Scott test is one of the methods used for screening for Cocaine in Forensic Chemistry. The multi step method consists of a) reacting the sample drug with cobaltous thiocyanate (Co(SCN)2) b) dissolving of the formed precipitate by adding HCl and c) extraction of coordination compound with Chloroform d) measurement of absorbance of extracted coordination compound at 627 nm What is the type of chemical equilibria involved in first step of the method? a.Solubility Product equilibria b.Bronsted Lowry acid – Bronsted Lowry base equilibria c.Complex ion formation d.Coordination compound formation

Scott test is one of the methods used for screening for Cocaine in Forensic Chemistry. The multi step method consists of a) reacting the sample drug with cobaltous thiocyanate (Co(SCN)2) b) dissolving of the formed precipitate by adding HCl and c) extraction of coordination compound with Chloroform d) measurement of absorbance of extracted coordination compound at 627 nm What is the type of chemical equilibria involved in first step of the method? a.Solubility Product equilibria b.Bronsted Lowry acid – Bronsted Lowry base equilibria c.Complex ion formation d.Coordination compound formation

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter10: Reconstitution Of Powdered Drugs

Section: Chapter Questions

Problem 4.6P

See similar textbooks

Similar questions

Explain the mechanism of denaturation for the following agent: 1. Hydrochloric acid 2. Lead (II) acetate solution 3. Picric acid 4. Nitric acid 5. Ethanol
Your patient requires pre-operative, local anesthetic and has been prescribed 0.16 g of chloroprocaine im STAT. Use the chloroprocaine hydrochloride label to answer the following questions. Show all calculations. a) What volume of chloroprocaine HCl will you administer at each dose? (4 marks) b) Validate your answer. (2 marks) c) Which company manufactures this drug? (1 mark) d) What is the prescribed route of administration? (1 mark)
A volumetric flask made of Pyrex glass is calibrated at 20 °C.It is filled to the 100 mL mark with 35 °C acetone. After the flask is filled the acetone cools and the flask warms so that the combination of acetone and flask reaches a uniform temperature of 32 °C. The combination is then cooled to 20 °C. a) What is the volume of the acetone when it is at 20 °C? b)At the temperature of 32 °C, does the level of acetone lie above or below the 100 mL mark?
Determine the weight/volume of the chemicals needed to prepare the following solutions: a) 100 ml of 0.9% (w/v) saline (NaCl) b) 30 ml of 50% glycerol (v/v)   c) Electrophoresis requires TAE, which is a specific mixture of Tris base, acetic acid, and EDTA. TAE is normally made as a 50X concentrated stock. Provide a recipe to make 40 ml of 50X TAE. The recipe for one liter of 50X TAE is as follows: 242g Tris base, 57.1 ml glacial acetic acid, 100 ml 0.5 M EDTA
Consider a HCI solution with a pH of 4.70. a) Calculate the concentration of HCl. b) Identify the two underlying assumptions in part a). c) The original solution is diluted by 1,000 fold. Calculate the pH of the resulting solution. Make sure to indicate if the forementioned assumptions are still valid.
Please don't provide handwriting solution
Arrange the following in order of increasing Rf on thin-layer chromatography: acetic acid, acetaldehyde, 2-octanone, decane, and 1-butanol.
The compounds 1-hexanol, 3-methyl-3-pentanol, hexanal, and 2-hexanone, and were used using different tests. Shown below is the schematic diagram of the tests performed on the compounds. Determine the identities of each compound based on the tests performed. a.) Compound A b.) Compound B c.) Compound C d.) Compound D Choices: I. 1-hexanol II. hexanal III. 2-hexanone IV. 3-methyl-3-pentano
A 1.000-g sample containing bromide was dissolved in sufficient water to give 100.0 mL. A 50.00 mL aliquot was measured and after acidification, silver nitrate was introduced to precipitate AgBr, which was filtered, washed, and then dissolved in an ammoniacal solution of potassium tetracyanonickelate(II): Ni(CN)42- + 2AgBr(s) → 2Ag(CN)2- + Ni2+ + 2Br- The liberated nickel ion required 11.70 mL of 0.002146 M EDTA. The other 50.00 mL remaining solution was also analyzed for its Br- content by potentiometry using a metallic electrode of the second kind. e) Write the cell notation of the potentiometric set-up with SCE as the reference electrode. f) Write the Nernst equation that describes the indicator electrode set-up.
If a powder in a 2gm vial diluted with 6.8ml of diluent provides 8ml of solution and each ml contains 250mg of a drug, how many ml is needed to give 750mg.
Is sodium propanoate (the sodium salt of propanoic acid) as effective a soap as sodium stearate (the sodium salt of stearic acid)? Explain.
An amino acid mixture of phenylalanine, glycine and glutamic acid is to be separated by paper chromatography.The solvent is less polar than water. Which of these amino acids will have the highest Rf value and which the lowest? Explain.