Situation 1: A 50 N block rests on a surface that is inclined by e degrees. If p. = 0.35 and uk = 0.15, determine the following: A. The maximum e where the motion impends (degrees) B. If e = 15°, what is the frictional force between the block and the incline? (N) C. If e = 25°, what is the frictional force between the block and the incline? (N)

Situation 1: A 50 N block rests on a surface that is inclined by e degrees. If p. = 0.35 and uk = 0.15, determine the following: A. The maximum e where the motion impends (degrees) B. If e = 15°, what is the frictional force between the block and the incline? (N) C. If e = 25°, what is the frictional force between the block and the incline? (N)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

I need the answer as soon as possible
2. Three blocks are connected by a weightless cord and rest on an inclined plane (Fig. 2(a)). The following set of simultaneous equations is derived from the free- body diagrams shown in Fig. 2(b): 100a +T + (0)R = 519.72 50a -T +R=216.55 25a + (0)T – R =108.27 Without interchanging the rows and columns, solve for the acceleration a and the tensions T and R, in the two ropes by using Gauss-Seidel iteration method. Stop all calculations after three iterations. 25 kg 50 kg 100 kg 45 1346 48 × 0,375 - 129.93 346.48 173 24 x 0.375 - 64.97 173,24 346,48 692.96 100 x 9.8 = 980 50 9,8 490 25 x 98- 245 a, acceleration 96769 T692.96 x 0.25 = 173.24 173.24
While digging a small hole prior to planting a tree, a homeowner encounters rocks. If he exerts a horizontal 242-N force on the prybar as shown, what is the horizontal force exerted on rock C? Note that a small ledge on rock C supports a vertical force reaction there. Neglect friction at B. Complete solutions (a) including and (b) excluding the weight of the 17-kg prybar. 242 N A, 1750 mm 15 B 220 mm Answers: (a) Including weight, Fc = i N (a) Excluding weight, Fc = i N
What is the single force R that will produce the same external effect on the bar ABCD as the two forces P and Q? At what point on the bar must this force be applied? Use the Principles discussed in Lesson 1 to solve. 1P = 160 lb 45 2 ft A 300 Q=80 lb 2 ft
1. Solve for the force P that would cause motion if the top and bottom block remain stationary and the middle block slips.2. Solve for the range of force force P that would cause motion if the top block remain stationary and the middle and bottom block slips together. 3. Solve for max force P to cause no blocks to move (remain at rest). N1,N2,F1,AND F2 VALUES ARE GIVEN BELOW
Subject:Statics of Rigid BodiesPlease display your solution, and please make it nice and readable.
Q.3) The coefficient of friction between the 120 lb block (shown in figure below) and the incline plane is 0.3 and that between the cord and cylindrical support is 0.4. Determine the range of cylinder weight W for which the system shown below will be in equilibrium. μ = 0.3 120 lb 24° <μ = 0.4 5 W
b = 2.05 m Submit Previous Answers With its engine removed, the mass of the car shown in ( Figure 1) is 1400 kg and its center of mass is at C. The mass of the engine is 300 kg. ✓ Correct Figure T 0.45 m > 1 of 1 Part B Review If the car is parked on a 15° slope facing up the slope, what total normal force is exerted by the road on the rear wheels B? Express your answer using three significant figures and include the appropriate units. ? UA 0.6 m A-1.14 m- B B = Value Units b. -2.60 m- ་ Submit Previous Answers Request Answer × Incorrect; Try Again
A puck weighs 9 lb and rests on the center of the frictionless surface of the ramp supported in equilibrium by ropes AC and BC. Determine the normal force the ramp exerts on the puck as well as the tension in each of the two ropes. X g a b A Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value 44.0 in 48.4 in 24.2 in 50.8 in 50.6 in 12.1 in 71.3 in C d Z e f 9 B