Question 3: Consider a cylindrical Tank of Height X as shown in the figure below. The tank consists of TWO outlets from where the water is drained into a sink. The total time required to empty the full tank by opening both the outlets is 1 day. Determine X. Assume that the ratio of the diameter of the cross section of tower to the diameter of the jet (both identical) is 235.0. X Jet2 v² = 2gh V→ Average of jer Diameter & Tank THER •Diameter of jel EXAM Jet 1 J velocity

Q: Air at atmospheric pressure flows across a staggered tube bank consisting of 8 rows of tubes in the…

A:

Q: 4. Rework inviscid flow past a cylinder in terms of the stream function y.

A: The inviscid flow past a cylinder in terms of stream function is to be mentioned.

Q: Q6: Water flows under the inclined sluice gate shown in Fig. P3.6.103. Determine the flowrate if the…

A: Flowrate of the water is asked.

Q: An oil-water mixture is separated in a decanter. The properties of oil and water are summarized in…

A: For oil,For water,

Q: 7) Water is flowing upward at 1.676 m/s through a vertical piping system consisting of 3" sch40…

A:

Q: 2. Air at 50°C and essentially atmospheric pressure is flowing through a 10 cm x 10 cm rectangular…

A: Given that- Length of duct, L=50 m Average velocity, vavg=10 m/s Wall temperature, Ts=250C…

Q: A glass tube is attached to a water pipe, as shown in Fig. 1. If the water pressure at the bottom of…

A: Pressure at the bottom of the tube, P = 115 kPa = 115000 Pa Local atmospheric pressure, Patm = 92…

Q: sider a U-tube whose arms are open to the atmo one arm and light oil (poil = 790 kg/m³) from the…

A:

Q: 1. An incompressible Newtonian liquid is in steady laminar flow in a slit formed by two parallel…

A: The given diagram for the flow of fluid in a slit is: Given conditions of the flow: The flow is…

Q: 1) Consider the infinitely tall, annular mixing tank. The fluid to be mixed is between the inner…

A: Given: Fluid is mixing in an annulus between inner cylinder and outer wall Inner cylinder angular…

Q: 8. Oil flows in the pipe shown in figure. The orifice in the pipe has a coefficient of discharge of…

A: The orifice meter is a flow measuring device. The difference in pressure gives the flow rate of the…

Q: Chapter 5: Water (density is 1000 kg/m) is in the cylindrical tank. When the valve at B is 1)…

A: In fluid mechanics, according to Swiss mathematician and physicist Daniel Bernoulli, the total fluid…

Q: Q4: A diffuser, has air entering at 100 kPa, 280 K, with a velocity of 200 m/s. The inlet…

A:

Q: Water is in steady fully developed laminar flow between two horizontal, very wide (W) and long (L)…

A:

Q: Water is siphoned from a tank from which a barometer provides a reading of 30.2 feet. De- termine…

A: Given data: Barometer reading = 30.2 ft Diameter of the pipe = 3 in

Q: Q3) When the valve is closed, the pressure throughout the horizontal pipe shown in Fig. P8.60 is 400…

A:

Q: 5.40. The tank in Fig. 5.33 is cylindrical and has a vertical axis. Its horizontal cross-sectional…

A:

Q: 2) A cylinder holds 200 kg of water at 120 °C at a pressure of 20 MPa. The temperature is increased…

A:

Q: A water pipe is connected to a double-U manometer as shown in Figure below at a location where the…

A:

Q: The wastewater treatment process at a polymer plant consists of a longitudinal bio-remediation pond…

A:

Q: Water is siphoned from the tank shown in the Figure below. The water barometer indicates a reading…

A: Given data: Barometer reading = 30.2 ft Diameter of the pipe = 3 in