SITUATION: A 300mm x 600mm reinforced concrete beam section is reinforced with 4 - 28mm dimeter tension steel at d = 536mm and 2 - 28mm diameter compression steel at d' = 64mm. The section is subjected to a bending moment of 150kNm. Use n = 9. 16. Determine the maximum stress in the concrete. A. 6.71 C. 4.99 D. 14.30 B. 7.61 17. Determine the maximum stress in the tension steel. C. 128.67 A. 4.99 B. 89.85 D. 14.30 18. Determine the maximum stress in the compression steel. A. 128.67 B. 14.30 C. 4.99 D. 89.85

Q: A beam cast monolithically has the following properties: bf=1200mm, t or hf = 110mm, bw=380mm and…

A:

Q: : The T- beams sections shown in the figures below. f'c-28 Mpa, fy-420 Mpa. Calculate the design…

A:

Q: Find the ultimate moment of resistance for the rectangular section reinforced as shown below.

A: b = 280 mm              d = 510 mm              d' = 50 mm (Taking 50 mm effective…

Q: 4-ø28 mm at the bottom and 2-ø20 mm at the top of the beam, Concrete covering to centroid of…

A:

Q: two span beam subjected to shear and flexure only is reinforced as follows: Given: Stirrup…

A: %pt = Ast / Ac  Ac = b * deff

Q: NWC M= 50 ft.

A:

Q: A W 305 x 87, 7.5m llong, is pinned at both ends and braced in the weak direction at the third…

A: W305 x 87 section L = 7.5 m or 7500 mm A = 10965 mm2 Ix = 331.2 x 106 mm4 Iy = 55.78 x 106 mm4

Q: A floor slab 100 mm thick is cast monolithically with beams 250 mm wide 450 mm deep spaced 1.2 m on…

A: Answer  (1) Calcualtion of Nominal Moment capacity Calculation of Nominal Moment capacity of singly…

Q: A composite beam cross section is made up of two rectangular strips. Each of (100x50) mm placed and…

A: A composite beam cross-section-To Find-The axial stress in the steel portion.

Q: A W18 x 40 floor beam supports a 4-inch-thick reinforced concrete slab with an effective width b of…

A: Given; W18 x 40 floor beam fc'= 4 ksi Positive service load moment =290 ft-kips Effective width b =…

Q: 3m 200 ↓ 8m GkN/m B 十 -2m-

A:

Q: L (m)=2.8   h (mm)=375    hs (mm)=325    b (mm)=275  (Ơst)allow (MPa)=150 (Ơconc)allow (MPa)= 18

A: Following Indian standard code IS 456 - 2012   The ultimate moment of resistance:(Limit State…

Q: A simply supported beam is carrying a uniform load. If the beam properties are given below, what is…

A:

Q: AW18 x 40 standard steel shape is used to support the loads shown on the beam. Assume P = 20 kips, w…

A:

Q: solve Any numerical problem on stresses and strains for multiaxial loading conditions.

A: Consider a bar of elastic material subjected to direct compression stress, σ in longitudinal…

Q: A beam has a width of 300 mm and total depth of 600 mm strength fc=36 MPa. Steel yield strength…

A: Given, b = 300 mm  d = 600 mm f'c = 36 MPa fy = 415 MPa

Q: PROBLEM 2. If the beam in Problem 1 is to be replaced by a rectangular beam below using a concrete…

A: From the problem 2, it is required to find out the whether the beam is safe for design or not.

Q: Design the reinforcement of a T-beam to resist a factored moment of 750 kN.m. Properties of the…

A:

Q: A rectangular beam has a width of 298mm and an effective depth of 465mm. It is reinforced with…

A:

Q: r is designed to ca 20KN. Using allow 20MPa and ỢC = 6

A:

Q: The three suspender bars AD, BE, and CF are made of the same material (E = 70 GPa) and have equal…

A:

Q: A rectangular steel block is 75 mm in the x-direction, 50 mm in the y-direction and 100 mm in the z…

A:

Q: AW18 x 40 standard steel shape is used to support the loads shown on the beam. Assume P= 27 kips, w…

A:

Q: A composite beam cross section is made up of two rectangular strips. Each of (100x50) mm placed and…

A:

Q: For a 100 mm size square section under bending, if the maximum compressive stress is 60 MPa, then…

A:

Q: two span beam subjected to shear and flexure only is reinforced as follows: Section @ midspan @…

A: Given, Stirrup diameter =10 mm Concrete compressive strengthfc=21 MPa  Steel rebarfy=415 MPa Steel…

Q: 1.2m 10 cm 7cm -7cm This concrete beam has four A-35 steel rods of one centimeter diameter and a…

A: Stresses in Concrete Beam : A concrete beam is a load bearing unit which is used to carry both…

Q: The cantilevered reinforced concrete beam is made using four reinforcing rods each has a diameter of…

A: Modular Ratio (m) : It is the ratio of modular of Elasticity of steel to that of Concrete. (i.e.…

Q: A concrete beam of length 5.5m is built monolithically with the slab. Originally, the beam has a…

A: Length of the beam = 5.5 mClear span from adjacent beam = 2.15 mWidth of the beam(web), bw = 300…

Q: Question 1 A composite beam cross section is made up of two rectangular strips. Each of (100x50) mm…

A:

Q: Question For a given loading on a rectangular plain concrete beam with an overall depth of 500 mm,…

A: Given- Overall depth of rectangular concrete beam = 500 mm=0.500 m Compressive strain and tensile…

Q: h As' 200 mm As 90mm b A 100 mm 30mm 3. Determine the ultimate moment carrying capacity of the…

A: Given: fc = 30 MPa fy = 420 MPa b = 335 mm h = 435 mm Ast = 5 #28 mm Asc = 1 #22 mm

Pressure and Stress