Situation 1] Five measurements were made to determine the length of a line and recorded as follows: 350.33 m, 350.22 m, 350.30 m, 350.27 m, and 350.30 m. If these measurements were given weights of 4, 5, 1,4, and 6, respectively, the most probable value of the length measured is?

Q: The sides of a closed figur

A: Accuracy ratio is the ratio of the error of the measurement to the distance measured. Accuracy…

Q: If a rock falls from a height of 35 meters on Earth, the height H (in meters) after x seconds is…

A:

Q: The error in measuring the radius of a 5 cm circular rod was 0.2%. If the cross- sectional area of…

A: A ) Given data : Radius of circular road = 5 cm Error = 0.2 % To Find ;The resulting absolute…

Q: What can you s

A: introduction: The degree of closeness to the true value is called accuracy. The degree of…

Q: A 3 kg box is displaced at a rate of 5 m/s. How much force is required to stop the box in 644.828…

A: It is required to find the force to stop the box weighing 3 kg moving at 5 m/s in 644.828 micro…

Q: The length of a line was measured repeatedly on three different occasions and probable error of each…

A: 1st set of measurements = 1201.50±0.02m2nd set of measurements= 1201.45±0.04m3rd set of measurements…

Q: Five measurements were made to determine the length of a line and recorded as follows: 350.33,…

A:

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- Error in measuring radius= 0.2% radius=R=5 cm area=A % error in area needs to be find out.

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- radius=R=5 cm area=A % error in area needs to be find out.

Q: 13.8 kips 23.6 kips 24.2 kips 43.5 kips 30 ft Submit B Request Answer 8 k 5 ft. 15 ft 10 14k 15ft 5k…

A: Determine the tension in cable-AB.

Q: The error in measuring the radius of a 5cm circular rod was 0.2%. If the cross-sectional area of the…

A: given- radius=R=5 cm area=A % error in area needs to be find out.

Q: Find: 1. The magnitude of the 150N load is, 2. The direction of the 150N load is LB. a. NOTE: i. Use…

A: Consider the figure,

Errors in surveying

An error in surveying is defined as the difference between two or more values of an identical quantity. However, the estimates are never accurate and there will always be a degree of variability regardless of the research tool or method used. These differences are known as errors that need to be reduced or eliminated to maintain certain levels of accuracy. Even if you carefully follow the prescribed test procedures, the considerations may contain errors.