Question 2 MN is the last two digits of your student number. 180100555- In an analog measurement operation set as an external reference, the reference source of the ADC is a voltage source of 5.5Volts. In case of 3.5V voltage to the analog input, write the decimal value of the value that will occur at the ADC output. (ADC is 12 bit) 0160 100565-6 g160 100555- 44 g160100556

Q: Design*/draw a 10-second timer using a  555 IC  (Astable)  with correct values of R1-2  and C. and…

A: Absolutely, here's the design for a 10-second timer using a 555 timer IC (astable) with component…

Q: For a full wave rectifier, when input frequency if 60HZ, output frequency is

A:

Q: Determine the peak input voltage (Vpim), peak output voltage (Vp(out)), the average voltage (Vavc)…

A: A bridge type full-wave rectifier is used to convert the AC input voltage into a DC Output voltage…

Q: Question 8: Determine the decimal values of the following unsigned numbers: (a) (0111011110)2 (b)…

A: In this question , we will find decimal equivalent ..

Q: Determine the ripple factor for the filtered rectifier circuit below when RL= 4KN. Then explain…

A: In the circuit,  Full wave bridge rectifier is given.  Find the ripple factor?  R and C are given.

Q: Convert each of the following two complements to Decimal. 101010 010001 011110 101001

A: in this answer we will try to find the decimal equivalents of the given 2's complements as shown…

Q: Which one of the following semiconductor device is used for high frequency and low power application…

A: Which one of the following semiconductor device is used for high frequency and low power…

Q: In a full wave bridge rectifier, the input sine wave is 40sin100nt. What will be the average output…

A: given in a full wave bridge rectifier , the input sine wave is 40 sin 100πt .here we have to find…

Q: Create a sequence detector that detects the sequence 1001 or 0110 by using Verilog Code. Construct…

A: Detects the sequence 1001 or 0110 by using Verilog code.

Q: 1) The following is not an example of a Thyristor a) A Silicon Unilateral Switch b) A TRIAC c) A…

A:

Q: Draw the input waveform and output waveform for the circuit given below with proper values marked in…

A: Note The voltage polirity of voltage source V2 must be reversed otherwise question will be wrong…

Q: 1.2 Convert to octal. Convert to hexadecimal. Then convert both of your answers to decimal, and…

A: Convert to Octal ,  convert to hexa decimal convert both answer to decimal and verifya) 1 1 1 0 1 0…

Code Conversion

The method or technique used to convert code from one format to another is termed code conversion. Code conversions are most commonly used in computers, digital electronics, microprocessors, etc.