Solve the following questions using Kirchhoff's Law 15. If R1 = 20, R2 = 40, R3 = 602, determine the electric current flows in the circuit below www R₁ E =9V it Ę₂-3 V www R R₂

Q: Approximate solution time is 5 minutes. A transformer supplies power to a feeder that has five…

A:

Q: sinco so l0d) ideal transformer M:05 Vi amplitnate is Sovi icoHz. Li=0.4H Lo=o.5H tind VR, in time…

A: The ideal transformer in the above figure is converted into the T- circuit model

Q: State the difference between Kirchhoff’s and Nodal analysis.

A: Node is a point at which two or more than two element are  joined . In the  circuit dot is used to…

Q: Redo it again with full details..

A: Given: 3:8 Decoder To find: we have to form the truth table for 3:8 decoder.

Q: Electrodynamic meters can measure ac signals only. True False

A: In this question , we will write about electro dynamic meters...

Q: Question 1 Is the FSM a Mealy or Moore machine? Choose '0' for Mealy and '1' for Moore. Reset So…

A:

Q: Critical resistance of a self-excited generator is closely related to the speed of the machine True…

A: Critical resistance is related to self excited generators. It is the maximum resistance. At this…

Q: True or False: In a DC Machine, the field windings can only be found at the Stator

A: In DC motor the field winding is on the stator of the motor and the armature winding is on the rptpr…

Q: Write down the differential equations describing the loop currents of the given circuit. Assume…

A:

Q: The frequency is known as ohms but many times, it is referred to as cycles. Select one: TRUE FALSE

A: To discuss whether the given statement is correct or not. Statement: The frequency is known as ohms…

Q: Gear box in the wind turbines rotate typically between 400 rpm and 40 rpm. Generators typically…

A: Yes it is TRUE

Q: FIND THE VALUE OF Rab IN THE CKT. 22 222 ·30 a-M ## Rab $20 bo se 10002

A:

Q: If A = 20260° and B= 5230°, find the products AB and BB".

A:

Q: Why do we have horizontal and vertical lines in a breadboard, and what are the advantages of these…

A: The breadboard vertical lines and horizontal lines have no relation to do with Kirchhoff's and ohms…

Q: The relation between current and admittance locus is the voltage False True

A: I=VY ohm's law,and Constant Voltage  V, so the admittance locus Y represent the change in current I…

Q: Force on -q is with field direction ,and Force on +q is against field direction. O True False

A:

Q: Choose the supply voltage for a step down chopper circuit which drives the resistive load 4.80 with…

A:

Q: HW.sA long solenoid that has loo0 turns distributed overalenyth of a-4 m producesanaguetic field of…

A:

Q: Cite practical applications of Kirchhoff’s Laws and Divider Rules.

A: Kirchhoff's laws: 1) Kirchhoff's current law: According to this law, the sum of total incoming and…

Q: What is the difference between Kirchhoff’s and Nodal analysis.

A: In this question we will find difference between Kirchhoff’s and Nodal analysis....

Q: In fast decoupled method, the strong coupling between the following is used, a. Q and V b. Pand V c.…

A: In high voltage transmission systems, the voltage angles between adjacent buses are  small but,  X/R…

Q: please write introduction of Study of transformers

A: we need to explain introduction of Study of transformers

Q: Manufacturers usually specify the impedances of machines and transformers in O Percent O Per-unit O…

A: Need to Find correct option

Q: A transformer supplies power to a feeder that has five customers. Daily maximum demands for these…

A: Introduction: The inverse of the diversity factor is the coincident factor.It is the ratio of the…

Q: 3) a) First put the numerator and denominator in exponential/polar form then find all

A: Given: F=-1-1i-2+12i-3+1i14

Q: ja ll l ell V, Fig 1. Per phase equivalent eireuk ol 3phse indection motor IL Fe. 2. Approsimate…

A: Induction motor working Principle When an ac supply is connected to a stator it creates a rotating…

Q: Explain what RLC circuits do and how they work including transformers, where applicable.

A: It is asked to explain what RLC circuits do and how RLC circuits can work including transformers…

Q: A 100 KVA, 2200 / 220 v, 50 cps transformer has the following constants: Rp = 0.42 Ω, Xp = 0.72 Ω,…

A: Given Transformer rating = S=100 KVA Turns ratio = K =2200220=10 Frequency= 50 cps =50 Hz Primary…

Q: Quèstion 14 The point form of Ampere law is given by Curl(D) = J Curl(V) = I Curl(B) = I Curl(H) = J…

A: In this question we will write point form of amperes law...

Q: The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base…

A:

Q: If a 19 m/s wind is blowing on a wind turbine and the tips of its blades are rotating at 62 m/s,…

A: Need to find tip speed ratio

Q: 48. One weber is equal to: a. 1x 108 Maxwell b. 1x 106 Maxwell C. 1 x 10° Maxwell d. 1x 10¹0 Maxwell…

A: 48.  One Weber is equals to 49. According to Biot-savart and Ampere's Law, the direction of magnetic…

Microscopic view of current

In physics, the term current is expressed as the rate of flow of electric charges across the area per unit time (I=q/t). It propagates along in the direction of the motion of positive charges. When the current is caused by the motion of electrons, the direction of the current is opposite to the flow.