Refer to diagram 3. A closed circular loop (N = 409 turns, radius r= 6.6 cm, resistance R = 3.65 Q) sits in a constant magnetic field B = 5.03 T pointing perpendicular to the plane of the loop (into the page). This time the loop is rotating about a horizontal axis through its diameter at a constant rate of 85.4 revolutions per minute. Find /max, the peak current induced in the loop, in A. Give the answ as a positive number.

Refer to diagram 3. A closed circular loop (N = 409 turns, radius r= 6.6 cm, resistance R = 3.65 Q) sits in a constant magnetic field B = 5.03 T pointing perpendicular to the plane of the loop (into the page). This time the loop is rotating about a horizontal axis through its diameter at a constant rate of 85.4 revolutions per minute. Find /max, the peak current induced in the loop, in A. Give the answ as a positive number.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 8-turn generator coil with area 0.155 m^2 rotates in a 1.20 T magnetic field. At what frequency should the coil rotate to produce a peak emf of 150, expressed four sig figs with approp units. Attached are self notes. If you help me with the symbology... I know that f = frequency. I am not at clear the other symbols.
X X X X X 1. In the figure to the right, the magnetic field B is pointing into the page and increasing in magnitude. What is the direction of the induced current? 2. If the radius of the (single) loop is 13.0 cm, and the field decreases from B = 0.067 T to zero in 0.13 s, what is the %3D メ magnitude of the induced emf? 3. Suppose the resistance of the wire is given to be 112 N. Calculate the induced current. X X X X X X,
How (Figure 1) shows a 4.0-cm-diameter loop with resistance 0.17 Ω around a 2.0-cm-diameter solenoid. The solenoid is 11 cm long, has 100 turns, and carries the current shown in the graph (Figure 2). A positive current is cw when seen from the left. Find the current in the loop at t = 0.5 s. Express your answer as an integer and include the appropriate units. I(0.5) = Find the current in the loop at t= 1.5 s. Express your answer to two significant figures and include the appropriate units. I(1.5) = Find the current in the loop at t = 2.5 s. Express your answer as an integer and include the appropriate units. I(2.5)=
Ex.1 A 100-loop square coil of wire, with side L=5 cm. and total resistance R=100 Ohm is positioned perpendicular to a uniform magnetic field B=0.6 T. as shown in Figure. below. It is quickly pulled from the field at constant speed (moving perpendicular to ) to a region where B drops abruptly to zero. At the right edge of the coil is at the edge of the field. It takes 0.100s for the whole coil to reach the field-free region. Determine (a) the rate of change in flux through one loop of the coil, and (b) the total emf and current induced in the 100-loop coil. (c) How much energy is dissipated in the coil? (d) What was the average force required( APPROACH We start by finding how the magnetic flux, changes during the time interval Faraday's law then gives the induced emf and Ohm's law gives the current.) B-0.600 T X X B=0 ext X X x x: xx x x x x × × -5.00 cm
A single turn coil of radius 5.00 cm is held in a vertical plane and a magnet is rapidly moved relative to the coil as shown in the diagram below. The field inside the coil changes from 0.040 T to 0.025 T in a matter of 0.200 seconds. If the resistance of the coil is 6.00 Ohms, what is the magnitude and direction of the induced current in a coil as viewed from the side of the magnet? Make sure to include clear explanations for your choice of current direction.
A single turn coil of radius 7.00 cm is held in a vertical plane and a magnet is rapidly moved relative to the coil as shown in the diagram below. The field inside the coil changes from 0.045 T to 0.020 T in a matter of 0.300 seconds. If the resistance of the coil is 5.00 Ohms, what is the magnitude and direction of the induced current in a coil as viewed from the side of the magnet? Make sure to include clear explanations for your choice of current direction.
solve correctly. I will rate accordingly.
Need help with problem #1
I need help on 2
Suppose a large generator rotates in the Earth's magnetic field. The strength of this magnetic field may be taken to be 0.500 Gauss. The generator has 600 circular loops of radius R = 0.500 meter, and the area of the loop is TR². The generator rotates at a frequency of 10.000 Hz. What is the peak AC voltage, E, generated? [?] V (Note: 1 Tesla = 10,000 Gauss) Enter
The magnetic field through a single loop of wire 12.0 cm in radius and of 7.5 Ω resistance changes with time as shown in the figure. Calculate the emf in the loop as a function of time.What is the emf at t = 1.0 s? For the sign take the loop in the plane of the paper, and the magnetic field out of the paper. Take clockwise to be positive emf. What is the emf at t = 3.0 s? What is the emf at t = 5.0 s? What is the current at t = 1.0 s?
b.) Find the net magnetic field at P. 10.) When a magnetic field is first turned on, the magnetic flux through a 10-turn coil varies over time. The equation for the magnetic flux is m = 200.0t2 – 120.0t, where the magnetic flux is measured in webers, and the t is in minutes. The loop is in the plane of the page, with the unit normal pointing out of the page. dºm a.) Calculate an expression for dt b.) Find an equation for the induced emf as a function of time.