represents an oil storage drum that is open to the atmosphere at the top. Some water was accidentally pumped into the tank and settled to the bottom as shown in the Figure 2. Calculate the depth of the water h2 if the pressure gage at the bottom reads 158 kPa (gage). The total depth hT = 18.0 m

Q: What is the equivalent pressure head at the toe of the triangular dam in mm of Mercury? In meters of…

A:

Q: For the hydraulic system shown below, calculate the total head, elevation head, pressure head, and…

A: Coefficient of permeability of soil 1, Coefficient of permeability of soil 2, To find: The total…

Q: ube 3m long, with one closed, is inserted vertically with the open end down, into a tank of water…

A: Given:- d=1.2m L=3m To find:- The water level in the rube be below the level in the tank distance.

Q: A 28 cm diameter pipe exits a reservoir as shown. What is the pressure head at Point 2?

A: Given   Given:A 28 cm diameter pipe exits a reservoir as shown.      To determine: Pressure head…

Q: Problem 1 Water is a depth H at a fresh water dam. If an air bubble of certain volume at the bottom…

A:

Q: If d1=330 mm, d2=160 mm, d3=480 mm, and d4=230 mm, then find the pressure differential between tanks…

A: d1​=330 mm, d2​=160 mm, d3​=480 mm,and d4​=230 mmSg=13.6To find the difference between A and B

Q: The figure bellow shows the load distribution of a septic tank on the ground. The shaded area…

A: Given, qshaded = 200 kPa qunshaded = 800 kPa z = 8m

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A:

Q: 3.14 Some skin divers go as deep as 50 m. What is the gage pressure at this depth in fresh water,…

A:

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A: Given data  Density of oil = 800 kg/m3 Dynamic viscosity= 0.8 kg/ms  Diameter of pipe (D) = 0.1 m…

Q: From the figure below, compute the pressure at A, B and C. 0.4 m oil, s = 0.90 0.4 m 0.5 m B 1.0 m…

A: Given data in question Water Oil of specific gravity 0.9 Depths  To find out Pressure at A , B and…

Q: For the same condition as the previous problem (After a solid block is put on a scale in the water…

A:

Q: Water at 10°C has a kinematic viscosity of 1.30 X 10-6 m2/s flows at the rate of 895.55 L/min from…

A: Calculate the velocity of flow as follows. v=QA=895.55×10-360×6.793×10-3=2.2 m/s Calculate Reynold's…

Q: Answer fast please clarify all question.

A: Solution:To calculate the velocity of the pressure wave in the pipe and plot the variation of…