Reciprocal leveling gives the following readings in meters from a set up near A: on A, 1.110; on B, 0.887, 0.845, and 0.984. At the setup near B: on B, 1.549; on A, 1.673, 1.670, and 1.666. The elevation of A is 1045.343 m. Part A Determine the misclosure of B. Express your answer to three decimal places and include appropriate units. Misclosure = Value Submit Part B elevB = Submit μA Request Answer Determine the elevation of B. Express your answer to three decimal places and include appropriate units. НА Value Units Request Answer Units ? ?

Q: Q4: a. The following readings were observed successfully with a leveling instrument. The instrument…

A:

Q: The survey works were carried out using the leveling device and took 0.895, 1.305, 2.800, 1.960,…

A:

Q: What is the error of closure?

A: Given:Reduced level of bench mark-10=701.32'We know that,Height of instrumentHI=R.L. of B.M. of…

Q: DIFFERENTIAL LeuEL IN PROBLEM # 4.72 8.19 2,16 :6.3) 3,04 6.72 3,15 BM Eleu TP #2 TP #3 TP FLeu lo00

A:

Q: Reduce the set of differential leveling notes in Table 2-11, and perform the arithmetic check.…

A:

Q: Based on the level loop problem. What is the calculated elevation of BM_10 ?

A: Given: The reduced level of BM10  is 701.32'.   To Determine: The calculated elevation of BM10.

Q: Prepare a set of level notes for the data listed. Perform a check and Elevation of BM 7 is 852.045m.…

A: The given data is: Length of loop=1500 m Elevation at BM 7=852.045 m Using the formula below,…

Q: 10. Complete the following table using the knowledge obtained in class about differential leveling…

A: Given Data Total 5 stations has been given and we are asked to calculate the Elevations, adjusted…

Q: A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ft) and closed on BM…

A: BM Hydrant =5869.31 ftBM Rock (orthometric height 5830.03 ft). Readings  2.28 (+S) on BM Hydrant,…

Q: What is the calculated value of BM_13 before adjustment ?

A: Given:R.L. of B.M.-10=701.32'We know that,Height of instrumentHI=R.L. of B.M. of known elevation+…

Q: The following consecutive readings were taken with a level and a 4m leveling staff on a continuously…

A: A leveling is done on slope AB, with a common interval of 30m on the line. Station Chainage Level…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.