A square coil with 475 turns of wire has a length of each side of 7.52 cm. A current of 0.546 amp flows through the coil. The coil is placed in a magnetic field of 0.585 T with the plane of the coil at an angle of 34.3 degrees to the direction of the field. What is the forque in Newton-metérs on the coil by the magnetic field? (Enter your answer with 3 digits right of decimal, and do not enter unit.)

A square coil with 475 turns of wire has a length of each side of 7.52 cm. A current of 0.546 amp flows through the coil. The coil is placed in a magnetic field of 0.585 T with the plane of the coil at an angle of 34.3 degrees to the direction of the field. What is the forque in Newton-metérs on the coil by the magnetic field? (Enter your answer with 3 digits right of decimal, and do not enter unit.)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Convert the balance readings (mass in grams) to force (N) for each data table. To do so, you first need to subtract the balance reading when the current was zero. Please help me fill out the graph under force.
What is the magnetic field strength if an area of5m2 a magnetic flux of 120wb?
Please check carefully don’t give me the same wrong answer in the letter C
A wire with a resistance of 1.2 ΩΩ is bent into the two-loop shape shown in (Figure 1). The length of the sides of the large square is 9.0 cmcm; those of the smaller square are half that, If the magnetic field shown is increasing at a rate of 0.075 T/sT/s, what is the current in the wire?
True or false: The stir bar is magnetized to stir using a magnet in the stir plate.
Needs Complete typed solution with 100 % accuracy.
Is my answer to this question correct?
i have tried this problem several times and I keep getting 3.12 which is not correct or 5.69 which is not correct I think there may be a formating issue on my end so please help if you can!
(a) A small wire loop carrying current is placed next long straight current wire as shown in the diagram. Label direction of force acting on each side of the loop due to long wire as follows with arrowheads. Force on AB is F1, Force on BC F2, Force on CD F3. Force on DA F4. Label the direction of net force on ABCD as F. A (b) ABCD is a square with side 4 cm. Two long wires carry currents 10 A each goes through A and B perpendicular to plane of ABCD out of the page. Label the magnetic field at the center of the square due to wire at A as B1 and wire at B as B2. What is the direction of net magnetic field at the center?
Describe the magnetic field that exists between the plates of a charging or discharging capacitor with parallel circular plates. The magnetic field lines are straight lines perpendicular to the plates (ignoring fringing at the edges.) The magnetic field lines are straight lines parallel to the plates (ignoring fringing at the edges.) There is no magnetic field between the plates. The magnetic field lines are circles around an axis perpendicular to the plates (ignoring fringing at the edges.)
The right-hand rule (RHR), as applied to solenoids, tells us the relationship between the coiling current and the magnetic field produced. Your fingers curve in the direction of the current (which follows how the wires are wrapped around in a circle). Your thumb then points in the direction of the magnetic field: https://www.miniphysics.com/ss-magnetic-field-due-to-current-in-a-solenoid.html When applying the RHR for solenoids, first determine the how the current is flowing. This requires (a) a careful look at the windings and how they wrap around and (b) the direction of positive current flow which is sometimes set by a voltage source. Curl your fingers to follow the current through the windings. Finally, note where your thumb sticks out. Your thumb will point in the direction of the magnetic "north" field. Following these steps, select the magnetic field direction for each of these solenoids: Solenoid 1 Solenoid 2 Solenoid 3 Solenoid 4 solenoid practice
what is the speed of an electron if the force generated is 3.72-N and the magnetic field strength is 4.21-T?