QUESTION 9 During the video on heat conduction, H through a single pane window was calculated. Now, consider a window that has two panes with a 6 mm air gap between them. Each pane has an area of 1.9 m. The window separates the inside of a house at 22 °C from the outside at 0°C. Let Kair = 0.03 W/(m-K). Hint: This problem can be simplified by noting that the thermal conductivity of glass is much greater than air, so the effect of the glass on the total conductivity can be ignored. Therefore, the purpose of the two glass panes is to support the layer of air between them. Calculate the heat current H through the double glass pane window in watts. Do not include units in your answer and state your numerical answer in normnal form.

QUESTION 9 During the video on heat conduction, H through a single pane window was calculated. Now, consider a window that has two panes with a 6 mm air gap between them. Each pane has an area of 1.9 m. The window separates the inside of a house at 22 °C from the outside at 0°C. Let Kair = 0.03 W/(m-K). Hint: This problem can be simplified by noting that the thermal conductivity of glass is much greater than air, so the effect of the glass on the total conductivity can be ignored. Therefore, the purpose of the two glass panes is to support the layer of air between them. Calculate the heat current H through the double glass pane window in watts. Do not include units in your answer and state your numerical answer in normnal form.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A small metal cube with a thermal mass mc and an initial temperature 0 is dropped into a container of water that is actively maintained at a constant temperature 0w. The cube quickly comes to rest on the bottom surface of the container. The bottom surface is maintained at a constant temperature 0 (note that this is different from 0w). The thermal resistance between the cube and the water is Rcw while the thermal resistance between the bottom surface of the container and the cube is RCB. The temperature of the cube is denoted by 0c. a) Draw the system schematic indicating the assumed directions of the heat transfer rates. Label all the nodes and system parameters. b) Derive the governing equation for the temperature of the cube, 0c. c) Where does to appear in the system schematic and how does it affect the governing equations? d) Calculate the steady-state temperature of the cube, css, assuming the following system parameters: 0o = 21°C, 0B = 6°C, 0w = 0°C, Rcw = 2°C/W, and RCB = 4°C/W
The density of ice and water are 917 kg/m³ and 1000 kg/m³. The latent heat for the transition between ice and water is 334 kJ/kg. Calculate the slope of the tangent of the coexistence curve of ice and water at T = 213 K. Select one: dP dT a. b. C. O d. dP dT dP dT dP dT = - -170 atm/K = — - - 181 atm/K -203 Pa/K -183 Pa/K
temperature is 330 K. Find the heat loss per unit area and the temperature of the junction of the fire brick and insulating brick? RO 5. In Sohar Petroleum Company, a steam pipeline, with 150 mm ID and 160 mm OD carries steam. The pipeline is surrounded with a layer of heat insulating material (K=0.08 W/m.k) of thickness 100 mm. The temperature drops from 392.8 K to 313 K across the insulating surface. Determine the rate of heat loss per 1 m length of pipe line. ID = 1Somm 160 mm OD,h-loo mm .K=0.08w/m.k %3D 「-392.8 ん/ 12 = 313k = 313 K 2.
U7
A 1 kg bar of copper is heated at atmo- spheric pressure of 1.013 x 105 N/m². If its temperature increases from 14°C to 54°C, find the work done by the copper. The linear expansion coefficient of copper is 1.7 x 10-5 (°C)¹, its density is 8920 kg/m³ and its specific heat is 387 J/kg. ° C. Answer in units of J. part 2 of 2 What quantity of thermal energy is trans- ferred to the copper in this process? The specific heat of copper is 387 J/kg.° C. Answer in units of J.
A 2.6 kg lump of aluminum is heated to 96°C and then dropped into 11.0 kg of water at 5.4°C. Assuming that the lump-water system is thermally isolated, what is the system's equilibrium temperature? Assume the specific heats of water and aluminum are 4186 and 900 J/kg-K, respectively. Number i Units
A small building has a heater inside it running with its door left open. The heater is the only device in the building. When the heater runs, it consumes 250 W. The building is 3m X 3m X 2.5m. The temperature outside is 25 degrees celsius, and the the wind is blowing at 10km per hour. Estimate the temperature inside the building if the walls and ceiling are made of 13 mm thick plywood and 13 mm thick drywall with 100 mm of air inbetween. The floor is perfectly insulated and there aren't any cracks in the walls ceiling or door frame. Make any other reasonable assumptions as needed
Answer in m
Rubbing your hands together warms them by converting work into thermal energy. a. If a woman rubs her hands a total of 19 times (forward and backwards count separately), at a distance of 7.75 cm per rub, and with an average frictional force of 39 N, what is the temperature increase of her hands, in degrees Celsius? The mass of tissues warmed is only 0.100 kg, mostly in the palms and fingers, and the heat capacity of her hands is 3500 J/(kg⋅°C).
Ice at -12.1 °C and steam at 121 °C are brought together at atmospheric pressure in a perfectly insulated container. After thermal equilibrium is reached, the liquid phase at 44.1 °C is present. Ignoring the container and the equilibrium vapor pressure of the liquid at 44.1 °C, find the ratio of the mass of steam to the mass of ice. The specific heat capacity of steam is 2020 J/(kg C°). af Number i Initial state Units Steam - Ice Equilibrium Water
Solar panels on one of the NWU solar car prototype, have an emissivity of e = 0.819. When in direct sunlight, they absorb energy at a rate of 877 J/s per square meter of surface. Assume that the only energy loss is due to the emission of radiation. What equilibrium temperature are the panels reaching?
How do I go about the questions d and e ?