Quest- A single phase 50 Hz, system supplies an inductive load of 5000 kw at power factor 0.8 lag through a line 25 km. Resistance of the line is 0.0195 2/km and inductance = 0.36 mH/km, receiving end voltage is 10 kV. A capacitor is connected across the load to get the voltage regulation of 10%. Ratio of transmission line loss with and without shunt capacitor is

Quest- A single phase 50 Hz, system supplies an inductive load of 5000 kw at power factor 0.8 lag through a line 25 km. Resistance of the line is 0.0195 2/km and inductance = 0.36 mH/km, receiving end voltage is 10 kV. A capacitor is connected across the load to get the voltage regulation of 10%. Ratio of transmission line loss with and without shunt capacitor is

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.13MCQ

See similar textbooks

Related questions

Q: 9.24 A three-phase, 60-Hz transmission line is completely transposed. The separation distances…

Q: 1) A 60-Hz, ...-km, three-phase overhead transmission line has a series impedance z = 0.8431L79.04…

Q: Example 8.11. Each line of a 3-phase system is suspended by a string of 3 indentical insulators of…

Q: (a) The base impedance in (N) (b) The reactive power drawn by the load (p.u.) (c) The total current…

Q: The impedance per phase of 3-phase transmission line on a base of 100 MVA, 100 kV is 2 pu. Find the…

A: Given- 3-phase transmission line- MVAnew=400,MVAold=100,kVold=100,kVnew=400,Zold (pu). To Find- The…

Q: Problem 6- A Three-phase 60 Hz transmission line has its conductors arranged in a triangular…

A: we need to find GMD and radius of conductor to calculate the required parameters.

Q: Write a report on the Star connection for three phase load experiment using the data/results from…

Q: 2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation

Q: Q5 (Large Single Phase Resistive load connected to 3 phase supply) Single Phase Resistive Load eg…

A: Given A large single phase load of Resistance = 0.25 ohm is to be connected to a three phase…

Q: A 220 kV, three phase transmission line is 50 km long. The resistance per phase is r 2 per km and…

Q: 60 Hz three-phase transmission line, Each single phase transmission line consists of two hard-drawn…

Q: Analyse the methods that improve the power factor of a electrical circuit.

A: In electrical engineering, the power factor of an AC electrical system is determined as that of the…

Question

Quest-
A single phase 50 Hz, system supplies an inductive load of 5000 kw at power factor 0.8
lag through a line 25 km. Resistance of the line is 0.0195 2/km and inductance = 0.36
mH/km, receiving end voltage is 10 kV. A capacitor is connected across the load to get
the voltage regulation of 10%. Ratio of transmission line loss with and without shunt
capacitor is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data-

VIEW

Step 2: Calculation-

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
Consider the 500 kV, three phase bundled conductor line as shown in the figure below. Find the line to neutral capacitance. 0.5 m 30 mm (0) (O to Ine 15 m 15 m
Schering Bridge is used to find ____________. a. capacitance b. pressure c. inductance d. frequency
6.8. A three phase, 50 Hz, 100 km transmission line has resistance 0.1 ohms/km, inductance 111.7 mH/km and capacitance 0.9954 x 10- uF/ph per km. The line is delivering 20 MW at a 0.8 power factor lagging and 66 kV to a balanced load. Determine the efficiency and regulation. Use nominal it method. Ans. n= 93.5%, VR = 17.47%
Subject - Design electrical circuits for single-phase AC networks Question - Compare the effect of varying resistance, capacitance and inductance in parallel and series AC circuits on voltage, resistance and impedance
In nominal-T method of medium transmission line what is the assumption about the capacitance
For transferring electrical power at 220 kV, six conductors of ACSR Drake constitute a 60Hz double circuit three phase line arranged as shown below. The vertical spacing between consecutive conductors is 14ft; the longer horizontal distance is 32ft whereas the shorter horizontal distance is 25ft. a. Find the inductance per phase per mile and the inductive reactance per phase in ohms per mile. b. Find the capacitive reactance to neutral in ohm-miles. c. Find the resistance per phase per mile in ohms per miles. d. If the length of the line is 90 miles then draw an equivalent circuit of the line and analyse the open circuit and short circuit performance of the line. e. Find the maximum power we can transmit over the line. f. If the line is delivering power to a load of 20MW at 0.8 power factor lagging then find the voltage at the receiving end of the line. Also, Determine the voltage regulation, losses and efficiency of the line. g. If a fixed shunt compensation of 3 MVAr is attached at…
Please provide Handwritten answer
GMR calculate
A three-phase, 60-Hz, untransposed transmission line runs in parallel with a telephone line for 20 km. The power line carries a balanced three-phase rms current of Ia = 3202 – 240°A. The line configuration is as shown in figure. Assume zero current flows in the ungrounded telephone wires. Find the magnitude of the voltage induced in the telephone line. = 32020°A, Ī, = 3204–120°A, and a 4 m 4 m 5 m d G2 mO
A single phase 50 Hz generator supplies an inductive load of 5,000 kW at a power factor of 0.707 lagging by means of an over head transmission line 20 km long. The line resistance and inductance are 0.0195 ohm and 0.63 mH per km. The voltage at the receiving is required to be kept constant at 10 kV Q1. the sending end voltage and voltage regulation of line Q2. the value of the capacitor to be placed in parallel with the load such that the regulation is requced to 50 % of that obtained in Q1 Q3. compare the transmission efficiency in parts of Q1 & Q2.
In power distribution systems, what is sometimes necessary to install to reduce harmonic frequencies and distortion between the three-phase transformers and distribution panels?