a 4. Givenkm/hr to 20.0 km/hr in 6.00 seconds.A vehicle changes velocity from 80.0Required: Find the uniform acceleration in ft/s2. Besure to note the sign/direction (+ or -).

Answered: Image /qna-images/answer/86b5a89c-3025-40c5-a29f-09c563e81857.jpg

Answered: Required: Find the uniform acceleration…

Engineering

Civil Engineering

Required: Find the uniform acceleration in ft/s-. Be sure to note the sign/direction (+ or -).

Traffic and Highway Engineering

5th Edition

ISBN:9781305156241

Author:Garber, Nicholas J.

Publisher:Garber, Nicholas J.

Chapter3: Characteristics Of The Driver, The Pedestrian, The Bicyclist, The Vehicle, and The Road

Section: Chapter Questions

Problem 10P

See similar textbooks

Related questions

Q: FIHD THe CENTROID (x $ Y) of THe GazOMETRY

A: Centroid is the point where the mass of whole body acts. If there is a figure which consists of…

Q: The

A: The construction schedule normally contains sufficient detail to schedule the day to day work on a…

Q: Describe briefly the T-v Diagram.

A: The TV diagram refers to the Temperature-Volume diagram for a particular substance. The diagram…

Q: According to this figure, What is d? What is dt?

A: Draw the figure.

Q: what are the USCS group name for each of the four gradations

A: Given: Specimen LL PL PI Cc Cu 1 53 24 29 2 1.05 95.52 3 27 16 11 3.06 28.34 4…

Q: hat about pin d?

A: We know that Forces acting at Joint D are shown in figure below Forces moving away from joints are…

Q: ftware Orcad cadence in detail?

A: A schematic editor (Capture), an analog/mixed-signal circuit simulator (PSpice), and a PCB board…

Q: 400 Hole of radius 200 300 --> x' 600 - 750

A: we are authorized to answer up to three subparts in one question request. please repost the…

Q: what about CB, IH, AB & AB

A: To find zero force members.

Q: The block of mass m1 = m0 is attached to a spring of elastic constant k = (m0g)/H and natural length…

Q: VDC is an acronym for Virtual Design & Construction True False

A: Given Information Whether the acronym for VDC is Virtual design and construction

Question

4. Given
km/hr to 20.0 km/hr in 6.00 seconds.
A vehicle changes velocity from 80.0
Required: Find the uniform acceleration in ft/s2. Be
sure to note the sign/direction (+ or -).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Interior finishes for wood light frame construction

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Two automobiles A and B are approaching each other in adjacent highway lanes. At t=0, A and B are 1km apart, their speeds are 108km/h and 63km/h and they are at the points P and Q respectively. Knowing that A passes point Q 40s after B was there and B passes P 42s after A was there, determine the uniform acceleration of A and B, when the vehicles pass each other and the speed of B at that time.
The gap between two consecutive automobiles (distance between the back of a vehicle and the front of the following vehicle) is 65 ft. At a certain time, the front vehicle is traveling at 45 mi/h, and the following vehicle at 35 mi/h. If both vehicles start accelerating at the same time, determine the gap between the two vehicles after 15 sec if the acceleration of the vehicles can be assumed to take the following forms: du/dt = 3.4 - 0.07u, (leading vehicle) du/dt = 3.3 - 0.065u, (following vehicle) where ut is the vehicle speed in ft /sec.
A car starts from rest and travels 10 sec. with an acceleration of a = 4 – 0.3t, then runs for 30 sec. at constant velocity and finally comes to rest by decelerating at 3.125 m/s2. Determine the velocity of the car after 10 sec. Determine the distance traveled by the car during the period of 10 sec. c. Determine the total distance traveled by the car until it stops.
. Cars A and B starts from rest at the intersection of two roads which makes an angle 60° with each other. Car A accelerates at 0.85 m/s2 and car B has an acceleration of 0.70 m/s2. Determine the relative displacement of the two cars 30 seconds after leaving the intersection. Determine the relative velocity of the two cars 30 seconds after leaving the intersection. Determine the relative acceleration of the two cars 30 seconds after leaving the intersection.
Two automobiles A and B are approaching each other in adjacent highway lanes. At t = 0, A and B are 3200 ft apart, their speeds are VA = 65 mi/h and vâ = 40 mi/h, and they are at points P and Q, respectively. Knowing that A passes point Q 40 s after B was there and that B passes point P 42 s after A was there, determine (a) the uniform accelerations of A and B, (b) when the vehicles pass each other, (c) the speed of B at that time. VA = 65 mi/h UB = 40 mi/h B P 3200 ft
Repeat the previous problem, only now the driver of car A is traveling at VA = 130 km/h as it passes P, but over the next 5 seconds, the car uniformly decelerates to the speed limit of 100 km /h, and after that the speed limit is maintained. If the motion of the police car P remains as described in the previous problem, determine the distance required for police officer to overtake car A. Ans. 330 m
Normal and Tangential Acceleration. An outdoor track is 126 meters in diameter. A runner increases her speed at a constant rate from 4.2 to 7.2 m/s over a distance of 28.5 meters. Determine the total acceleration of the runner 2 seconds after she begins to increase her speed.
A car starts from rest at point A and accelerates at 0.75m/s^2 until it reaches a speed of 9m/s. It then proceeds at 9m/s until the brakes are applied. It comes to rest at point B, 27m beyond the point where the brakes are applied. Knowing that the distance between points A and B is 180m, determine the time required for the car to travel from point A to point B
Car A is traveling at a constant speed vA = 132 km/h at a location where the speed limit is 100 km/h. The police officer in car Pobserves this speed via radar. At the moment when A passes P, the police car begins to accelerate at the constant rate of 4.1 m/s² until a speed of 169 km/h is achieved, and that speed is then maintained. Determine the distance s required for the police officer to overtake car A. Neglect any nonrectilinear motion of P. VA Answer:s= m
1. The car is traveling at a speed of 45 mi/hr approaches point A. Beginning at A, the car as it decelerates at a constant 4 Jt/s- point B, after which its constant rate of decrease of until it gets to 3 ft/s? as it rounds the interchange ramp. speed is Determine the magnitude of the acceleration of the car at point C. Use 1 mile = 5280 ft. Hint: you have to solve the tangential velocity at point C using UAM Formulas. 200' A B 300'
The car is traveling at a constant speed through a dip in the road. The radius of curvature of the road at point A, the bottom of the dip is 471m. What speed of the car (kph) would result in an acceleration of magnitude 0.2g when the car is at A? use 3 decimal places
Car A is traveling at a constant speed vA = 127 km/h at a location where the speed limit is 100 km/h. The police officer in car P observes this speed via radar. At the moment when A passes P, the police car begins to accelerate at the constant rate of 5.0 m/s2 until a speed of 171 km/h is achieved, and that speed is then maintained. Determine the distance s required for the police officer to overtake car A. Neglect any nonrectilinear motion of P.