QI. A hydroelectric station has a cubic tank of height 50m above the earth. This cubic tank has an equal part of 35m. The maximum height of water in the tank is 25m for one day and the minimum height of water in the tank is 5m for one day also. The efficiency of the station is 0.9. Find 1. The power that developed by the station. 2. The maximum power that developed by the station. 3. The maximum power that could be developed by the : 35m 25m Sm S0m earth COOL

QI. A hydroelectric station has a cubic tank of height 50m above the earth. This cubic tank has an equal part of 35m. The maximum height of water in the tank is 25m for one day and the minimum height of water in the tank is 5m for one day also. The efficiency of the station is 0.9. Find 1. The power that developed by the station. 2. The maximum power that developed by the station. 3. The maximum power that could be developed by the : 35m 25m Sm S0m earth COOL

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A piston of mass 2 kg is lowered 0.5 m in the standard gravitational field. Find the required force and the work involved in the process.
A car engine releases 325J of heat and pushing the piston doing 400J of work. Does the sytem gained or lost energy? By how much?
A container maintains a constant pressure of 86300 Pa and volume of 116 liters while 49960 J of heat is added. How much work is done by the gas? *
Thermodynamics
3. In figure, a carton box weighing 5.5 kg is lifted up through a height of 380 mm by a cylinder “A”. Then it is pushed on to a conveyor by a cylinder “B”. The pushing distance is 460 mm. Compressed air is available for this facility at 80 N/cm^2.Find the diameter of the cylinder “A” required to perform thisfunction.(Note: Consider material handling cylinder as ‘A’ and box pushing cylinder as ‘B’).
However a gas does a differential amount of work δWb as it forces the piston to move by a differential amount ds.
A windmill produces 5 kW and is connected to a battery to charge it. The batterydue to resistive heating loses heat at a constant rate of 2 kW. Find the stored energyin the battery after 2 hours?
8. A wind turbine receives air at 50kph and receives energy from it then the flowmeter behind it reads 10kph. Assuming no change in internal energy of the air, find the specific work in J/kg that the turbine will receive assuming no losses in friction.
A water pump increases the water pressure from 15 psia to 90 psia. Determine the powerinput required (hp), to pump 2 ft3/s of water. Neglect potential, heat, kinetic energychanges.
(2.) Steam enters a turbine with an enthalpy of 1292Btu/lb and leaves with an enthalpy of 1098 Btu/lb. The transferred heat is 13 Btu/lb. what is the work in kW and in hp for a flow of 2 lb/sec? draw a figure also, and explain each step by step solution.
Steam enters a turbine at a mass flow of 1.4 kg/s, a pressure of 700 kPa and a temperature of 400 °C. Steam, 100 kPa pressure and 1.4 m3 / kg specific volume it comes out of the turbine. Heat transfer from the turbine to the environment is 50 kW, since the boundary temperature between the turbine and the environment is 70 °C, a) find the power generated by the turbine. b) calculate the entropy produced in the turbine. c) find the Isanthropic efficiency of the turbine. Note: changes in kinetic and potential energies will be neglected and T (k) = 273 + °C will be.
Q2. From the following figure; 400 power, kw L 200 0 12 8 Time, hr 1. 2. What will be the highest power value for this project? ( What will be the total rated output? (