QUESTION 6 1. The following data were taken from PEG method of adjustment. Point 1 is midway between A and B. Point 2 is 20m to the left of A and 120m from B. Determine the difference in elevation between A and B. (give your answer in two decimal places) Instrument at 1 3.0 2.0 Rod Reading on A Rod Reading on B Instrument at 2 2.75 1.50

QUESTION 6 1. The following data were taken from PEG method of adjustment. Point 1 is midway between A and B. Point 2 is 20m to the left of A and 120m from B. Determine the difference in elevation between A and B. (give your answer in two decimal places) Instrument at 1 3.0 2.0 Rod Reading on A Rod Reading on B Instrument at 2 2.75 1.50

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Apply “Rise and Fall method” for working out the reduced levels of points for which the following consecutive readings were taken with a level. 0.894, 2.643, 2.896, 4.016, 1.954, 0.692, 2.582, 0.251, 1.532, 2.996, 1.135 The instrument was shifted after the 2nd, 4th, 6th and 8th readings. The first reading was taken on the staff held on the bench mark of R.L. equal to 5757. Rule out a page of level field book and enter the above readings
QUESTION 4 Table Q4 shows the booking of levelling fieldwork conducted during light rain. It was later found out that some of the readings are illegible due to the rain water. Complete the booking and perform all checks. Table Q4 BS IS FS HPC RL Remarks ? 20.662 18.569 TBM 1 RL 18.569 2.010 ? ? 18.645 3.467 0.418 20.244 C (CP) 3.053 ? D E TBM 2 RL 22.968 1.467 22.243 22.959 !! IMPORTANT ! SAVE THIS QUESTION PAPER (SHADED AREA) IN PDF AND SUBMIT IT TO THE E-LEARNING WEBSITE
Q: Find the distance x in fig below, use the common intensity method as (i= 1200/1+90) x 150 m Sewer 1 Sewer 2 Sewer 3 50 m B Percent Slope Area A 0.44 0.5 B 0.35 2 Sewer D (mm) 1 290 2 410 3 600 0.8 Distance (m) 140 80 d/D 0.3 0.6 V full m/s 1.8 2 1.6
2. During the measurement at the sides of the slope, the data was recorded into three bays, the following information (Table 1.0) was obtained: Table 1.0 Difference in Tension (N) Temperature (°C) Bay Measured Length (m) level between end (m) 1 25.842 19 +0.285 150 27.365 18 -0.236 120 3 21.645 21 -0.239 160 The 30 meter tape used has a mass of 0.400 N/m and a cross-sectional area of 3.00 mm?. It was standardised on the flat at 20 °C under a pull of 100 N, the actual length was 29.995 m during the measuring works. The coefficient of linear expension for the materials of the tape us 0.000015 / °C and Young's Modulus is 20.5 x 104 MN/m?. Calculate the absolute length of survey line in 3 decimal point. Slope correction = -v² 2s Sagging correction = - w²L³ 24P? Tension correction = (P – Ps) EL AE Temperature correction = a (T-Ts) (L)
Round off to Four Decima Places on Final answer only.
18. The angle of elevation of point A, on a pole is measured as 1° and the angle of depression of point B on the same pole is measured as 2°, when measured from a location using a theodolite. Calculate and write the horizontal distance of the pole from the instrument station, if the elevation of point B is 102 m and length of AB is (10+Z) m. Enter your answer take , z = 8
SITUATION VII. In a two-peg test of a dumpy level, the following observations were taken: Rod Reading on A Rod Reading on B Instrument A 1.428 2.034 Instrument B 0.935 1.441 14. What is the difference in elevation between A and B? a. 0.539 m b. 0.556 m c. 0.542 m d. 0.514 m
In the two-peg test method of a dumpy level, the following observations were taken. What is the difference in elevation between A and B in meters? * Instrument near A 1.455 2.341 Instrument near B 0.978 Reading at A Reading at B 1.957 0.933 0.887 0.949 O 0.871
Hello kindly please help me answer this question. Letter D. The other paper attached is for reference of datas