shear stress of 100 MPa in the bronze segment,

Q: the 12 kn m torque is applied to the free end of the 6-m steel shaft. the angle of rotation of the…

A: The torque is the rotation force which makes the object rotate about the axis  Formula to calculate…

Q: 5- The solid rod is subjected to the loading suown. Determine the state of stress at point A, and…

A: Given : Determine the state of stress at point A and show the results on a differential volume…

Q: The compound shaft consists of bronze and steel segments, both having 120-mm diameters. If the…

A:

Q: PROBLEMS 237. The lower ends of the three bars in the figure are at the same level before the rigid…

A:

Q: The rigid bar AB, attached to two vertical rods as shown in Fig. is horizontal before the load P is…

A:

Q: The copper pipe has an outer diameter of 40 mm and an inner diameter of 37 mm. If it is tightly…

A:

Q: The rigid bar AB of negligible weight is supported by a pin at O. When the two steel rods are…

A: Given data,  E for steel = 200 Gpa Cross section area of AC = 300 mm² Cross section area of BD = 250…

Q: Situation 2| The compound shaft as shown is attached to rigid supports. It is subjected to a…

A:

Q: A cylindrical pressure vessel of 2.5m inside diameter, which is closed at both ends, having 12 mm…

A: Given that , d = 2.5 mm, t = 12 mm, P = 1.5 MPa, Angle = 30⁰ Required to calculate stress acting…

Q: The rigid bar AB is hinged at A and supported by a steel plate hanger. The hanger is fixed at C and…

A:

Q: A steel pipe is subjected to the 16-kN load shown below. Its outside diameter is 140 mm and its…

A: A steel pipe is subjected to the 16-kN load shown below.Outer diameter = 140 mmThickness = 7 mmYield…

Q: Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Knowing that dị…

A:

Q: The frame supports the distributed load shown. Determine the state of stress acting at point E. Show…

A: Draw the free body diagram.

Q: . The beam weighs 3600N. Draw the V and M diagram. b. Assume we do not now the weight of the beam…

A: 1-If Beam weighs 3600 N then drawing of SFD and BMD 2- if Beam Weighs is not know then finding of…

Q: The steel rod fits loosely inside the aluminum sleeve. Both components are attached to a rigid wall…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.