Question 4.A skateboarder of mass m approaches a ramp with height H and an incline angle of 0. You may ignorefriction throughout this problem.(a) Draw an FBD for the skater on the ramp.(b) What is the acceleration on the ramp?(c) What is the minimum speed the skateboarder must have at the bottom of the ramp to ensure hereaches the top?(d) Assume he approaches the ramp with a speed greater than the one you found in part (c). How far inthe horizontal direction does he travel after leaving the ramp before landing?

(a) Given: The mass of the skateboarder is m. The height of the ramp is H. The incline angle is θ.…

Answered: Question 4. A skateboarder of mass m…

Similar questions

A girl on a skateboard (total mass of 40 kg) is moving at a speed of 12 m/s at the bottom of a long ramp. The ramp is inclined at 13° with respect to the horizontal. If she travels 13.9 m upward along the ramp before stopping, what is the net frictional force (in N) on her? (Assume the positive direction is upward along the ramp. Indicate the direction with the sign of your answer.)
Problem 10: The speed of a block traveling on a horizontal frictional surface changes from v; =16 m/s to v= 11 m/s in a distance of d = 8.5 m.
A 7.80 g bullet is initially moving at 650 m/s just before it penetrates a tree trunk to a depth of 4.70 cm. (a) What is the magnitude of the average frictional force (in N) that is exerted on the bullet while it is moving through the tree trunk? Use work and energy considerations to obtain your answer. b) Assuming the frictional force is constant, how much time (in s) elapses between the moment the bullet enters the tree trunk and the moment it stops moving?
A 4kg block was released from rest on top of a quarter circular surface. If the vertical height from A to B is given as 4m as shown below, How far from point B will the block reach if the surface A to B is frictionless while B to C has a coefficient of friction of 0.45? answer must be in meters.
Subject :- Physics
rough surfice Smooth Swace feed 2.50m he 3.00m E; Ei + WNc m A 34.2 kg block slides with a velocity of 10.22 m/s to the right on a frictionless surface (as shown in the figure above). The block slides up a slope to a height of 3.00 m and then slides across a 2.50 m long rough surface with a coefficient of kinetic friction equal to 0.325. The block continues to travel to the right and bumps into a massless spring with a spring constant (k) equal to 2320 N/m. a) How much does the spring get compressed by the block with respect to its equilibrium length? Please answer with a positive number in units of metres, with 3 sig figs. Start with conservation of energy: Er = Ei + WNC , and show all steps. b) What is the potential energy stored by the spring when the mass comes to a stop? Please show the symbolic equation and then “plug in the numbers" to give a numerical answer in units of joules with 3 sig figs. c) What happens to the potential energy stored in the spring after the block stops…
A 13.0kg stone slides down an icy, essentially frictionless, hill that is shown in the figure. At the top of the hill, the stone is moving at 1.75m/s down the hill. While the hill is frictionless, the stone experiences friction along the level, rough ground (beyond the base of the hill) all the way to a wall. The coefficients of static and kinetic friction are 0.800 and 0.300 respectively. The stone slides along the ground for 9.15m before making contact with a long spring, which has a spring constant of 25.0N/m. (“Long” in this case means that the spring is sufficiently long to stop the stone before it hits the wall.) Will the stone move again after it has been stopped by the spring?
Please use conservation of energy (kinetic and gravitational potential energy) to solve this problem. A 1.5-kg block initially at rest at the top of a 3-m incline with a slope of 30° begins to slide down the incline. The upper half of the incline is frictionless, while the lower half is rough, with a coefficient of kinetic friction μk = 0.3. (a) How fast is the block moving midway along the incline, before entering the rough section? (b) How fast is the block moving at the bottom of the incline?
A 4.25 kg block is projected at 5.40 m/s up a plane that is inclined at 30.0° with the horizontal. The block slides some distance up the incline, stops turns around and slides back down to the bottom. When it reaches the bottom of the incline again, it is traveling with a speed of 3.80 m/s. If the coefficient of kinetic friction between the block and the plane is 0.500, how far up the incline did the block slide?
7.43 - A 2.0-kg piece of Figure P7.43 wood slides on a curved surface Wood (Fig. P7.43). The sides of the surface are perfectly smooth, but the rough horizontal bottom is 30 m long and has a kinetic friction coefficient of 0.20 with the wood. The piece of wood starts from rest 4.0 m above the rough bottom. (a) Where will this wood eventually come to rest? (b) For the motion from the initial release until the piece of wood comes to rest, what is the total amount of work done by friction? Rough bottom
A penguin slides down an icy incline on his stomach, as shown in the diagram below. The coefficient of kinetic friction between the incline and the penguin's stomach is 0.15. The angle of the incline is 0 = 25 degrees. The total distance down the incline is 25 meters. The penguin gets a running start so his speed is 2.5 m/s when he begins to slide down the incline. What is the penguin's speed when he reaches the bottom of the incline? Hint: use Newton's 2nd law to calculate the acceleration of the penguin on the incline, then use kinematic equations to calculate the speed of the penguin when he reaches the bottom. 2.5 m/s 25 m 25°
Calculate the force needed to bring a 900 kg car to rest from a speed of 90.0 km/h in a distance of 110 m (a fairly typical distance for a nonpanic stop).N(b) Suppose instead the car hits a concrete abutment at full speed and is brought to a stop in 2.00 m. Calculate the force exerted on the car and compare it with the force found in part (a), i.e. find the ratio of the force in part(b) to the force in part(a).(force in part (b) / force in part (a))

SEE MORE QUESTIONS

Question 4. A skateboarder of mass m approaches a ramp with height H and an incline angle of 0. You may ignore friction throughout this problem.