Select a wrong statement. 1) Piping around air coolers with multi-bundles, shall be arranged to ensure even flow distribution. 2) For safety reasons, no flanges in hydrocarbon lines shall be located under the air fin coolers. 3) Tower piping shall be routed with adequate flexibility to accommodate tower and line growth for the identified design conditions. 4) Platforms of towers shall be arranged so that the vertical distance between upper and lower platforms does not exceed (6 m).

Select a wrong statement. 1) Piping around air coolers with multi-bundles, shall be arranged to ensure even flow distribution. 2) For safety reasons, no flanges in hydrocarbon lines shall be located under the air fin coolers. 3) Tower piping shall be routed with adequate flexibility to accommodate tower and line growth for the identified design conditions. 4) Platforms of towers shall be arranged so that the vertical distance between upper and lower platforms does not exceed (6 m).

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Explore the concept of hazard detection units and their role in pipeline control.
118 ABOUT INDUSTRIAL PIPING IN WHAT SITUATION IS IT NECESSARY TO PERFORM FLEXIBILITY CALCULATION IN PIPING SYSTEMS
Question 3 10 points V Sav The basic principle to select a material for a product is to use a material with properties that meet or exceed the product performance requirements, and keep the cost of the product as low as possible to use a material with properties that meet the product performance requirements, and keep the cost of the product as low as possible to use a material with properties that exceed the product performance requirements as much as possible, and keep the cost of the product as low as possible to use a material with properties that meet or exceed the product performance requirements, and keep the cost of the material as low as possible
What is the function of the empty pipes that connect from the sanitary/drainage pipes up through the roof of a building?
An oil/gas separator is a pressure vessel used for separating a well stream into gaseous and liquid components. They are installed either in an onshore processing station or on an offshore platform. Based on the vessel configurations, the oil/gas separators can be divided into horizontal, vertical, or spherical separators. In a vertical tank, the heavy liquids are pumped out of the ____________ of the vessel and the light phase is drawn off the side of the tank. a. Inlet b. corner c. Bottom d. Top
Stratified flow pattern can be observed in horizontal or slightly inclined pipelines. It is characterized by the structure of the interface which may be ________ according to the gas flow rate a. Up and down b. Smooth c. Harsh d. Uneven
For the process shown in the schematic below, which of the statements is/are incorrect? Feed hopper Feed hopper Plastic pellets Mold cavity Mold Nozzle Spreader Heating chamber Ram Hydraulic pressure Turning screw Barrel Heaters Shaping die Molten plastic Extrudate Select one or more: a. The process can only work with thermoplastics and not with thermosets due to the thermal processing requirements Tubing and pipes Sheet and film Structural parts b. The feedstock has to be molten or liquid monomer, the temperature of which will constantly be held above the melting temperature c. This process is best suited for the large volume production of tubes, bars and beams due to the nature of the extrusion process d. To release the part, the process typically involves the mould sections opening and the ejector pins pushing the object out of the mould De. The mould cavity region is usually temperature controlled so that at the point of injection it is heated and then gradually cooled down until…
020 ABOUT INDUSTRIAL PIPING WHAT ARE THE POSSIBLE TRANSIENT OPERATING CONDITIONS FOR PIPING SYSTEMS?
Plz solve this question completely (handwritten solution acceptable)
Give four design features of flue gas analysis stack??
Question 13.17 (please do problem 13.17 as13.18 is posted as a seperate question.)