Replace the two moments and the three forces, acting on the pipe assembly, by an equivalent resultant force and couple moment at point O NO 205m- 100 N-m 300 N B 0.6m 0.8 m- 45 200 N 180 N-m 100 N

Q: What are the various types of errors? Explain the concept of sounding a number of some Significant…

A: Disclaimer: “Since you have asked multiple question, we will solve the first question for you. If…

Q: Determine length CE for the similar triangles shown in Figure 1. E 25 m D A 10 m FIGURE 1 B 16 m

A: For similar triangles, corresponding sides are in the same ratio.

Q: 42. The density of aluminum is 2.7 g/cm³. What is the density in kilograms per cubic meter?

A: Density is Note:Find:Density in

Q: Question 1 Solve the system of equations below for x. Assume that a=7.75, b=6.87, and y=2.51. Ca = x…

A:

Q: For each of the following descriptions of the volume of a cell, write a differential equation, find…

A: Given

Q: Identify the independent variable, levels of the independent variable, and the dependent variable.…

A:

Q: The Speed limit on a highway in Lower Slovakia was given as 120,000 furlongs per fortnight. How many…

A: Given problem is related to speed measurement.

Q: 11.16 A projectile enters a resisting medium at x = (0 with an initial ve Vo = 900 ft/s and travels…

A: The velocity of the system follows the equation, v=v0-kxinitial velocity, v0=900 ft/sif x=4 in=0.33…

Q: SI to US conversion, explain how many cubic feet are in 5.00 cubic meters. Show all work, include…

A: Conversion from m to ft is,

Q: Voltage (V) Circuit Current Resistance Power R2 Position (A) (ohm) (W) R, R 10.0 ohms 2 20.0 ohms…

A: h) The voltage across resistors in series combination is given by:

Q: A 6.22kg block is pushed across a horizontal surface with a hori: 12.7N. The acceleration of the…

A: Mass of block,                        Horizontal force on block                       Friciton force…

Q: 2. A 3/4 inch diameter rivet is used to fastened two 25 mm thick plate. If the shearing stress of…

A: Diameter of rivet d=3/4 inch=1.9*10-2m, Plate thickness t=25mm, Shearing stress of rivet s=80…

Q: 13. Measure the size of your shoe using an inexpensive ruler. Walk 10 nose to end steps. Then, using…

A: Given, observation of measurement of size of your shoe using ruler, tape. To find, %difference…

Q: The Speed limit on a highway in Lower Slovakia was given as 120,000 furlongs per fortnight. How many…

A:

Q: Solve for the total resistance (R7) and voltage drop in each resistor if 3 ohms, 4 ohms and 5ohms…

A: Say three resistances are connected in series to a battery as shown below: In series combination…

Q: could you please check my graph and also help me find the slope and the percent error. Thank you

A: Please see the answer below

Q: If you were to plot E vs v on a log-log graph what would you expect the slope to be? The expected…

A: Given             E=mv2/2

Q: A $250 150 mm B P4.82 250 mm C

A:

Q: Trial d (cm) Ad (cm) L (cm) AL (cm) 1 15.96 11.00 15.89 10.50 15.91 10.00 4 15.85 9.50 15.95 9.00…

A: Using formula of mean we can fill data table. MEAN: d¯=∑diiNN   OBSERVATIONS: TRIAL d (cm) ∆d…

Q: 18. A 65-kg basketball player jumps vertically and leaves the floor with a velocity of 1.80 m/s.…

A:

Q: The graph below shows the velocity of a ball on a spring verses time. IM V 05 25 a. 4 Position (m)…

A:

Q: When you convert from g small unit to g large unit you must divie Note: If this method is confusing…

A:

Q: What should you do after obtaining a numerical answer when solving a problem?

A:

Q: hypothetical alloy has a face-centered cubic unit cell. Its density is 10,470 kg/m3 and its atomic…

A:

Q: a man goes from A to B along the diameter AB of a circular shaped park in a certain time. He takes…

A: Suppose that, radius of the circle is r Speed is v = 8 m/min

Q: Part B: Adora needs to find the area of a table top. She measures the table width to be 0.8673m and…

A: Given data The measured table width is w = 0.8673 m. The measured table length is l = 1.405 m.\ The…

Q: Question 12 The volume of a small pond is 783 gallons. If one cubic meter is equal to 264 gallons…

A:

Q: The following conversions occur frequently in physics and are very useful. (a) Use 1 mi = 5280 ft…

A: In Question no 2 ) we need to convert the units .  For conversion, we need to replace the given unit…

Q: the reaction at A and the tension in the cord. D A 150 N 240 mm-240 mm- Fig. P4.70 B 200 mm 360 mm

A:

Q: A spring with a force constant of 225 N/m is resting on a frictionless surface and mounted…

A:

Q: A. QUANTITATIVE ANALYSIS: Write A if what is in column A is greater than in column B, B if column A…

A: Since you have been posted multiple questions. SO we are solving only first question for you. If you…

Q: Activity Oliver and Robin have different stride lengths and want to compare them. Oliver uses a…

A:

Q: Calculate the period of an artificial satellite orbiting at an average altitude of 1951 km above…

A: Altitude, h = 1951 kmRadius, r = 6,380 kmMass, m = 5.98×10²⁴ kgPeriod, T = ?

Q: Andre, a physics undergraduate, enters a coffee shop that is holding a contest. Customers who guess…

A:

Q: Assume it takes 5.00 min to fill a 25.0-gal gasoline tank. (1 U.S. gal - 231 in.³) (a) Calculate the…

A:

Q: The ambulance car drove the distance 6.3 km. The first part of the way the car drove at a velocity…

A: Given data: The total distance is d=6.3 km. The velocity in first part is v1=5.3v. The velocity in…

Q: A skier with a mass of 62.0 kg (including equipment) is sliding down a snowy slope. The slope makes…

A: Given in question - Mass(m) = 62.0 KgAngle = To find - Magnitude of the acceleration( a).

Q: What is the error formula for the following shown below 2x³ 3 =

A:

Q: Use the dimensional analysis to show if the following equations below are dimensionally consistent:…

A:

Q: Completely solve, illustrate, and box the final answers. 3. A 5 kg object is moving with a velocity…

A: Given  Question 3..  Mass of object, M = 5kg  Velocity , U = +5 m/s , in the  east   Final velocity…

Q: If quantity A is proportional to quantity B, describe how a graph of A vs B should look.

A:

Q: Below is the calculator result for the operation indicated. Enter the answer to the correct number…

A: Given, 2.15648 - 0.0056892 = 2.1507908  We want to correct number of significant figure in above…

Torque

Torque is the rotational equivalent of linear force in physics and mechanics. Based on the course of study, it is also known as the moment of force, rotational force, or turning effect.