Side view Front view .005 A ALL ANGLES ± 1° On the part above, specify a geometric control to make the left surface in the front view perpendicular to the bottom surface within .005 total. 12. Can a datum or feature modifier be applied to this feature control frame? Why or why not? Feature modiher Cannot be applied here because feature modifiers are applied to feature of size & not the feature. 13. What is the flatness on the left surface of the part above? On the part above, there is no perpendicularity requirement specified between the right surface and bottom surface. What perpendicularity is implied? parallel lines

Q: 2.

A:

Q: Give all the location dimensions between the datum target points, B1 ,C1 and B2, C1. B1, C1 : X =…

A: Since, the bottom part of the drawing represents dimensions in X and Y direction while the upper…

Q: For the objects shown in isometric below, sketch the top, front, and right side views in the space…

A: Given: Draw front, top view and right side view of the given isometric view.

Q: Given the left and front views, sketch the top view.

A: The problem is easily done with the help of orthogonal projection. first try to imagine the 3D view…

Q: Calculate the minimum and maximum values for the indicated dimensions attached. All minimum and…

A: Given: All the dimensions are shown below:

Q: Problem 1 For the 3d object shown to the right, complete the following: a) Determine the position…

A:

Q: 1. Sketch the CAVALIER OBLIQUE of the given object. Use corner "A" for orientation.

A: according to the details provided in the question, we need to draw a cavalier view of the given…

Q: The three planes of 'orthographic' projection of an object are presented in Figure 1.1 below. Draw…

A: Draw the isometric block according to dimensions of the object as shown in the image:

Q: 3. On the drawing and produced part below, label the following terms: Datum feature symbol Datum…

A: Label the given terms.

Q: Given the Top and Front Orthographic views of an object, construct a One-point Perspective view in…

A:

Q: 9. A Coordinate frame, {A} is located at the base of a robot manipulator. Frame {B} describes the…

A: There are two operations done here.First operation is translation/displacment.Second operation is…

Q: DIMENSION THE OBJECT SHOWN BELOW. NOTE THAT NOT ALL ORTHOGRAPHIC VIEWS WILL REQUIRE DIMEN- SIONS. DO…

A:

Q: The plan of a point T is 35 mm above XY line and its front view is 40 mm below the XY line. Draw its…

A: Given:The distance of the plan (top view) is and it is above the XY line.The distance of the…

Q: Ae bes elole 15.3 15.1 Ø0.3|A-B 6.40 6.35 9.55 9.50

A: (1) coaxially tolerance.on left diameter = ∅ 6.5-0.05+0.00on right diameter = ∅9.5-0.00+0.05 maximum…

Q: On the part shown, specify a geometric control to make the left surface in the front view…

A:

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.