Scenario 2: You work as a technical engineer in a company that designs and installs 4G and LTE [wireless cellul networks] solutions for mobile networks like Zain, Orange and Umniah. Your role includes designi and optimizing new communications solutions, which requires a good knowledge in sinusoidal sign: and their properties. Throughout a new project, your manager has requested your feedback on t following cases. Task 1: An alternating current in a 4G signal transmitter is expressed as 1 = 5 sin(120t + 0.52), I in mA, t in s, Find: A. The amplitude, period, frequency and phase shift (phase at time = 0, in degrees) of I B. The value of the current I at: i. t=0 ii. t= 1/60 iii. t= 1/30 iv. t = 1/15 What do you notice about your results? C. If the phase of the current I is 1 radians, what is the time at this instance.

Scenario 2: You work as a technical engineer in a company that designs and installs 4G and LTE [wireless cellul networks] solutions for mobile networks like Zain, Orange and Umniah. Your role includes designi and optimizing new communications solutions, which requires a good knowledge in sinusoidal sign: and their properties. Throughout a new project, your manager has requested your feedback on t following cases. Task 1: An alternating current in a 4G signal transmitter is expressed as 1 = 5 sin(120t + 0.52), I in mA, t in s, Find: A. The amplitude, period, frequency and phase shift (phase at time = 0, in degrees) of I B. The value of the current I at: i. t=0 ii. t= 1/60 iii. t= 1/30 iv. t = 1/15 What do you notice about your results? C. If the phase of the current I is 1 radians, what is the time at this instance.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

None
The diagram below represents the first two stages of a typical AM receiver. the power gains are Ap1=53, Ap2=0.33. The input power is Pin =0.33mW 1) Find the overall gain as ratio AT and AT( dB) 2) Find the outputs P, and Pout (unit is mW) 3) Express P1 and Pout in dBm P1 Pout amplifier Ap1 Pin Mixer Ap2
Question 3: An optical transmission link to transmit 50 Mb/s is shown as in Figure 4. The output power of the laser diode is 10 dBm and the insertion loss of the 50/50 coupler is 3.7 dB. The 50/50 coupler is used to split the power into two destinations: Receiver A and Receiver B. The link connection requires connectors and splicing in between the link. Given that, the connector loss is 3.5 dB, splicing loss is 4.0 dB and fiber attenuation is 1.5 dB/km. Each link to the receivers will have a 6- dB system margin. H Laser Diode (LD) Connector 50% 50/50 Coupler/Output 1 Output 2 50% 9 km Splice Connector Splice 17 km Figure 4: Optical transmission link |Receiver A Photodetector (PD) Receiver B Photodetector (PD)
3- Choose the correct answer: a. If the system requires lower system complexity, which system do you recommend: i. DPCM ii. DM iii. PCM b. The bandwidth of unipolar RZ is i. less than ii. bigger than iii. equal the bandwidth of polar NRZ. c. To reduce the "slope overload distortion" in DM we need to i. Increase ii. Decrease iii. Maintain i. Increase ii. Decrease iii. be Constant step size. d. If we reduce the number of quantization levels, L, the quantization error will
If a photovoltaic (PV) power generation system is connected to a smart grid, then during a major disturbance or heavy load conditions, will the PV generation system itself be affected? Will the power quality of the network be affected? Explain your answer. A distributed generation system provides power to a customer that faces flicker problem. What might be the reason of that flicker?
Derive the expression for Zin
Q2) Do not explain but compare again do not explain but compare and only compare among the methods used in the detection of FM signals.
Don't use chat gpt
1. If we add a Zero into a system: I. The gain slop will be increased by 20db/decade at its corner frequency. II. The gain slop will be decreased by 20db/decade at its corner frequency. III. Gain will not be affected. IV. None of the above. 2. If we add a Pole into a system: I. The phase will be increased by 90 degrees. II. The phase will decrease by 90 degrees. III. Phase will not be affected. IV. None of the above. 3. In systems, the Integrator add slop to the system gain equal to: I. 20 db/decade. II. -20 db/decade. III. 0 db/decade. IV. None of the above 4. The purpose of the Lag Compensator is: I. Improve the study state response of the close system. II. Speed up the transit response. III. All the above. IV. None of the above. 5. In the Lead Compensator: I. Z > P. II. Z < P. III. Z = P. IV. None of the above.
State and explain with diagram and reasons how the GaN LNA Receiver design can be modified with Network Traps to avoid bits of signal power loss and removing undesired harmonics of radiated signals in the Transceiver of figure 1 which finds use in several Giga Hertz Frequency for wireless communication applications.
Q. 13. Transmission systems that produce switching surges higher than lighting surges are the ones that operate at: A. 200 kV B. 300 kV C. 400 kV D. B and C Q. 14. When constructing volt time curve, if flashover occurs on the tail side of the wave, the point on the curve will have a voltage magnitude equal to: Whos A. The applied wave peak B. The applied wave flashover point C. The applied wave peak multiplied by a factor of 0.9 D. The applied wave flashover point multiplied by a factor of 0.9
a b c please