QI: In a venturemeter used for measuring the flow of oil (S = 0.85) through a horizontal pipeline, the pipe diameter is 2.4 times the diameter at the throat. Connections are made from the entrance to the meter and the throat to a vertical U tube containing mercury. If the difference level between the fluids in the U-tube arms is (x +) in cm, where S.N. is student serial number. Neglect friction in the pipe. Find an expression in terms of x for the velocity of the oil in the pipe. Throat Area, A ON, S-035 Manometer - Mercury

QI: In a venturemeter used for measuring the flow of oil (S = 0.85) through a horizontal pipeline, the pipe diameter is 2.4 times the diameter at the throat. Connections are made from the entrance to the meter and the throat to a vertical U tube containing mercury. If the difference level between the fluids in the U-tube arms is (x +) in cm, where S.N. is student serial number. Neglect friction in the pipe. Find an expression in terms of x for the velocity of the oil in the pipe. Throat Area, A ON, S-035 Manometer - Mercury

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

b) A 3 cm orifice plate is placed within a 4 cm pipe in which methanol at 20 °C (SG = 0.7884 and dynamic viscosity (µ) = 0.5857 cP) is flowing through. If the flow rate passing through the pipe is 3.1 litres per seconds, determine the pressure difference that must be measured around the orifice plate. The discharge coefficient of the orifice can be calculated by: 91.71B2.5 Ca = 0.5959 + 0.0312B2.1 – 0.184ß® + Re0.75 Where, B is the ratio of orifice diameter to pipe diameter and Re is the Reynolds number.
Water flows through a horizontal pipe of cross sectional of 20 cm2. Atone section, the cross sectional area is 4 cm2. the pressure difference is29.4 psi. How many cubic meters of water will flow out of the pipe in 1min? (can you show the diagram or illustration if possible. thank you!) Choices: a. 0.008 b. 1.208 c. 0.493 d. 0.0185
Completely solve and box the final answers. Write legibly 9. A blower with the inlet open to the atmosphere delivers 250 cubic meters per minute of air at a pressure of 2.50 cm of water gage through a duct 25 cm in diameter, the manometer being attached to the discharge duct at the blower. Air temperature is 25 degrees C and the barometer pressure reads 1.025 bar. Calculate the required motor rating in KW if the blower efficiency is 92.5%
Kindly answer correctly. Please show the necessary steps. Thank you so much
A Pitot-static probe was used to measure the velocity distribution in a water tunnel. The two pressure lines from the probe were connected to a U-tube manometer which uses a liquid of specific gravity 1.7. The maximum velocity expected in the water tunnel was 2.3 m/s. Your job was to select an appropriate U-tube from a manufacturer which supplies manometers of different heights. The cost increases significantly with manometer height. Which of these should you purchase?
Q 2 please
I need the answer as soon as possible
%3D Find the pressure in KN/m2 at the center of pipe A. T = 10°C. Oil (S = 0.85) Water 90 cm 150 cm Water 30 cm Mercury (S = 13.6) to 30 cm