Answered: QUESTIONS:1. A) Write down the… | bartleby

Related questions

Question

QUESTIONS:1.
A) Write down the definitions of magnetization (M), magnetic dipole moment (4), magnetic flux (), magnetic
induction (magnetic flux density) (B) and magnetic field strength (H).
B)Write down the units of the physical quantities that you defined in the previous question and find their derived
units in terms of basic quantities of the SI system.

Expert Solution

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Question help
symmetries. 1. Solenoid: The magnetic field inside a very long solenoid must be along the axis of the solenoid. The magnetic field outside the solenoid is approximately zero. A very long solenoid of radius b carries a current I with turns per length. We want to use Ampere's law to find the magnetic field at a point P a distance ? from the central axis. Assume r
Consider the velocity selector diagrammed below. If the charged particle ejected by the heated filament passes through the capacitor plates undeflected with a speed of 2.0 x 105 m/s,what is the magnetic field strength if the electric field strength is 800 volts/m? a. 2.0 mT b. 0.00 mT c. 6.0 mT d. 8.0 mT e. 4.0 mT
3. Four long wires are parallel to each other, their cross section forming a square 20 cm on edge, as shown in Figure 1 below. A 20 amp current is set up in each wire. What is the force per meter acting on the lower left wire, in magnitude and direction? represents current flowing through wire in the direction out of the paper, direction into the paper. represents current flowing through wire in the a a a Figure. 1
Describe how the magnetic domains in an unmagnetized iron rod will respond to the presence of a strong external magnetic field. a. The domains will split into monopoles. b. The domains will tend to align with the external field. c. The domains will tend to orient themselves perpendicular to the external field. d. The domains will tend to align so as to cancel out the external field.
nswer A square coil with 475 turns of wire has a length of each side of 7.52 cm. A current of 0.546 amp flows through the coil. The coil is placed in a magnetic field of 0.585 T with the plane of the coil at an angle of 34.3 degrees to the direction of the field. What is the forque in Newton-meters on the coil by the magnetic field? (Enter your answer with 3 digits right of decimal, and do not enter unit.) A Moving to another question will save this response. KQuestion 7 of
Instructions1. In the three cases, use the average of the two angles ( = (+) + () =2), the averageof the two currents ( I = I(+) + I() =2), and Eqs. (1) and (2), and calculate coilÖeld and the earth ís horizontal component of magnetic Öeld, B(earth) H [ Tesla ].2. Based on the three previous calculations, what is your experimental determination ofthe horizontal component of the earthís magnetic Öeld, B(earth) H [ Gauss ]?3. Take the accepted value of the earthís horizontal component of magnetic Öeld in southFlorida to be 0:25 Gauss and calculate the percent error in your answer.
1. Determine the fundamental unit equivalent to a Tesla. Deld. FaquB units: N= CmlsT
Help
1a. Determine the magnitude of the magnetic field at a point 33.0 mm from for a current-carrying conductor with 1.5 A of current running through it b. How would the magnetic field vary for the same conductor above if it was 2.5m long, and the current-carrying conductor was wound into a coil with a total of 5.0x103 turns? Express this value as a ratio to the magnetic field found in part a.
6. Mass spectrometry uses magnetic field to separate isotopes (same element, but different atomic masses), so we can get the relative abundance of the different isotopes of a given element. For example, Chlorine has two naturally occurring isotopes: Cl-35 has a mass of 5.812 x 10-26 kg and Cl-37 has a mass of 6.144 x 10-6 kg. If both of these are ionized to a singly charged ion (q = -1.602 × 10-" C), and accelerated through a voltage of 400 V, (a) what is the diameter of the semicircular path travelled by each of the isotopes in a uniform magnetic field of 0.10 T? See the figure below for the geometry. lonizer (b) The results can be further refined by a velocity selector so only ions with a specific velocity enters the magnetic field (see below). If the electric field in the velocity selector is 2000 N/C, what magnetic field strength is needed to have only ions with speed of 4.60 x 10' m/s to pass through undeflected? In that case, what is the diameter of the semicircular path…
Describe the origins of the magnetic field of the Earth. Describe what is meant by magnetic field strength and state its unit of measurement in SI units. Select one or more: a. Magnetic field strength is measured in amperes per meter squared. b. О с. d. The magnetic field strength B is the value of the current in the loop per unit area. The magnetic field of the earth is caused by electric currents inside the molten iron core of the Earth. The magnetic field strength B is defined as the force acting per unit current in a wire of unit length when the wire is perpendicular to the magnetic field lines. e. The magnetic field of the earth is caused by Earth's rotation around the Sun. ☐ f. Magnetic field strength is measured in Tesla.