solve a,b and c asap. A steam turbine with rated capacity of 56.4 MW operates with steam at inlet conditions of 8.6 MPa and 500 oC, and discharges into a condenser at a pressure of 10kPa. Assuming a turbine efficiency of 0.75, determine: a. The state of the discharge from the turbine (saturated liquid, saturated mixture or saturated vapor...etc?) b. The steam mass flow rate c. Draw the process of steam expansion in the turbine on T-s diagram (T-s diagram only)

Q: Problem 2: Known: The gas turbine cycle working under the principle of Brayton cycle (a) Explain…

A:

Q: an ammonia refriferation cycle operates at 12C suction temperature and 300 kpa condensing pressure,…

A: Since we only answer up to 3 subparts, we will answer the first 3. Please resubmit the question and…

Q: A stem power plant operates with high pressure of 5.5 MPa, and has boiler exit temperature of 450…

A:

Q: a. Total heat added b. Total turbine work C. Heat rejected in the condenser d. Total pump work e.…

A: IN THIS PROBLEM USE STEAM POWER CYCLE WITH THE BOILER PRESSURE OF 10MPA . AND THE TEMPRETURE OF THE…

Q: It is proposed to design and develop a Rankine cycle Steam Power Plant in which steam at 80 bar and…

A: As per the guidelines, I can solve only first three subparts. For other parts, please repost in a…

Q: A pressure relief valve is installed in a rigid 25-L steam cooker to release vapor and maintain…

A: To determine the smallest entropy change of the thermal energy reservoir.

Q: In an ideal reheat cycle, the steam throttled condition is 8 MPa and 480 degree C. the steam is then…

A:

Q: If the Rankine cycle shown in the figure is an "Ideal Rankine cycle", what assumptions do you…

A: ideal Rankine cycle Assumptions 1) no internal friction  2)Boiler and Condenser are constant…

Q: 5. In a Rankine cycle, the steam at inlet to turbine is saturated at a pressure of 30 bar and the…

A: Concept of Rankine Cycle And Formula Is Used

Q: c) To examine the behavior of turbocharging, we shall consider the following example of a four…

A:

Q: Question attached

A: Saturation Pressure: The pressure exerted by the vapour on the liquid when both liquid and vapour…

Q: Completely solve and box the final answers. Write legibly In a steam turbine plant, a single bleed…

A: The T-s diagram of the given power plant is here, x is the fraction of steam extracted To…

Q: A medium size power station is used to produce 30 MW net power for a refinery. The station uses…

A:

Q: A turbine operates under the following conditions, steam being bled off from two stages for feed…

A:

Q: An open-cycle gas turbine plant will exhaust into a waste heat boiler which receives 66 °C…

A: Write the given data.      P=2611 kW     x=37 kg/kW·hrrf/a=0.014 kg fuel/kg air  Te=483°C  cp=1.082…

Q: Rannkin cycle     1_The value of enthalpy at point 1 is ( h1 =?) 2_ value of enthalpy at point 2…

A:

Q: Task 1 Derive the non-flow and flow energy equations from first thermodynamic principles. Task 2…

A:

Q: a alll Asiacell The unit of temperature in S.I.-17 * units The unit of temperature in S.I. units is…

A: Note: - As per the guidelines of Bartleby, only one question is allowed to answer so please submit…

Q: Air with a pressure of 0.1 MPa and a temperature of 25oC with a flow rate of 5.29 kg/minute enters a…

A:

Q: 2.3 A. Calculate the thermal efficiency of a Rankine cycle in which the steam is initially dry…

A:

Q: An engineer in a steam power plant is tasked with calculating: a. The isentropic efficiency of the…

A: Given Data, Inlet pressure to the turbine= 6MPa Inlet temperature to the turbine= 500oC Outlet…

Q: Unit No. 6 at The Geysers produces 52 MW of power at the generator from a steam flow of 417,000 kg/h…

A:

Q: Air enters the compressor of an ideal air-standard Brayton cycle at P1-98 kPa and T1-320 K, with a…

A:

Q: Problem (1.2) A steam power plant working according to simple Rankine cycle. It has a high pressure…

A:

Q: Nitrogen gas is being compressed from 105 kPa and 295 K to 460 kPa and 553 K, if 17 kJ/kg of heat…

A:

Q: Q) A cycle operate on (1 kg) of slandered air with an initial pressure of (0.98 kg F/cm?) and a…

A:

Q: Problem 1 In a Rankine Thermodynamic cycle, steam leaves the boiler and enters the turbine at 600…

A: “Since you have posted a question with multiple sub-parts, we will provide the solution only to the…

Q: (a) Identify the effectiveness of a regenerator and demonstrate why the enthalpy value before the…

A: Solution:

Q: What is the mass flow rate flowing through the boiler?

A:

Q: Diesel Cycle has a volume displacement of 0.95 m3 and the volume at during heat rejection is 1 m3.…

A:

Q: Which of the following are true for the limitations and impracticalities of the turbine of the…

A: Limitations and Impracticalities of turbine of the Carnot vapor cycle: Quality of steam decreases…

Q: What are the advantages of 1-reheater 2-economizer 3-fixed row of steam turbine.

A: Advantage of reheater: It increase the thermal efficiency of the thermal power plant. It reduce the…

Q: An open-cycle gas turbine plant will exhaust into a waste heat boiler which receives 66 0C…

A:

Q: Calculate thermodynamic and isentropic efficiency of a turbine: Mass flow rate 5kg/s = Condenser…

A:

Q: In a Steam power plant working on ideal Rankine cycle. Steam enters the turbine at 13 MPa and 600…

A: Given,

Q: A:-Prove that the efficiency of Otto cycle is 1 =1 rek-1 Otto

A: NOTE- According to bartleyby policy we shall answer only one question at a time so kindly repeat…

Q: Question 6 of 14 -/2 Referring to the reversible heat pump cycle shown in the figure, p1 = 14.7…

A:

Q: A system consists of a turbine and heat exchanger are connected in series. The working fluid is…

A: Solution: Since the expansion in the turbine is adiabatic, P1P2=V2V1γ0.60.21γ=V2V1V2V1=311.4=2.191…