Question 3 Water flows through a 5 cm diameter pipe with a velocity of 4.5 m/s as shown in Figure Q3. The relative roughness of the pipe is 0.004 and the loss coefficient for the exit is 1.0. The dynamics viscosity of water is 1.12x10³ N.s/m². (a) Write a balanced energy equation. (b) Calculate the Reynold number in the water pipe, (c) Determine the friction factor, and (d) Determine the height, h, to which the water rises in the piezometer tube, in m. 4.5 m/s Open 5 cm 2.5 m TL 2.5 m

Question 3 Water flows through a 5 cm diameter pipe with a velocity of 4.5 m/s as shown in Figure Q3. The relative roughness of the pipe is 0.004 and the loss coefficient for the exit is 1.0. The dynamics viscosity of water is 1.12x10³ N.s/m². (a) Write a balanced energy equation. (b) Calculate the Reynold number in the water pipe, (c) Determine the friction factor, and (d) Determine the height, h, to which the water rises in the piezometer tube, in m. 4.5 m/s Open 5 cm 2.5 m TL 2.5 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

On a single plot, plot three curves that show the relationship between the pressure generated by thepump as a function of flow rate of water at 20 °C through the three branches of the piping systemshown below. Delta P on y axis and flow rate on the x axis. The pressure range is 0 to 1 MPa. (Branches 1 and 3 are in the same plane; branch 2 is located 5 m above the other two branches. Pipe inner diameter: 0.0254 mPipe material: copperTypical mass flow rate of interest: 0.5 kg/sIgnore minor losses of tee's at points A and B and any features of branch 3Consider minor losses of two 90° elbows in branch 2
3. Theoretical Analysis: [With reference to the Bernoulli and Continuity equations, provide a theoretical analysis of how flowrate can be calculated for a level venturi tube. Label each equation in the theoretical analysis with a number. Explain the steps as per the start given below...] As applied to a pipeline, Bernoulli's equation can be stated as follows: P2 -++ Z1 P1 v? +Z2 (1) Pg 2g Pg 2g I. where the subscripts refer to stations 1 &2 respectively. In this case the elevation head is the same for both stations since the venturi tube is horizontal therefore the Z terms in the above equation can be omitted, giving: 二

In mechanical fluid
ASAP pls (pipes same height and plane)
Show complete solution with diagram: A 3.81-cm diameter venturi meter is installed in a pipe with an internal diameter of 10.23 cm. A 127 cm manometer filled with mercury is used to measure the pressure difference across the venturi meter. If the manometer reads 101.6 cm when 15 °C water is flowing through the pipe, what is the flow rate of water (m3/min)? Assume that the venturi meter coefficient of discharge equals 0.98.
(Q29) A horizontal pipe of diameter 550 mm is suddenly contracted to a diameter of 300 mm. The pressure intensity in large pipe is given as 14 N/cm2 and the flow velocity in the larger pipe is 2 m/s. Find:- (a) The rate of flow of water through a horizontal pipe. (b) Loss of head due to sudden contraction. (c) Pressure intensity in smaller pipe.
Apply Bernoulli equation in solving the problem: A 3.81-cm diameter venturi meter is installed in a pipe with an internal diameter of 10.23 cm. A 127 cm manometer filled with mercury is used to measure the pressure difference across the venturi meter. If the manometer reads 101.6 cm when 15 °C water is flowing through the pipe, what is the flow rate of water (m3/min)? Assume that the venturi meter coefficient of discharge equals 0.98.
I want full solution, this is one question only if u can't solve them all handwritten then I suggest u to skip, I'll upvote
Initially, a tank contains 3m^3 of salt-free water.A stream enters into the tank at a constant flow rate of 0.04 m3 per second with a 30 kg/m3 salt concentration. A stream leaves at a constant rate of 0.03 m^3 per second. The tank is well stirred.Find the amount of salt (kg) in the tank when the volume of the salt solution is 6 m ^3 That is a fluid mechanics homework question, I need your help immediately. Thank you
G1/ In the fig.shown, the Flow rate Pipe (A) is equal ( QA = 25 Lit15), the diameter is equal ( DA = 75 mm, D, = De = Dc =30mm), and the velocity in Pipe (D) is equal (Uo=5 m/s), the relation between flow rate in in 6o mm, Pipe (B) and pipe (c) GB =3 Qc. Find the Value of '. Re, Qc, Qo. 2- UA, UB, Uc: Pe = 30 mm water Pc = 30mm imput QA = 25 2i+/sec OA= 75 mm = 6o mm input = A outPut = B, C, D accumulation = o.
Water is pumped into a fire hose through a 6 cm diameter pipe with speed 1m/s. The water in the fire hose flows with a pressure of 200000 Pa. At the end of the fire hose is a nozzle (small hole). The pressure decreases to atmospheric pressure (101300 Pa) when the water leaves the nozzle from the hose. There is no change in height moving from the hose to the nozzle. 1. What is the water speed in a 4 cm diameter fire hose? 2. What is the velocity of the water exiting the nozzle (p=1000kg/m³)? 4. What is the diameter of the nozzle? 3. A Fireworker now connects an additional flexible tube to the nozzle (tube and nozzle has same diameter). He lifts the tube to a height of 1 meter above the ground. At what speed does the water come out of the tube? (hint - the pressure at the exit is still atmospheric)
A long pipeline carries 75.0 cfs of water from reservoir 1 to junction J, where it is distributed into pipes 2 and 3 and transported to reservoirs 2 and 3. Determine the surface elevation of reservoir 3, given the following: WS elevation R₁ = 3200 ft R₂ = 3130 ft R3 =? Pipes 1 2 3 Length 8,000 ft 2,000 ft 3,000 ft Use Hazen-William's coefficient of 150 for all pipes. Note: WS- Water surface R - reservoir Diameter 3.0 ft 2.5 ft 2.0 ft