Answered: Question 2 : Block B slides down the… | bartleby

Related questions

Question

Question 2
: Block B slides down the rough
surface, while pulling block A to the right. If both blocks
are initially at rest and the spring is initially unstretched,
determine:
a. Velocity of A, after B slides down a distance
d=0.5m
b. Maximum distance "d" block B slides down
before stopping
K=300N/m
A
10kg
Note: Spring is attached to A
H=0,2
B
50kg
3
d

Expert Solution

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

In the given figure block is held at rest such that spring is in natural length, now block is released. Find maximum speed (in m/s) of block during the motion. (Take 10 = 3.16). %3D k = 20 N/m m 2kg 000000000000
o Harry is designing the crumple zones in a new car. He decides to model the front end of the car as a spring. If he wants it to bring the car (mass m) to rest from an initial velocity to without the passengers experiencing an acceleration of more than ama, what spring constant should he use? mal amla
16. A mass is sitting on a frictionless table and attached to one end of a spring. The spring Is horizontal and the other end of the spring is attached to a wall. The spring is initially at its natural length. I give the mass a very quick push, giving it an initial velocity vo away from the wall, as shown in the diagram below. Wall Spro The mass moves away from the wall and then back towards the wall as the spring stretches and then recoils. What is the direction of the net force on the mass in the middle of this motion, when it is instantaneously stopped, just before moving back towards the wall? A) Zero net force B) Horizontal towards the wall C) Horizontal away from the wall Đ) Vertically downwards E) Vertically upwards
A 4 kg object is released from rest from a height of 1.2 m above a vertical spring (initially in its natural state). The object strikes the top end of the spring compressing it at distance of 0.6 m. Find the spring's force constant. A.) 261.33 N/m B.) 366.25 N/m C.) 480.00 N/m D.) 164.64
Question 6) Consider the following graph. (cm) Elongation of a spring as a function noitesu of the exterior force applied to it 20 According to the graph, what is the spring constant of the spring? 16 12 8. A) 1.0 N/m B) 2.0 N/m 6. 8. 10 C) 5.0 N/m F D) 50 N/m 4- 2. 4-
2. Construct a problem where a mass is sitting on top of a spring inside an elevator; both are suspended by a rope and are uniformly accelerating upwards with magnitude 4 meters per second squared. Specify all the masses in the problem, as well as all the forces acting in the problem, and their relative directions.
3. Before: mi vi After: m2 Ax (mm) I coul m₁+m2 a) Measurements on a spring reveal that a force of 0.75 N will compress the spring by 0.25 cm. Find the spring constant of this spring, k. b) This spring is now mounted horizontally with a block of wood attached to one end. A bullet with mass m₁=0.008 kg and velocity v, is fired horizontally into the block of wood. The wood block has mass m₂=0.992 kg and is initially at rest. The bullet embeds itself in the wood and the spring is compressed by 2 cm before it comes to rest momentarily. c) Find the velocity of the block/bullet combination directly after the collision needed to compress this spring by Ax=2 cm. d) Find the initial velocity of the bullet before the collision, V₁. Hint: Is the collision elastic or inelastic?
A mass of 0.12 kg is sliding on a frictionless horizontal surface when it comes to a horizontal spring with Hooke’s constant k = 90 N/m. The mass is moving at 15 m/s. How far does the spring compress? What is the acceleration of the mass when the spring is fully compressed? How much time elapses between when the mass first encounters the spring, and when the spring reaches full compression? a.) Set up and solve for maximum compression distance. b.) Set up and solve for acceleration at maximum compression. c.) Set up and solve for the time to maximum compression.