Referring to the circuit shown below, determine the following:(a) The voltage between points e and d(b) Power factor of the load 8.66-j5Note: Express the final answer in polar form. Referring to the circuit shown below, determine the following:(a) The voltage between points e and d(b) Power factor of the load 8.66 - j5 n-j52e100 Vj408.662Note: Express your final answer in polar form.-WW-WW-ll

Fig: Given circuit (a) Calculate the current I1 and I2…

Answered: Referring to the circuit shown below,…

Referring to the circuit shown below, determine the following: (a) The voltage between points e and d (b) Power factor of the load 8.66 - j5 n 3Ω -j52 d 100 V j40 8.66N ll

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Two parallel branches have admittances of 0.3+j0.4 and 0.2-j0.5 respectively. If the current in the…

Q: The output voltage waveform of a four quadrant chopper is shown in figure. In the waveform, Vdc is…

A: First write the expression for given output voltage waveform and than evaluate the rms value of the…

Q: This course Time left Find the value of i2, 14 and i5 if i1-3A, 13=1A and i6-1A. 10 oh 20 ohm 15 ohm…

Q: Determine the value of the capacitor to be connected in parallel with ZL (load) in order to correct…

A: In this question, We need to determine the value of the capacitor to be connected in parallel with…

Q: Three identical Y-connected loads, each having a resistance of 20 2 in parallel with an inductor,…

Q: Determine the RMS value of semi circular current wave which has a maximum value of "A". a. 0.816A c.…

Q: A sinusoidal AC voltage source has the equation, e=311sin377t, find the maimum voltage Rm, the RMS…

A: The solution is given below

Q: Q A power station with capacity of 800 kW is to supply two loads (A & B). The daily load curve of…

A: As per the policy we can solve only 3 sub-parts of a question, please re-upload the remaining part…

Q: ermine the following, . Amplitude i. Frequency ii. RMS value of Voltage Figure Al

A: Bartleby has policy to solve only first 3 subparts of a question. So reupload the question

Q: the balanced positive-sequence three-phase circuit shown below, fill the given below tables (show…

Q: The total power drawn by the two-impedance load in parallel is 26kW at 0.98 power factor lagging, it…

Q: Given the circuit shown, answer the following questions 1 20 ww 8 Ia ww Vs 24/50 V -j40 12 in Ampere…

A: In the circuit, Find the current I2 voltage V2 The equivalent impedance in ohm.

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: RMS value of sinusoidal voltage is given by Vrms= 5 V, Calculate the value of peak voltage Vm? a.…

A: For a sinusoidal voltage of peak value Vm and RMS value Vrms , Relation between peak value Vm and…

Q: The circuit shown in Figure Q1.2 is connected to a 1.6 Hz sinusoidal source. Calculate the total…

A: Given : frequency =1.6 hz ω=2Πf ω=2Π×1.6 ω=10.05 radian/second

Q: What is the mutual admittance, Y41, of the electric circuit shown in Figure 1?

A: We need to find the mutual admittance

Q: Given the circuit shown, answer the following questions I 40 1 U8 V22 Vs 24/60 V one of the…

A: We need to analyse the given network .

Q: Determine the output waveform for the network of figure below and calculate the output dc level. Si…

A: Rectifiers are used to convert the Alternating supply into pulsating DC. It can be an uncontrolled…

Q: what will be the power factor, if the inductive reactance is equal to the capacitive reactance of 20…

A: Given: Inductive reactance is equal to capacitive reactance of 20 Ω XL=XC=20 Ω The resistance is 20…

Q: The frequency is known as ohms but many times, it is referred to as cycles. Select one: TRUE FALSE

A: To discuss whether the given statement is correct or not. Statement: The frequency is known as ohms…

Q: A power station with capacity of 800 kW is to supply two loads (A & B). The daily load rve of the…

A: A power station, often known as a power plant, is a facility that generates electricity. A generator…

Q: VA rms() IA LA) PA (W) QAVAR (rad ts) (rod is)

A: Since you have posted a question with multiple sub-parts, We will solve the first three parts for…

Q: v(t)' +20V A1 12 6. 10 11 -5v

Q: Two impedances, Z1 = 2+j6 N and Z2 = 6-j12 N are connected in series with a 220-V 60-Hz supply. At…

Q: If A = 20260° and B= 5230°, find the products AB and BB".

