Range of a generating voltmeter is 30 to 300 kV dc and its indicating meterreads a minimum current of 3μA and maximum current of 35 μA, find the capacitance of thegenerating voltmeter. 23. (15 Points) Range of a generating voltmeter is 30 to 300 kV dc and its indicating meterreads a minimum current of 3µA and maximum current of 35 µA, find the capacitance of thegenerating voltmeter.

Assume that the driving motor has a synchronous speed of 1500 rpm, Irms=VCmω2 where, V is the…

Answered: Range of a generating voltmeter is 30…

Range of a generating voltmeter is 30 to 300 kV dc and its indicating meter reads a minimum current of 3μA and maximum current of 35 μA, find the capacitance of the generating voltmeter.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: A limiter circuit should be designed that limits a 20 V rms sinusoidal voltage to a maximum positive…

Q: How does the equivalnce capacitance in series vs parallel relate to the dimming time of a bulb.

A: Dimming time of a bulb:- The bulb does not directly glows based on the electricity flowing through…

Q: Can Ohm's Law be applied to a capacitor in an alternating current circuit?

A: Ohm's Law:- Under the assumption that all physical parameters and temperatures remain constant,…

Q: What are the types of semicondoctors available

A: The objective of the question is to identify and describe the different types of semiconductors…

Q: What are the things common in direct current and alternating current. And also its Difference

A: The explanation is as follows.

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: Value of series impedance if inductance is 4mH , resistance is 40 ohm and frequency is 50 Hz.

A: Given values are =

Q: When a capacitor is discharged through a resistor, the discharge curve is exponential Sinusoidal…

A: Equation for discharging of capacitor is given by, v=voe-tΤ. Here, vo is initial voltage, v is…

Q: 3. The secondary voltage can rise above its rated value when the load is a. resistive. b.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: For figure (1)draw and calculate the voltages waveform across each half of secondary winding and…

A: The figure shows a full wave rectifier circuit using two diodes D1 and D2. The supply voltage is…

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: What is value of RMS current if voltage is 10sin(100t) Volt and load is 10mH inductor.

A: v(t)= 10sin (100t) Volt XL=jωL XL=j(100)(0.01) Ω XL=j1 Ω

Q: Compute the amount of capacitance needed to correct the power factor to 90%

Q: The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak…

A: The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak…

Q: An inductor and resistor are connected in parallel to a 120-V, 60-Hz line. The resistor has a…

A: An inductor and resistor are connected in parallel we need to find the phase angle between voltage…

Q: A moving coil ammeter and a moving iron ammeter are connected in series with a rectifier across 110V…

Q: When a capacitor and a resistor are connected in parallel, how many degrees out of phase are the…

A: When resistance and capacitance are connected in parallel, the current flow through the resistor and…

Q: Establish and analyze Ohm's Law applied for a capacitor in sinusoidal alternating current

A: Ohm's law: Ohm's law states that the current flowing through the conductor is directly proportional…

Q: 3. Sketch the current waveform for the circuit in Figure below. The diac has a breakover potential…

A: Given data: The breakover potential, VB=20 V. The holding current, IH=20 mA. The given circuit…

Q: Value of series impedance if inductance is 5mH , resistance is 4 ohm and frequency is 50 Hz.

A: Given values are =

Q: What is the speed of an inductor motor of 7 poles if the slip is 2.1%

Q: The conversion of an AC to DC Source is by using the A) Commulator B) None of these C Round ring…

A: The commutator is used in the DC generator to convert the AC voltage into a DC voltage.

Q: Consider the following statements :A clamper circuit 1. adds or subtracts a dc voltage to a waveform…

A: A clamper circuit is consist of a capacitor diode and batteries ( dc level,) If input is of any…

Q: A non polarized capacitor is connected in DC circuit. Is there a danger of damaging the capacitor…

A: Asked to explain what happens if an unpolarised capacitor is connected to the DC supply? An…

Q: characteristics in alternating currents with a frequency

Q: Determine the K stability range of the control system, whose characteristic equation is given as…

Q: An inductor and a 470 ohm resistor are connected in series with a function generator. The current is…

A: Given, Resistor and inductor are connected in series. Resistance (R)= 470 ohm Current flows…

Q: If the voltmeter in the figure shown reads 60 V, find the following: A V V j3 + j4

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: A Clipper circuit can be used to clip the desired voltage level in any cycle. since a single dc…

Question

100%

Range of a generating voltmeter is 30 to 300 kV dc and its indicating meter
reads a minimum current of 3μA and maximum current of 35 μA, find the capacitance of the
generating voltmeter.

23. (15 Points) Range of a generating voltmeter is 30 to 300 kV dc and its indicating meter
reads a minimum current of 3µA and maximum current of 35 µA, find the capacitance of the
generating voltmeter.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
For figure (1)draw and calculate the voltages waveform across each half of secondary winding and across load when 100sin2π60t applied across the primary, then find PIV.
what is the use of DC/DC tension converter DC/DC booster MT3608
Discuss the difference between Alternating Current (AC) and Direct Current (DC)
a. individal current b. voltage source
8. Liquids with solid impurities a) Have higher dielectrie strength b) Of large size have higher dielectric strength c) Have lower dielectric strength as compared to pure liquids d) None of the above 9. Peak to peak ripple is defined as a) the difference between average de voltage and peak value b) the difference between maximum and minimum de voltage c) the difference between maximum ac and average dc voltages d) the difference between ac (rms) and average de voltages 10. In a Cockroft-Walton circuit, input voltage 100 kV load current 25 mA, supply frequency 100 Hz, each capacitor 10 nF. The optimum no. of stages for maximum output voltage is a) 1 b) 2 c) 10 d) 35
How does the internal resistance of the multimeter (in voltage setting) affect the charging/discharging rate of the capacitor. Explain.
Choose the correct statement for pure inductor connected across single phase AC supply. a. Current leads the supply voltage by 90° b. Current lags the supply voltage by 90° c. Current and Voltage are in phase d. None of these
3-9 An rms ac voltmeter and a peak-to-peak-reading ac voltmeter are to be used to determine whether three ac signals are sinusoidal. Deter. mine whether the signals are sinusoidal if the following readings are obtained First signal Second signal Third signal peak-to-peak reading = 35.26 V rms reading. - 12.00 V peak-to-peak reading - 11.31 V rms reading = 4.00 V peak-to-peak reading = 25.00 V rms reading -8.83 V
Please solve this question in electric circuits
QUESTION 11 An inductor is connected in parallel with a 6540 resistor and a function generator. The applied voltage is 42V RMS and the total current is 67mA RMS. Find the magnitude of the current through the inductor. Enter your answer in the space provided. Round your answer to one decimal place. Your answer should be in mA but do not enter the unit.
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of 158 volts, 50 Hz supplies the combination. Determine the following: a. Circulating current b. Voltage across the resistor c. Voltage across the capacitor