Question 3. The two parallel loads in the figure shown below are as follows. Load 1 absorbs 24 kW and 12 kVAr and Load 2 consists of a 60 ohms resistor in parallel with a capacitive reactance of 480 ohms. 1. Determine the rms magnitude of the generator voltage Vg if the load voltage Vo is 2,400 volts rms. 2. With Vo as the reference, draw a phasor diagram of the system voltages. V + j10 N + V₁, L₁ 1₂ S

Question 3. The two parallel loads in the figure shown below are as follows. Load 1 absorbs 24 kW and 12 kVAr and Load 2 consists of a 60 ohms resistor in parallel with a capacitive reactance of 480 ohms. 1. Determine the rms magnitude of the generator voltage Vg if the load voltage Vo is 2,400 volts rms. 2. With Vo as the reference, draw a phasor diagram of the system voltages. V + j10 N + V₁, L₁ 1₂ S

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.14MCQ: The instantaneous power absorbed by the load in a single-phase ac circuit, for a general R LC load...

See similar textbooks

Similar questions

A single-phase, 120V(rms),60Hz source supplies power to a series R-L circuit consisting of R=10 and L=40mH. (a) Determine the power factor of the circuit and state whether it is lagging or leading. (b) Determine the real and reactive power absorbed by the load. (c) Calculate the peak magnetic energy Wint stored in the inductor by using the expression Wint=L(Irms)2 and check whether the reactive power Q=Wint is satisfied. (Note: The instantaneous magnetic energy storage fluctuates between zero and the peak energy. This energy must be sent twice each cycle to the load from the source by means of reactive power flows.)
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020°, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.332Z –120° A (C) 0.9962-120° A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
Q2. For the circuit shown below, sketch the current waveforms is and io and determine the Average and RMS for both currents. a = 50° T1 50 2 ot Vs = 300 sin 100rt T2 ot
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
Hi, Help me with this circuit question
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three-phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT
A three phase load has a rating of 200 KW, 4000 volts, 0.7 power factor lagging and a frequency of 50 Hz. Determine the required capacitor bank rating in micro Farad per phase to improve its power factor to 0.9 lagging if: a) The capacitor bank is to be connected in Delta. b) The capacitor bank is to be connected in Star.
15) Kirchhoff's Voltage Law (KVL) states that A) the product of the phasor voltages around any closed path must equal zero. B) the sum of the phasor voltages around any closed path does not have to equal zero. C) the sum of the phasor voltages around any closed path must equal zero. D) the sum of the phasor voltages around a closed path cannot include "through the air."
An 11 KV generating station has four identical 3-phase alternators A,B,C and D and each of 10 MVA and 12% reactance. There are two sections of bus-bar, P and O linked by a reactor rated at connected to bus-bar section MVA with 24% reactance. Alternators A and B are and alternators C and D to bus-bar section Q. From each section, load is taken through a number of 6 MVA, 11/66KV step-up transformers, each having a reactance of 3%. Calculate the current fed into a fault if a short-circuit occurs on all phases near the high-voltage terminals of one of the transformers at the bus-bar section Q. 10 MVA 10 MVA 12% 11 11 KV 10 MVA 24% -000000 10 MVA 12% o Q 10 MVA 12% 0 11 KV 6 MVA WWW 3% /www
A star connected three phase alternator supplies power to a delta connected resistive load. The alternator has a line voltage of 480V. Each resistor of delta load has 8 ohm of resistance. Find the following values. Line voltage of the load (VL(load)) Phase voltage of the load (VP(load)) Phase current of the load (IP(load)) Line current delivered by the alternator (IL(alt)) Phase current of the alternator (IP(Alt)) Phase voltage of the alternator (VP(Alt)) True power
8. The total power supplied to a balance delta load is found in the same way as for a balance wye load. True False Either Neither 12. A load of 20 + j35 ohms is connected across a 220 V, 60 Hz supply. Find the reactive power of the load in var. 595 2420 1042 1382 13. A type of DC source where the characteristic output voltage has perfect unidirectional waveform and is based on electrochemical principle. Generator Inverter Converter Battery 14. Calculate the Rf of a circuit whose impedance is 20+j35 and current of 2A. 0.86 0.91 0.50 0.71 15. What capacitor shall be installed in parallel with a circuit to achieve a unity power factor if the reactive power of a circuit is 200VARS and the voltage is 100V. 80.45 microfarad 53.05 microfarad It's already in unity 62.45 microfarad
A 50 cycles, 3 phase alternator with grounded neutral has inductance of 1.6 mH per phase and is connected to busbar through a circuit breaker. The capacitance to earth between the alternator and circuit breaker is 0.003 uF per phase. The circuit breaker opens when rms value of current is 7500 A. Determine the following: i) Maximum rate of rise of restriking voltage. 1) Time for maximum rate of rise of restriking voltage. in) Frequency of oscillations