SHOW UNIT CANELLATION AS WELL AS STEP BY STEP SOLUTION. ANSWERS MUST BE IN 4 DECIMAL PLACES INCLUDING YOUR FINAL ANSWER. A 10 m diameter cylindrical tank has a height of 5 m and is full of water at 20°C. (Unit weight= 9,879 kN/m³) If the water is heated to a temperature of 50°C (Unit weight= 9.689 KN/m³), solve for. a. The weight of the water at its initial temperature in kgr b. The volume of the water when heated to its final temperature in cm³ c. The volume of water that will spill over the edge of the tank in cm³.

Q: 2. Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

A:

Q: 6. A differential manometer is attached to a pipe, as shown in figure below. Calculate the pressure…

A:

Q: A converging nozzle having an exit diameter of 30 mm is connected to the large tank (Figure 1). The…

A: Temperature of air in the tank, Pressure inside the tank,

Q: Determine the stretch of each spring for equilibrium of the 17-kg cylinder in (Figure 1). Figure…

A: Solution: Spring AD: ∑Fy=0 FAD=166.77 N

Q: Meriam red oil, SG=0.827 P2.32 Water A 18 cm H 35 cm B Mercury

A: Given data:- The PB-PA=89.5 kPa=89500 Pa The specific weight of water is, Wwater=9790 N/m3 The…

Q: An elastoplastic material with strain hardening has the stress–strain relationship shown in Figure .…

A: Given data:

Q: Find the water height hg in tank B shown in the figure below for steady-state conditions. Suppose…

A:

Q: In the figure below, a pool of liquid sodium is sitting in open atmosphere (and somehow not…

A: 22

Q: The pump shown creates a water jet oriented to travel a maximum horizontal distance. System friction…

A:

Q: Water flows steadily from a nozzle into a large tank as shown in the figure below. The water then…

A:

Q: p is the density in grams per cubic centimeter .cm3 V is the volume of the space the gas occupies in…

A: Given, theoretical equation as C=C0e0.5rtρV From the graph, we know that C=52e0.2t Equating both the…

Q: H.W: An open tube is attached to a tank, as shown in the figure. If the water rises to a height of…

A: Given:- Height of water= 800 mm

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

A:

Q: Question 1 You are presented with a bucket of water (y = 72 dynes/cm, T= 25C) that has a thin…

A: ASKED: To determine the rise of water in the thin cylindrical tube.   Given, Surface tension γ = 72…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.