Solute A has partition coefficient K between benzene and water of 32 Le. Ais 32 times more soluble in benzene than water. 150 mi of a 0.010M aqueous sof of Asersd Cte Calculate the of A that remains in the aqueous phase after 1.A single extraction with 300mis CH 2. Four extractions, each with 75 mis CH

Q: Mangrove bank containing 48% tannin and 13.5% water soluble non-tannin material, on a dry basis, is…

A:

Q: countercurrent absorption tower receives 100 kmol of a gas mixture per hour having 15% of a solute…

A:

Q: If 5.0 grams of caffeine dissolved in 100 ml of water was extracted once using 60 ml of CH2Cl2, how…

A: Given that: Caffeine mass dissolved in water, w = 5 g Volume of water, V = 100 mL Volume of CH2Cl2,…

Q: A countercurrent-flow, plate-and-frame dialyzer is to be sized to process 0.78 m3/h of an aqueous…

A: The volumetric flow rate of the inlet stream to the dialyzer, Vin = 0.78 m3/h Concentration of H2SO4…

Q: For Mixture of sand and water, the boiling point rise (B.P.R.) will be O Smaller than pure water O…

A: Boiling point rise: Boiling point rise occurs because when solute is added in the solvent there is…

Q: Q2/ aqueous solution has 35% NaCl and 65% water by mass entered to crystallizer were 5 kg/hr of…

A:

Q: Solve the following parts: a) An aqueous solution of 25 wt% glucose (C,H1206) has a specific gravity…

A: a) The specific gravity of the aqueous solution is SG = 1.3  Thus, the density of the glucose…

Q: For pilot test purpose in mud lab. , 1L of FWB has been prepared , if the volumetric percentage of…

A: Volume of mud=1L Vol% of bentonite in mud = 0.03 Find Mud Density Water and bentonite volume Barite…

Q: Tannin is produced from tree barks by leaching with water. In the leaching process, 100 tons of feed…

A: Given information: Feed, L0 = 100 ton = 200000 lb Feed composition: 20% soluble tannin, 2% water.…

Q: Q3 :- what is the percent of solution made by adding 40 mL of Methanol to 0.4 L of water

A: Given  Volume of methanol = 40 mL Volume of water = 0.4×1000                               = 400 mL…

Q: A compound had a molar absorptivity of 2.93 x 103 L cm-1 mol-1 What concentration of the compound…

A: Beer Lambert's law is a relationship between the physical properties of the solution and the…

Q: If 10 mL of the sample solution from the batch reactor is mixed with 0.20 M HCl of 15mL and then…

A: Given that- Volume of sample solution, V1= 10 mL= 0.01 L Volume of HCl solution, V2= 15 mL= 0.015 L…

Q: For a nitrate ion selective electrode, the selectivity factor for nitrite over nitrate is 0.062 and…

A: In the given question it is asking for nitrite and perchlorate present in the concentration of…

Q: A column provided with or 8-m packed bed is being Lised to air strip trichloroethylene (TCE) in…

A: For a detailed solution, please see the attached files.

Q: What is the diffusion flux of acetone across a 15-mm layer of air flowing in the opposite direction…

A: (a) The length from point 1 is to be determined for the 10%  acetone.   The diffusion is taking…

Q: A column provided with a 3-m packed bed is being used to air strip trichloroethylene (TCE) in…

A: Given data: Height of the packed bed = 3 m Concentration of TCE in liquid stream entering the tower…

Q: the number of theoretical stages needed

A: In mass transfer, an extraction process is carried out to separate the solute particles and solvent…

Q: Flaked soybeans are to be leached with hexane to remove the soybean oil. Following experimental data…

A: Soyabean flakes =20% Solvent=0.5% 1 kg hexane as fresh solvent  10% of the insoluble solid in the…

Q: The most soluble gas in a specific solvent is the one with which value of Henry's law constant? O 10…

A:

Q: control. Using the data provided, estimate the diffusion coefficient of the ferricyanide.

A:

Q: (d) Often, a low flow of water can make the concentration of dissolved lead in the pipe flow even…

A:

Q: Q2:- how many milliliters of ethanol that dissolved in 400 ml of solution by percent 35% ?

A: Given data V1 = 400 ml  X = 35 %  Find dissolved volume (V2) = ?

Q: Separation of a mixture of sand, NaCl and CaCO3 Part 2 (Values from this part may be used on parts…

A: Given: mass of watch glass, filter and CaCO3 W1=13.57g mass of watch glass and filterW2  =12.43g

Q: For a nitrate ion selective electrode, the selectivity factor for nitrite over nitrate is 0.062 and…

A: In the given question it is asking for nitrite and perchlorate present in the concentration of…

Q: Salt A of 60 g is mixed with 300 g solvent. Solubility is 30 g A/100 g solvent. 3a) What is the…

A: Given, Mass of salt A = 60 gmass of solvent = 300 g

Q: How many grams of solute do you need to prepare a buffer (1.6 M Na Citrate 50 mM Tris-base) for a…

A: The Molecular mass of Na Citrate = 258.06g Molarity = 1.6 Volume = 500ml = 0.5l

Q: Calculate     a)     molar     flux     of     B     b)     interfacial    concentration     of    B…

A:

Q: why are used the (lead/ silver, carbon/ silver, gold/silver) probes for determine DO concentration…

A: The DO( dissolved oxygen ) is the amount of oxygen that is present in water. It is the important…

Q: Oilseeds containing 20% oil by weight will be extracted with pure solvent in a multi-stage leaching…

A: Given that:Oilseeds= 20% oil by weightExtract phase (overflow) composition= 50% oil by weightOil…

Q: A stock containing 1.526 kg moisture per kg dry solid is dried to 0.099 kg moisture per kg dry solid…

A:

Q: Experiments were conducted to concentrate the protein solution with initial concentration 1 kg/m3…

A: With the exception of the Lewis-Matheson method, all the methods listed above require the…

Q: 1.- During the recovery of phenolic compounds from nixtamalization wastewater (NWs) using an UF…

A: Given that, Ultrafiltration UF membrane is used for the recovery of phenolic compounds from…

Q: In 100L of water, there are 30kg of solute. If the distribution coefficient is 4, what is the weight…

A: Given data: Volume of water; V1=100 LDistribution Coefficient; K=4Volume of ether; V2=35 LAmount of…

Q: 3- In a titration experiment, 50 mnL of 0.20 M KOH solution was used to neutralize 20 mL of H2S04…

A: The molarity of the acid is to be calculated.

Q: Estimate the effective diffusivity of thiophene (molecular weight 84) in hydrogen at 660K and 30…

A:

Q: 5.40 Determine the retardation factor for a. MEK b. Naphthalene c. Hexachlorobenzene for a…

A:

Q: QI// A- Calculate the height of plate column with tray spacing of 0.51 m and tower efficiency based…

A: Given: Tray spacing  = 0.51 m The concentration of ammonia is to be reduced from, Y1 = 5.5 mol% or…

Q: 11

A: Given that- Molar Concentration,  C= 0.239 M= 0.239 mol/L Volume, V= 500 mL = 0.5 L Now, to prepare…