Seawater is about 3.5% by weight dissolved solids,almost all of which is sodium chloride. Calculate the normal boiling point of seawater? A. 110.5°C B.105.6°C C.100.64°C D.102.15°C E.101.12°C F.100.35°C   (not graded)

Q: 49.037 J°c What would be the system temperature?

A: P= 500 mmHg Gas temperature =72 °C mole fraction H,O =0.3 mole fraction of N= 0.7 conditions at dew…

Q: 1. Calculate: 1. (273.15 K) / (0 oC) =, 2. (1365.75 K) * (__ oC) = 0 oC 3. (498 K) / ( oC) = (-47.5…

A:

Q: a. Draw and label a ternary phase diagram consistent with the above data. b. Draw and label a…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: O2 (A) is diffusing through Carbon Monoxide (B) under steady-state conditions, with carbon monoxide…

A: Given thatPT =105  Nm2PA1 =13 x 103  Nm2PA2 =6500  Nm2T =0 C =273.15 kDAB  =1.85 x 10-5  m2sz =0.002…

Q: EXAMPLE 4.21 Energy Balance Ten pounds of water at 35°F, 4.00 lb of ice at 32°F, and 6.00 lb of…

A: water- m=10 lb T1=35 F U1^=3.02 Btu/lb V^1=0.0162 ft3/lb ice- m=4 lb T2=32 F…

Q: What is the composition of the vapour in equilibrium with the liquid of composition (a) xA = 0.50…

A:

Q: The following table shows the boiling pressure of pure acetone at different temperatures: T (°C) Pat…

A: Temperature and vapor pressure of pure acetone is given.

Q: A liquid mixture consists of 40% n-pentane and 60% n-hexane by mole. It is placed in a closed…

A: A mixture of n-pentane and n-hexane is heated in a closed at given T and P.

Q: 2. Find the humidity and percentage humidity of the mixture when wet and dry bulb temperatures are:…

A: a) Tw = 50^c and Td = 120^c b) Tw = 20^c and Td = 60^c to find = humidity and % humidity

Q: P9.20 The partial molar volumes of water and ethanol in a solution with xH,0 57.0 cm³ mol1,…

A: The partial molar property is a thermodynamic property that describes the variation of an extensive…

Q: 1.11 Ethane at 10 MPa and 100°C is heated at constant pressure until its volume has increased by…

A: (a) Write the relation between temperature and volume at constant pressure process as follows: T1V1…

Q: 16. Calculate the internal energy of combustion per unit mass for gaseous propane, C3H8, at 25°C…

A: (16) Write the reaction for the combustion of propane as follows: C3H8g + 5O2g → 3CO2g +4H2Ol One…

Q: Prepare a table of temperature/composition data for the benzene(1)/water(2) system at a pressure of…

A:

Q: |what is the relative saturation of water vapor in air at 25 °C, i

A: Relative saturation typically refers to the extent to which a substance or medium is saturated with…

Q: At 60°C, the vapor pressure of ethanol is 352.7 mmHg and that of methanol is 625 mmHg. Ethanol and…

A: Given Ethanol vapor pressure = 352.7 mm of hg Methanol vapor pressure = 625mm of hg Ethanol moles =…

Q: What amount of energy must be removed to cool 3.00 moles of liquid ethanol at 35°C to -55°C?

A: moles of ethanol n = 3 T1 = 35 oC = 308 K T2 = -55 oC = 218 K

Q: 11.7-2. Boiling Point, Dew Point, and Flash Vaporization. Following is the composition of a liquid…

A: The boiling point is where the vapor composition pressure is equal to the surrounding pressure of…

Q: 2. A mixture of benzene and ethylene chloride obeys Raoult's law accurately. At 50°C, their vapor…

A: Raoult's law is applied to this system. The component number decides the number of independent…

Q: ) A 3.0 L flask containing 2.0 mol O2 and 1.0 mol N2 is in a room that is at 22.0° What is the total…

A: The volume of the flask = 3 L Moles of O2 in the flask = 2 mol Moles of N2 in the flask = 1 mol The…

Q: Sulfur dioxide, argon, and helium gases are added to a 2.00 L flask in equal amounts. The…

A: Given that, The volume of the flask = 2 L Temperature = 27.0oC Sulfur dioxide, argon, and helium…

Q: 4-83 Determine the specific volume of superheated water vapor at 15 MPa and 350°C using (a) the…

A:

Q: Consider the equilibrium system described by the chemical reaction below. At equilibrium, a sample…

A: Given reaction is- 4NO2(g)⇔2N2O(g) +3O2(g) At equilibrium conditions- Sample volume in the flask is,…

Q: 5. A tank contains a liquid composed of 60 mol% toluene and 40 mol% benzene in equilibrium with the…

A: Given: x1 = 0.6, x2 = 0.4, P = 1 atm, T = 80 0F To calculate the composition of the gaseous phase…

Reactive Processes

Reactive processes are the processes in which any reaction occurs. The reactions can be any combination reaction, decomposition reaction, combustion reaction, oxidation reaction, reduction reaction, neutralization reaction, displacement reaction, or double displacement reaction.