Answered: Question 10.8: A hydraulic automobile… | bartleby

Related questions

Question

Un well in the can.
Question 10.8:
A hydraulic automobile lift is designed to lift cars with a maximum mass of 3000 kg. The
area of cross-section of the piston carrying the load is 425 cm². What maximum pressure
would the smaller piston have to bear?

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A force of F1 = 374 N is applied to a hydraulic jack pump piston with a diameter of D1 = 0.0192 m. What is the magnitude of the output force F2 (in N) if the lifting piston has a diameter of D2 = 0.124 m
Many cities have water tanks raised high off the ground to produce pressure for their residence. If one such water tank had a diameter of 4.40 m and its water level being 20.7 m above the ground. What would be the pressure at ground level if the water was not being used? (static)If at ground level a faucet had an opening with a diameter of 2.00 cm, how fast would the water come out of the faucet?
A certain hydraulic system is designed to exert a force 405 times as large as the one put into it. (a) What must be the ratio of the area of the slave cylinder to the area of the master cylinder? (b) What must be the ratio of their diameters? (c) By what factor is the distance through which the output force moves reduced relative to the distance through which the input force moves? Assume no losses to friction.
Water (density equal to 1000 kg/m³) flows through a system of pipes that goes up a step. The water pressure is 140 kPa at the bottom of the step (point 1), the cross-sectional area of the pipe at the top of the step (point 2) is half that at the bottom of the step and the speed of the water at the bottom of the step is 1.20 m/s. The pressure at the top of the step is 120 kPa. Find the value of the height h? h
A hydraulic lift is designed with an output cylinder that has 36 X the area of the input cylinder. If a force F is applied to the input cylinder, the output cylinder can supply a force equal to _______.
Chapter 37, Problem 012 The length of a spaceship is measured to be exactly 1/2 its rest length. (a) What is the speed parameter ß of the spaceship relative to the observer's frame? (b) By what integer factor do the spaceship's clocks run slow, compared to clocks in the observer's frame? (a) Number Units (b) Number Units
A hydraulic car lift has an input piston of radius 2.9 cm and negligible weight. The output piston has a radius of 67 cm. If you push in on the input piston with a force of 200 N, how much pressure are you applying to the system? What force will be transferred into the output piston?
A hydraulic jack piston has a diameter of 0.06 m. The hydraulic jack is connected to another piston that supports the load. The support load piston has a diameter of 0.50 m. If the jack can lift a mass up to 2500 kg, what is the maximum force that one needs to apply to the piston in order to lift the given mass?
In the hydraulic system shown in the figure (see below) the piston on the left has a diameter of 5.2 cm and a mass of 2.0kg. The piston on the right has a diameter of 15 cm and a mass of 3.6 kg. If the density of the fluid is 700 kg/m^3, what is the height difference h between the two pistons?
The small piston of a hydraulic lift (see figure below) has a radius of r1= 1.00 cm, and its large piston has a radius of r2=9.45 cm. What downward force of magnitude F1 must be applied to the small piston for the lift to raise a load of mass 1500 kg? Answer: N.