rod of the fixed hydraulic cylinder is moving to the left with a constant speed VA = 37 mm/s slider B when SA = 500 mm. The length of the cord is 1890 mm, and the effects of the radi ected. The velocity VB is positive if up. ime h = 235 mm. B

Q: 0.3 m B (0) AB 12 rad/s 0.6 m 30° II IV D The velocity at point B is 3m/s towards the left. a. What…

A: given; velocity of B towards left (VB)=3m/sAB=0.3mBD=0.6mθ=300

Q: In a four bar mechanism the link AB rotates with angular velocity of 20rad/s and angular…

A:

Q: 1. Part of a symmetrical rolling machine can be modeled as shown below. Find the velocities of…

A:

Q: 4. A solid metal pipe of mass 100 kg and length 7 m is placed on a truck as shown in the figure.…

A:

Q: Determine the torque applied to the shaft of gear A when the acceleration of gear B is 25.5 rad/s^2…

A: Given, Angular acceleration of gear B = 25.5  rad/s2. Mass of gear A , ma = 20 kg Radius of…

Q: Find the upward velocity v of the car hoist when e = 53. The piston rod of the hydraulic cylinder is…

A:

Q: 1. What is the vertical acceleration and normal velocity when the spring is stretched an extra…

A: We have  (d1)=0.70.7 mm (Wrong)So take it(d1)=((0.707) mm) (d2)=0.10.1 mm (Wrong)So take…

Q: The wheel shown in the figure has the inner and outer radius of r1= 0.125 m and r2= 0.575m,…

A: Givenr1=0.125mr2=0.575mv=5.6 m/s

Q: 4. Point A on the rod has a velocity of 84 to the right. Where is the IC for the rod? At what point?…

A: draw perpendicular to the both velocity vectors. IC is the point of intersection of those two lines.

Q: 5-6-1-2 In the system shown, rod AO rotates at w,= 1 rad/s, while disk OP rotates at a constant rate…

A:

Q: A torque T = 0.30 N-m is applied to a bevel gear B. Bevel gear D meshes with gear B and drives pump…

A:

Q: The bar AB is uniform and has a mass of 50.0 kg.  At the moment shown, the rod has an angular…

A: Given that, Mass of bar AB = 50 kg Angular velocity of rod = 4 rad/sec Spring is stretched by 0.3 m

Q: The 1.5-kg rod ACB supports the two 4.5-kg disks at its ends. (Figure 1) Part A If both disks are…

A:

Q: A load of lumber weighing W-25 kN is being raised by a crane. The weight of the boom ABC is 4 KN and…

A:

Q: Determine the velocity of Block D assuming link 2 is moving at 5 rad/s. The image is to scale with…

A: Kinematic velocity analysiscalculating velocity vector ob→ob→=ω1OBω1= angular velocity of link 1…

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.