4. A steam power plant operates on the reheat Rankine cycle. Steam enters the high-pressure turbine at 12.5 MPa and 550°c at a rate of 7.7 kg/s and leaves at 2 MPa. Steam is then reheated at constant pressure to 450°C before it expands in the low-pressure turbine. The isentropic efficiencies of the turbine and the pump are 85 percent and 90 percent, respectively. Steam leaves the condenser as a saturated liquid. If the moisture content of the steam at the exit of the turbine is not to exceed 5 percent, determine (a) the condenser pressure, (b) the net power output, and (c) the thermal efficiency

Q: Question 8 What is the total reactance of the circuit shown below? A.1.194 k B. 796 N C. 683 2 D.…

A: In this question we need to find a total reactance of the given circuit.

Q: Summary Hybrid systems in seawater desalination? Hybrid systems in seawater desalination in daily…

A: The seawater desalination is the process of removal of salt and impurities from seawater to…

Q: Calculate for the value of VL(peak). Please show your complete solution. Thank you.

A:

Q: f a capacitor produces 15 ampere on a 240-volt supply, which of the following is its microfarad…

A:

Q: Q. 37 Define SCR. Explain its V - I characteristics. By Handdrawn sketch

A: A Silicon Controlled Rectifier (SCR) is a crucial semiconductor device widely used in power…

Q: The 2N5459 has a rating of gmo VGS(off) = -8 V. = 4 ms determine the value of gm at VGs = -3 V. For…

A:

Q: DG CIRCUIT CHALLENGE SOLVING FOR DC CIRCUIT COMPONENT VALUES

A: In the given questions we need to calculate the voltage current and power of each element.

Q: A coil has resistance of 5 ohm and inductive reactance of 4 ohm. a) what is the impedance of the…

A: This question belongs to circuit theory . It is based on the concept of impedance and admittance of…

Q: 19 Polymers such as PVC are commonly used in coating electrical wires due to what properties? (A)…

A:

Q: Calculate the voltage at a distance of 200 m of a 300 m long distributor uni formly loaded at the…

A:

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).