Sir Lancelot rides slowly out of the castle at Camelot and onto the 12.0-m-long drawbridge that passes over the moat (Figure 1). Unbeknownst to him, his enemies have partially severed the vertical cable holding up the front end of the bridge so that it will break under a tension of 5.80 x 10 N. The bridge has mass 200 kg and its center of gravity is at its center. Lancelot, his lance, his armor, and his horse together have a combined mass of 600 kg.

Sir Lancelot rides slowly out of the castle at Camelot and onto the 12.0-m-long drawbridge that passes over the moat (Figure 1). Unbeknownst to him, his enemies have partially severed the vertical cable holding up the front end of the bridge so that it will break under a tension of 5.80 x 10 N. The bridge has mass 200 kg and its center of gravity is at its center. Lancelot, his lance, his armor, and his horse together have a combined mass of 600 kg.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

If the allowable bending stress is 0 = 218 MPa, find the magnitude of the maximum internal bending moment M₂ that can be supported by the beam. The moment of inertia about the z axis is 402,238,667 mm4. 16 mm 240 mm V O 698 kN-m O 501 kN-m O 579 kN-m O 651 kN-m O 461 kN-m 30 mm 350 mm
When you bend over, a series of large muscles, the erector spinae, pull on your spine to hold you up. Figure shows a simplified model of the spine as a rod of length L that pivots at its lower end. In this model, the center of gravity of the 320 N weight of the upper torso is at the center of the spine. The 160 N weight of the head and arms acts at the top of the spine. The erector spinae muscles are modeled as a single muscle that acts at an 12° angle to the spine. Suppose the person shown bends over to an angle of 30° from the horizontal. a. What is the tension in the erector muscle? Hint: Align your x-axis with the axis of the spine.b. A force from the pelvic girdle acts on the base of the spine. What is the component of this force in the direction of the spine? (This large force is the cause of many back injuries).
Two people carry a heavy electric motor by placing it on a light board 2.10 mm long. One person lifts at one end with a force of 450 NN, and the other lifts the opposite end with a force of 570 NN. What is the weight of the motor? Express your answer in newtons. Where along the board is its center of gravity located? Express your answer in meters. Suppose the board is not light but weighs 190 NN, with its center of gravity at its center, and the two people each exert the same forces as before. What is the weight of the motor in this case? Express your answer in newtons. Where is its center of gravity located? Express your answer in meters.
To get up on the roof, a person (mass 82.0 kg) places a 6.60 m aluminum ladder (mass 11.0 kg) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder rests against a plastic rain gutter, which we can assume to be frictionless. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. What are the magnitudes (in N) of the forces on the ladder at the top and bottom? top N bottom N
The experiment you did in lab is repeated, using a uniform metal bar that is 80.0 cm long instead of the meterstick. Since the bar is uniform, its center of gravity is at its center. The new experiment uses different hooks for hanging the masses from the bar, with mhook 5.0 g. As in the experiment you did in lab, X1 = 5.00 cm, m1 300.0 g, and Xp = 25.0 cm. In the 1 new experiment, you make the same measurements as in your lab and plot x versus The line that is the best fit to your data has slope 3800 cm · g. What is the mass of m2 + mhook the bar?
In the figure, a lead brick rests horizontally on cylinders A and B. The areas of the top faces of the cylinders are related by AA= 2.8 Ag; the Young's moduli of the cylinders are related by EA= 1.5 Eg. The cylinders had identical lengths before the brick was placed on them. What fraction of the brick's mass is supported (a) by cylinder A and (b) by cylinder B? The horizontal distances between the center of mass of the brick and the centerlines of the cylinders are dafor cylinder A and dg for cylinder B. (c) What is the ratio da/dg? com of brick (a) Number i Units (b) Number i Units (c) Number i Units
0.20 L 0.40 L 3. The foot of a ladder rests against a wall and its top is held by a tie rope, as shown in the figure. The ladder weighs 100 N, & its center of gravity is 0.40 of its length from the foot. A 150 N child hangs from the rung that is 0.20 of the length from the top. Determine the tension in the tie rope and the components of the force on the foot of the ladder. Tie rope IS0 N 37 100 N
A solid sphere, made of acrylic plastic with a density of 1.1 g/cm3,1.1 g/cm3, has a radius of 5.0 cm.5.0 cm. A very small "eyelet" is screwed into the surface of the sphere and a horizontal support rod is passed through the eyelet, allowing the sphere to pivot around this fixed axis, as shown in the figure. If the sphere is displaced slightly from equilibrium on the surface of Earth, determine the period ?T of its harmonic motion when it is released.
The meterstick shown is 100 cm long. It is free to pivot around its center of gravity (CG), which is at the 50 cm mark. 10 20 30 40 50 60 70 80 90 There is a 25.0 N block hanging from the 80 cm mark. Decide where each of the other blocks should be placed, one at a time, to balance out the 25.0 N block. 3 2 1 At what mark on the meter stick would you place a 19.0 N block to balance the 25.0 N block? mark: cm At what mark on the meter stick would you place a 44.0 N block to balance the 25.0 N block? mark: ст
The meterstick shown is 100 cm long. It is free to pivot around its center of gravity (CG), which is at the 50 cm 10 20 30 40 50 60 70 80 90 mark. There is a 20.0 N block hanging from the 80 cm mark. Decide where each of the other blocks should be placed, one at a time, to balance out the 20.0 N block. 3 2 1 At what mark on the meter stick would you place a 19.0 N block to balance the 20.0 N block? mark: cm At what mark on the meter stick would you place a 42.0 N block to balance the 20.0 N block? mark: cm about us careers privacy policy terms of use contact us help -8
A circular plate with radius r = 0.785 m lies next to a rectangular plate with base br = 0.948 m and height hr = 0.770 m which lies next to a triangular, plate with base bt = 1.41 m and height ht = 0.712 m. Determine the center of gravity of the rectangular plate in the y-direction if its surface density varies in the x and y-direction according to σr = 4.84 · x · y kg / m2.
A 1.90-m-long barbell has a 24.0 kg weight on its left end and a 32.0 kg weight on its right end. Where is the center of gravity if the 9.00 kg mass of the barbell itself is taken into account?