they conmected parallel to esch other. Furthermore the sum of the phasors representing the currents through the inductor and the resistor equals the phasor representing the current through the…
I dont understand phase shift and lags?
A sinusoidal current of 5 Arms is flowing through a series combination of a resistor and Inductor. The value of R is 45 ohms and that of the inductance is 15 mH and a frequency of 60 Hz. Find the magnitude and the phase angle of the voltage across the combination. (Hint: you can use phasor diagram). Select one: a. [V]=28.89, angle=9.39 b. IV]=25.60, angle367.00 c. [V]=128.01, angle3D10.18 d. IVl=226.77, angle=D7.16
) Evaluate In C3tja) + h (2tjo). Convert your answer to polar form.
QUESTION 5 A resistor, a capacitor, an inductor, and a mystery component are connected in parallel. The resistor has a resistance of 300N, the capacitor has a reactance of 2500, and the inductor has a reactance of 6000. The total impedance of the circuit is 59.52-j119.640. What is the mystery component? O there is no mystery component O resistor O inductor O capacitor
The phasor of the impedance of an AC circuit has no vertical component. What does this mean? there are no reactive components in the AC circuit the resistance of the circuit is equal to the reactance of the reactive components the inductive reactance and capacitive reactance are equal in magnitude there are no inductors in the circuit
find The average power delivered to * .the circuit