QUESTION 5 In the experiment "Preparation and Standardization of a Sodium Hydroxide Solution", why was the burette rinsed with NaOH before filling it to "zero" for the titration? To remove any residual liquids from the burette To check that the burette works properly To remove any air bubbles and fill the tip of the burette O All of the above

QUESTION 5 In the experiment "Preparation and Standardization of a Sodium Hydroxide Solution", why was the burette rinsed with NaOH before filling it to "zero" for the titration? To remove any residual liquids from the burette To check that the burette works properly To remove any air bubbles and fill the tip of the burette O All of the above

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

QUESTION 12 Which of the following statements is TRUE? A. The end point is the same as the equivalence point B. An indicator is not pH sensitive. C. A titration curve is a plot of pH vs. the [base]/[acid] ratio. D. At the equivalence point, the pH can be greater than, equal to or less than 7. O E. The equivalence point is where the volume of acid equals the volume of base during any acid-base titration.
How do I calculate the number of moles of potassium permanganate used in each titration?
Endpoints in titrimetric procedures employing neutralization reactions are determined by:I. PotentiometerII. Visual Inspection III. Indicators III only II & III I & II I, II & III I & III
Volumetric Analysis In Part A, a drop of the NaOH titrant adheres to the side of the buret (because of a dirty buret) between the initial and final readings for the titration. As a result of the “clean glass” error, how will the calculated molar concentration of the NaOH solution be affected?
A 5.4681 gram sample of beef was analyzed for its N (14g/mole) content and the liberated NH3 was collected in a 99.31 mL of 0.2012 M HCI and 6.28 mL back titration with 0.0120 M NaOH was required. Calculate the percentage protein in the beef sample. (Answers should be written in 2 decimals place and do not include the UNIT)
Use the References to access important values if needed for this question. A 30.0 mL sample of 0.316 M diethylamine, (C₂H5)2NH, is titrated with 0.245 M hydroiodic acid. At the titration midpoint, the pH is Use the Tables link in the References for any equilibrium constants that are required. Submit Answer Retry Entire Group 8 more group attempts remaining Previous Email Instructor Nex Sav
EXPERIMENT 10 PRE-LABORATORY QUESTIONS STANDARDIZATION OF A SODIUM HYDROXIDE SOLUTION NAME DATE 1. What is the purpose of this experiment? 2. A sample of KHP has a mass of 2.345 g is used for a titration, how many moles of KHP is this sample? 3. How many moles of NaOH would be needed to reach the endpoint of this titration with sample of KHP from the previous question? 4. If the initial volume of the NaOH in the burette was 0.50 mL and the final volume is shown to the right, what is the volume of NaOH used in this titration? 19 5. What is the concentration of the NaOH solution used in this titration? EXPERIMENT 10 155
Name: Postlab Questions: 1. A student was performing the test for chloride in his unknown. When he added the five drops of HNO3, he observed bubbles forming (effervescence) in his unknown. Was chloride present in his unknown? How do you know? 2. A student added barium chloride to her unknown and immediately witnessed the formation of a precipitate. She concluded that this white precipitate indicated the presence of chloride ion in her unknown. Is she correct? How do you know? 3. A student has two unlabeled bottles of solution. One contains PO4³¯ and the other SO,?". How can this student identify which is which? Page 6 of 6
1) a)Interpret and explain each region that appears in the titration graph. b)Indicate the color changes and the range in which each indicator is changing the color
1 L - 1 F F D 1 F F C J 7₁ C " I F < 4:32 Question 11 of 13 A) CN and HCN B) CN- What is the primary species in solution at the halfway point in a titration of HCN with KOH? C) HCN and OH- D) OH- all? Tap here or pull up for additional resources Submit
Based on the two graphs , draw conclusions regarding the buffer and water solutions ability to resist changes in pH after the addition of NaOH
During the titration of 50.0mL of 0.1098M HCl using a standardized 0.0750M NaOH solution, what would be the pH of the solution (round off to 2 decimal points) after the addition of: a.) 0.00mL NaOH total volume? b.) 50.0mL NaOH total volume? c.) 75.0mL NaOH total volume? d.) 100.mL NaOH total volume?