Situation 2. Refer to FIG DENJIRO. Neglect the thickness of the member. 3. Determine the moment of the force about point O in N-m. a. 18.32 b. 2.41 c. 14.66 d. 11.25

Q: statics

A: 1) Maximum  shear Force will occur at each support = 18 kips Maximum and moment will occur at the…

Q: /hat is the Maximum moment in kN-m. Given: w1 44, w2 17, a 3, b 4 , and c =3. %3D %3D %3D w1 kN/m w2…

A:

Q: What is the vertical reaction at A for the frame shown? 2 k/ft B 100 k •ft 15 ft El = constant E =…

A: Figure is as shown

Q: 4. Find the support reactions at A, B, C, and D. Assume E = 200GPa, and I = 1705 x10^6mm4. 32kN/m…

A:

Q: Prob. 2-3: Two guy wires are fastened to an anchor bolt which is held by the concrete block of…

A:

Q: What is the maximum value of moment at D in KN-m?

A: We will apply the concept that moment at hinge is zero if no external moment is applied.

Q: 4. Replace the forces acting at A and D with an equivalent force-couple system acting at point B.

A:

Q: The assembly shown above is subjected to an applied force F = {1.5i + 6.7j - 2.4k} kip at point D.…

A: Given: The applied force is {1.5i + 6.7j – 2.4k} kip. Consider the figure,

Q: 300N 400N 45° 30 10200N Find F and e if the force syskem above is in a state of Statu equlibrium.

A: Given data in question  Forces Angles Static equilibrium  To find out  Force F Angle

Q: 12-3. A picture is taken of a man performing a pole vault, and the minimum radius of curvature of…

A:

Q: 3. The frame shown in the figure below is supported by a hinge at E and a roller at D. Compute the…

A: Given,  Load at AB at a distance 2m from left= 24kN Find the horizontal and vertical component of…

Q: The spool of wire having a weight of 300 lb rests on the ground at B and against the wall at A.…

A: Draw the free body diagram.

Q: 15 in. 80 Ib 10 in." to 20° 50 Ib 12 in. E 11. Determine force-couple system at A. Draw the free…

A:

Q: For the figure shown, determine the reaction of the hinge force at B as it acts upon member AC. (kN)

A:

Q: What is the fixed end moment FEMAB for the beam with a settlement of 25 mm at support C? 20 kN/m 60…

A: Given data in question  UDL Span member length  Settlement  To find out  Fixed end moment of AB

Q: Determine the horizontal and vertical components of force which the pins at A and B exert on the…

A: The given figure is shown below:

Q: Draw the influence line for the vertical deflection at point B of the beam shown using constant El.…

A:

Q: 8:45 PM +51 969 383 276 Hoy, 7:38 p. m. 9-15. Determine the vertical displacement of joint C of the…

A: Note : provided data is used to find displacement at C. Virtual forces must not have any unit and…

Q: QI Determine the vertical rotation of point B. 35 kN/m B. -3m- 9 m El-constant E E =70 GPa %3D I -…

A: Step 1

Q: 4.30 The horizontal force P is applied to the handle of the puller. Determine the resulting tension…

A:

Q: Part A Force F = 410N acts perpendicular to the inclined plane (Figure 1). Determine the moment…

A: Given:- The magnitude of the force = F = 410 N The force acts perpendicular to the inclined plane To…

Q: Determine the resultant couple moment acting on the beam.

A: From the given figure, we can calculate the moment from both sides (either from right side or from…

Q: Replace the system of forces acting on the frame in Fig. and a couple acting horizontally through B…

A:

Q: SITUATION. The tower for a transmission line is modeled by the truss shown. The crossed members in…

A: Truss is formed by  members connected through smooth pin joint , members take axial load only

Q: The beam has an additional load of 24 kN/m in segment BC. Determine the rotation of the beam at B.

A:

Q: Determine the distance d for placement of the load P for equilibrium of the smooth bar in the…

A: The given figure is shown below:

Q: Prob. 2-3: Two guy wires are fastened to an anchor bolt which is held by the concrete block of…

A:

Q: Determine the force in G a E 400 N 3 m B D 4 m- 1200 N 4 m 8. member GE of the truss. a. 568 N C.…

A:

Q: depth of 600mm and total depth of 650mm. It is reinforced with 4-32mm diameter bars for tension. fc'…

A: Width of the reinforced concrete beam (b): 300 mmEffective depth of the beam (d): 600…

Q: y 100 N/m а A В 75 N/m -8 m- Fig. P3.61

A:

Q: 60 KN 3 m 50 kN/m 10 kN-m A 1 m 5 m

A: Given data:

Q: Determine the x-component of the resultant force 31.) Determine the x-component of F2 32.)…

A: To find component of various forces

Q: A Find the moment at A of the beam shown, El is constant. (kN m) 30 KN 40 KN 50 kN 60 kN/m ↓ 2 m 4 m…

A:

Q: P11.9 Select Roy as the redundant. (Ans: Rcy = 6.3 k) 3.6 klf A *1 = 3000 in.4 20 ft- B DQ I= 1000…

A:

Q: What is the location of the Maximum moment from A in meters. Given: w1 = 46, w2 %3D = 19, a 3, b =…

A: To find location of maximum moment from end A

Q: MAJAOS g B -008- 50° 60° D SS.S bnp (SS awodz 290101 Fig. P2.26 a The hydraulic cylinder BD exerts…

A:

Q: Q3: The of the moments about point C sum A due to the forces and couples acting on the bar is zero.…

A:

Q: Force Pwith 5.05 kN magnitude acts along the paralelepipeds diagonal CE, pointing towarts E 290 mm…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: 1. Find the support reactions at points A, B, and C. Assume that the second moment of area of…

A:

Q: Refer to Fig. STA-002. Determine the moment in (kN-m) at D. W = 8 kN/m P =40KN 2.5m 0.3m Fig.…

A:

Q: Choose Joint B and determine the Force in member BC and BA.

A: Given Force at B = 500N Triangle is Right angle isosceles triangle with Equal sides as 2m

Q: Q2. Find the magnitude of the moment about BC.

A:

Graphical Methods

The graphical method is a method of solving equations involving more than one variable using the Cartesian coordinate system. In civil engineering, the use of the graphical method is limited to the problems involving two variables. The graphical method has a great impact in solving the questions regarding engineering mechanics.