Q: for 下e energy FiND Tellowing Synal ン(り- loe もろ0 the -ヒ loe くo

Q: The active and reactive powers of an inductive circuit are 60W and 80VAR respectively. The power…

A: According to the question we have to find the value of the power factor.

Q: Solve all parts i.e. a,b,c&d

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: The voltage V, in the frequency-domain circuit shown in (Figure 1) is 120./0° V (ms). • Part A Find…

Q: I. CIRCUIT DIAGRAM. R1 L1 150 26.5mH C1 100 Vrms 60 Hz =132.63µF 0°

A: In series RLC Circuit,XL=XC Resonance ConditionXL>XC Inductive Circuit (R+j XL-j…

Q: If the peak to peak voltage is equal to 20 . How much the RMS value of the voltage!?

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: The circuit shown in Figure Q1.2 is connected to a 1.6 Hz sinusoidal source. Calculate the total…

A: Given that; f=1.6 hz We can draw the above figure as;

Q: Л Ч -5 i(t) mA 10 Sinusoidal 5 10 15 1 (us)

Q: 12.14: the currenit waveforms of a capacitov are shown in Figuse o Determine root The avesage peak…

A: Given Ip=500 At1=100 μst2=300 μst3=500 μsfs=250 Hz

Q: An alternating current varying sinusoidally with a freq. of 50 c/s. has a r.m.s. value of 35 A.…

Q: Q1/ A resistance of 2002, an inductance of 0.2 H and a capacitance of 100 μF are connected in series…

Q: Consider the system in the figure to the right. The Zbus for the system is given as follows: [j0.411…

A: Given data Zbus=j0.411j0.310j0.354j0.310j0.446j0.333j0.354j0.333j0.450 To find out We have to…

Q: A sinusoidal current has a rms value of 3 amperes, its maximum value will be ______.

Q: Derive the formula for the RMS value for the following a)

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: one (360 degrees), all of the instantaneous power falls under positive loops (no negative loops),…

A: Option A Resistor is the correct answer.

Q: Which of the following descriptions IS NOT correct for loads in power systems? A. The purely…

A: capacitive load will deliver reactive power to the grid. so option C is the wrong one

Question

Referring to the circuit shown below, determine the following:
(a) The voltage between points e and d
(b) Power factor of the load 8.66-j5

Note: Express the final answer in polar form.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

electric units a & b are connected in parallel and its rms current is 15A. If the current in b lags behind a by pi/3 rads and the current is 23.4 A. find the current in b and sketch the equivalent circuit diagram
q5
An alternating current varying sinusoidally with a frequency of 50 Hz has an rms value of40 A. Find:a. The instantaneous value of 0.0025 seconds after passing through maximumpositive value,b. The time measured from the maximum value when the instantaneous current is14.14 A.
2
3) Calculate the currents I1, I2 and I0, as well as the active power supplied to the load secondary side.
Please provide Handwritten answer
Please answer all subpart please Asap I will like it please ASAP..
A sinusiodal voltage having maximum amplitude of 680 V is applied to the terminals of 65 Ohm resistor. Find the rms value of current in the resistor. (Unit: A) Submit Answer
6. Determine the rms current I as shown in figure 1. Source voltage is already in RMs value (Answer must be in polar form and should be in 4 decimal places) -j4 n 20 j1.5 a B 40 200/30 V -12 n: Figure 1. 7. Determine the rms current I as shown in figure 2. Source voltage is already in RMS value (Answer must be in polar form and should be in 4 decimal places). j4n 240/50 V 火 js a 60 20 Figure 2.
the two alternating e.m.f.s would reach their maximum and zero values at the same time such alternating voltages or (currents ) said to be: Phase with each other In phase with each other
5. An alternating current varying sinusoidally with a frequency of 50 Hz has an rms value of 20 A. a) Determine the instantaneous value at 0.0025 seconds. b) Determine the instantaneous value, 0.0125 seconds after passing through a positive maximum value. c) At what time, measured from a positive maximum value, will the instantaneous current be 14.14 A?
Short term and long term effects of wind energy on power system