Regarding impact resistance, determine what energy is mobilized by rock of 150-mm size falling out of a dump truck 1.5-m to the geotextile, if the geotextile rests on the following: (a) A “soft” soil of unsoaked CBR = 3 (b) A “firm” soil of unsoaked CBR = 9 (c) A “hard” soil of unsoaked CBR = 16

Regarding impact resistance, determine what energy is mobilized by rock of 150-mm size falling out of a dump truck 1.5-m to the geotextile, if the geotextile rests on the following: (a) A “soft” soil of unsoaked CBR = 3 (b) A “firm” soil of unsoaked CBR = 9 (c) A “hard” soil of unsoaked CBR = 16

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter9: Consolidation

Section: Chapter Questions

Problem 9.20CTP

See similar textbooks

Similar questions

F2
Calculate the soil density in PCF to be used in ground support system loading calculations for the following: a) Stiff glacial clay below the water table ε = 0.60, S.G. = 2.75 b) Uniform dense sand below the water table ε = 0.58, S.G. = 2.70
Geotech engineering
Please give the correct solutionnof this problem on geotechnical engineering
E2
Relative density.
A stratified soil deposit consists of four layers of equal thickness. The coefficient of permeability 1 1 of the second, third and fourth layers are respectively 3' 2 and twice of the coefficient of permeability of top layer. The average permeabilities of the deposit in parallel and perpendicular direction respectively, are
A horizontal stratified soil deposit consists of three uniform layers whose thicknesses are 6, 3, 12 m respectively. The permeabilities of the layers are 4*10^-4, 25 * 10^-4, 7.5*10^-4 mm/s. Find the effective average permeability in the horizontal direction.
A layer of silty soil of thickness 5 m lies below the ground surface at a particular site and below thesilt layer lies a clay stratum. The ground water table is at a depth of 4 m below the ground surface.The following data are available for both the silt and clay layers of soil. Silt layer: ?10= 0.018 mm, e= 0.7, and Gs = 2.7Clay layer: e = 0.8 and Gs = 2.75Required: (a) Height of capillary rise, (b) capillarypressure, (c) the effective pressure at theground surface, at groundwater table (GWT)level, at the bottom of the silt layerand at a depth of H =6 m below groundlevel, (d) at a depth 2 m below ground level.(Sketch or draw the stress distribution diagram).
A layer of silty soil of thickness 5 m lies below the ground surface at a particular site and below thesilt layer lies a clay stratum. The ground water table is at a depth of 4 m below the ground surface. The following data are available for both the silt and clay layers of soil. Silt layer: ?10= 0.018 mm, e= 0.7, and Gs = 2.7 Clay layer: e = 0.8 and Gs = 2.75 Required: (a) Height of capillary rise, (b) capillarypressure, (c) the effective pressure at theground surface, at groundwater table (GWT)level, at the bottom of the silt layerand at a depth of H =6 m below groundlevel, and (d) at a depth 2 m below ground level.(Sketch or draw the stress distribution diagram).
Cmp
A soil formation is composed of 5 m thick clay and 5 m thick sand being the sand above the clay. The ground water table (GWT) is located at 2 m below the ground surface. 40 kPa 2 m Sand Ydry = 17.66 kN/m^3 VGWT Sand 3 m Y sat = 20.93 kN/m^3 LI = 64% PL = 20% w = 40% 5 m Clay eo = 0.60 G. = 2.60 1. Calculate the primary compression index. [ Select ] 2. Calculate the primary consolidation settlement of the normally consolidated clay layer if there is a surcharge of 40 kPa acting on the ground surface. [ Select] 3. Calculate the secondary settlement of the clay layer 5 years after the completion of the primary consolidation settlement. Time for completion of primary settlement is 2 years. Use C, = 0.02. [Select ]