For each set of ac phasors, find the indicated resultant.10. RC series circuit: VR 8 20° V, Vc 5 Z-90° V; resultant VT

Given- For series RC circuit- VR= 8∠0° Volts VC= 5∠-90° Volts To find- Resultant, VT=?

Answered: set of ac phasors, find the indicated…

Engineering

Electrical Engineering

set of ac phasors, find the indicated resultant.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: A sinusoidal voltage trace displayed by an oscilloscope is shown, if the 'time/div' or Hs, switch is…

Q: d.Explain what a phasor is and sketch it in the position-dependent case.

Q: A three-phase, three-wire CBA system, with an effective line voltage 106.1 V, has a balanced…

Q: Given a capacitive load absorbing 5 kW with a power factor of 0.85. The source connected to this…

A: Given the real power P and the power factor pf, we can find the apparent power S using the formula:…

Q: A circuit consisting of a resistor in series with a capacitor takes 100 watts at a power factor of…

A: Resistance: It is a property of a material that resists the flow of the current and its unit is the…

Q: Ac - 100 Vrms R1 - 1k R2 - 500 Rload - 1k Capacitor - 2uF Q1. How much is the capacitor voltage…

A: To determine the phase lag between the capacitor voltage and the AC source voltage, we need to…

Q: . What effect does changing the frequency on the effective value of sinusoidal voltage? 2. What…

A: Consider a sinusoidal voltage voltage shown below, Here v=Vmsinωt The peak voltage is Vm and ωt=α…

Q: A chopper circuit has an inductive load of 2ohm resistance and 10mH inductance. If the source…

A: According to question:

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and…

A: time division - time/cm=0.2ms/cm voltage division volt/cm=1V/cm

Q: Consider the situation shown in (Figure 1). A 1000-V-rms source delivers power to a load. The load…

Q: An electromagnet that is modeled as a resistor R=20 ohms and L=0.3 henrys in series, is connected to…

A: Electromagnet modeled as series connection of resistance and inductance whose values are 20 ohms and…

Q: A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the…

Q: You have an AC source, which is connected through series connection of an inductor and a resistor to…

A: When AC source is connected to the R-L series circuit is shown below: - IR and IL will be the…

Q: Compute the capacitance of (i) parallel plates with plate width w- 2.0 (m), length 1 unit and…

A: Width of plate w = 2 m. Length is given L =1 m. Separation between plates d = 4.6 m. Relative…

Q: Reduce to its simplest form using msop

A: The max terms for the given function are: 0 (A’B’C’D’) 1 (A’B’C’D) 2 (A’B’CD’) 3 (A’B’CD) 9…

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: The capacitive reactance (XC) . be affected by the harmonics of non- * .sinusoidal wave will…

A: From the reactance offered by capacitor.

Q: .. Add 3coswt and -4sinwt

Q: Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the…

Q: What impedance vector (0- j15) Ohms represents: A. A pure resistance. C. A pure capacitance.…

A: Since real part is 0, so it can't be resistor. So option A is wrong.

Q: An inductive coil of resistance 15 ohms and inductance 0.2 is commented in parallel with a 100…

A: In this question, we need to determine the frequency when current is in phase with voltage. Also…

Q: An electrical circuit with a sinusoidal voltage source, a resistor, and a capacitor all connected in…

A: When the same current flows through all the elements, they are said to be in series. When the same…

Q: What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a 480 nF…

A: This is the series RLC circuit and concept of resonance Use fundamental formulas

Q: Phasor A: magnitude 10, angle 45° Phasor B: magnitude 10, angle -45° A

A: Given, Two magnitudes with angles , We have to draw the phasors. Please find the below attachment…

Q: Lift force is the basic driving force in a multi blade vertical axis wind turbine. Select one: O…

A: The ease of the arrangement and improvement of vertical turn contraptions allowed to join a power…

Q: A voltage y(t) = 10 cos(2000xt) is applied to a 100-mH inductance. Find the complex impedance of the…

Q: a) The voltage across a 20µF capacitance is ve = 50 sin( at - 80) volts and Frequency equal to 100…

Q: See images attached. Help with finding sinusoid equations for graph

Q: What impedance vector - j25 represents: A. A pure resistance. C. A pure capacitance. B. A…

Q: 1. a) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a…

A: given data:

Q: A sinusoidal current of 5 Arms is flowing through a series combination of a resistor and Inductor.…

A: In this answer let us try to find the voltage across the combination of the series R-L Circuit as…

Q: A capacitor "C", an inductor "L" and a switch "S" are connected in series. When the switch is open,…

A: When a capacitor "C," an inductor "L," and a switch "S" are connected in series, an electrical…

Q: a) Using your own words, describe how triangular waveforms are produced from sinusoidal waveforms.…

A: (a)The triangular waveform from the sinusoidal waveform cannot be easily generated directly. Hence…

Q: A 60 Hz voltage of 230v effective value is impressed on an inductive of 0.265H. a.) Write the time…

A: The solution can be achieved as follows.

Q: Discuss phasor Diagrams and Phasor Algebra.

A: Phasor diagram and Phasor algebra are used to represent the phase relationship between the…

Question

For each set of ac phasors, find the indicated resultant.
10. RC series circuit: VR 8 20° V, Vc 5 Z-90° V; resultant VT

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
Using a line phasor (circle), draw the two given phasors. Use the sine function as the base function.
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Previous solution was incorrect...
....please solve this urgent for me..
A series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100 sin200t. Determine the following: a). The overall power factor ( indicate big leading or lagging) b). The voltage drop across the resistor and the capacitor
6 to 8
Ac - 100 VrmsR1 - 1kR2 - 500Rload - 1kCapacitor - 2uF Q1. How much is the capacitor voltage lagging from the AC source
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.
If the phasor current is 45 degrees ahead of the phasor voltage, write down all the possibilities about circuit impedance.
Plz solve it early.......
find The average power delivered to * .the circuit