QI) Find the resultant of the two forces acting on the bent bar as shown in figure (1)? F3 kN 30 P-7 AN 45 Figure (1)

Q: The three concurrent force acting in the beam can be replaced with a single force , R, compute the…

A: This is a problem regarding the resultant of forces. The figure for the problem can be given as: The…

Q: Obtain the resultant of the six forces acting on the sides of a hexagon. Each side measures 125 mm.

A:

Q: a) Why does any person lean towards right while carrying a bag in her left hand?

A: When all the forces acting on the body are balanced, the body acquires the state of equilibrium.…

Q: 6) The upper leg muscle (quadriceps) exerts a force of Fo = 1120 N, which is carried by a tendon…

A:

Q: AF-S KN force is applied on steel pipes in -z axis direction. According to connection coordinates of…

A: Answer:   TAD = -4. 64 kN,  TBD = -4. 32 kN,  TCD =-4.55 kN

Q: 140 N 14m 40 N 240 N 3. Determine the resultant of the three forces acting on the pulley shown.

A: Resultant of the forces is the vector sum of forces acting in x and y direction .

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown,…

A: Given, The resultant force of three forces is vertically downward with a magnitude of 1390 lb

Q: The figure below shows a claw hammer being used to pull a nail out of a horizontal board where 0 =…

A:

Q: Three forces F, = 20 N, F, = 10 N and F, = 5.0 N act on the structure shown in fi fourth force F4 to…

A: Analyzing the horizontal forces (which add tozero) we find Fh = F3 = 5.0 N. Equilibrium of vertical…

Q: Determine the height h above the base B at which the resultant of the three forces acts. 290 lb 24"…

A: Given:              F1= 615 lb              F2 = 290 lb               F3 = 280 lb

Q: 10NA A(2,3, 5) B(3, 1.-2) D(-4, -2.0) C(4,0, 10) In the above, B, C, D are fixed and their…

A: First, we calculate unit vectors along AB, AC, AD…

Q: Q3 1m An external force is applied to the beam, as shown below. The beam is supported at A and B,…

A:

Q: The coefficient of friction between blocks is us = 0.4, at what angle will the block start sliding…

A:

Q: (b) In the figure shown below, three forces F1, F; and F3 acting on the ring Usang the component…

A:

Q: 2. Find the value of P and F so that the four forces shown in the figure produce an upward resultant…

A: We have to use the condition that total force is 300 lb upward and total torque is 4ft×300lb. From…

Q: The resultant of three parallel loads is 30ON acting at 7m to the right of A. Compute the magnitude…

A:

Q: It is desired to remove the spike from the timber by applying force along its horizontal axis. An…

A:

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown,…

A: GivenTwo rods and one cable are attached to the supports at 0as shown in given figure

Q: 1) The rectangular prism shown in the figure is supported by a ball-and-socket at A, and the…

A:

Q: 4. Determine the resultant of the three forces F= 2.5 -3.3j-2.6k Ib, P=-itj-2.5k Ib, and…

A: Resultant force in x direction = sum of components of forces F, P and S in x direction So net force…

Q: P= 800 N Aa 8 m T= 600 N B 6 m C 60% D y I L--x

A: Given:-  A diagram is given as  Find:-  Combine the two forces P and T, which act on the fixed…

Q: ASK YOUR TEACHER The figure below shows a clawhammer as it is being used to pull a nail out of a…

A:

Q: QUESTION 1 5° 5 kN The two 5-degree wedges shown are used to adjust the position of the column under…

A: Free body diagram gives whole idea of the forces acting. Force brings about motion and changes in…

Q: Calculate the 4th Force you need to add to the 3 Forces given below to achieve equilibrium. = 1 F₁ =…

A: The force F1 = 20 N , F2 = 10 N and F3 = 30 NTotal x component of…

Q: D E A C h W Find the tension developed in cable AD, given: w = 260 N, 0 = 50°, = 25°, x.y,h= 4,3,5,…

A:

Q: a) Determine the tension in cable OD required to support the crate b) Determine the tension in…

A:

Q: The 1,094 kg uniform beam is subjected to the three external loads shown. Compute the force reaction…

A: Given data- weight of beam W=mg=(1094 kg)(9.8 m/s2)=10721.2 N=10.7 kN at point A=1.4 kN=1400 N…

Q: 7) Let P= 20 kN. What is the tension in the cable? (Hint: If you want to know the internal force you…

A: in this question  we drew FBD and get equilibrium  equation at different point.

Q: 3) If the block remains in the equilibrium position shown, determine the mass of the block D. -d, m…

A: Given: d1=10m, d2=11m, kAC=43N/m, kAB=82N/m, x=9m Refer to the free body diagram below :

Q: 3-22 Struts Al and AC of Pig, P3-22 can transmit only av- ial tensile or compressive forces.…

A: Consider the coordinate system and write the coordinate for point A, B, C and D.

Q: A bicyclist applies a 43-N force to the brake lever of her bicycle as shown. Determine the…

A:

Q: Question 6 a) Figure Q6a shows a bracket that can roll and move horizontally along a beam. A 1600 N…

A: Step 1:Step 2:

Q: In the figure shown, if the weight of the beam is 300 N. What is the force exerted by the beam on…

A:

Q: Indicate the magnitude of the other Force components. Use values given. Angle of drawing may not be…

A: The horizontal force acting on A is The distance  is The distance  is Hypotenuse of the triangle…

Q: It is desired to remove the spike from the timber by applying force along its horizontal axis. An…

A: Lets find the angle of P (θ1) with horizontal:- Using trigonometry we can say that:- tan(θ1)= 5/10 =…

Q: QI) Determine the magnitude and direction of F, so that If the resultant of the three forces act on…

A: In this problem, the resultant force is 250 N and it makes an angle of 20o clockwise from positive…

Q: QUESTION 16 Five forces: Fi, F2. Fs, Fa and Fs are applied to point O. The RI= Fi = 40 N 30 force F2…

A:

Q: QI) Determine the magnitude and direction of F; so that If the resultant of the three forces act on…

A: Let the angle between F1 and F2 be φ and between x-axis and resultant force be α. The resultant…

Q: Q.5) Two weights C = 2000 N and D = 1000 N are located on a horizontal beam AB as shown in 4 m…

A: Given : Weight of C = 2000 N Weight of D = 1000 N If considering reaction at A as RA and reaction at…

Q: The resultant of three parallel loads is 300N acting at 7m to the right of A. Compute the magnitude…

A: Given:

Q: 65 kN 25° 80 kN 10°

A:

Q: Given a set-up like that described in the figure below you measure T2 = 8N and 02 = 140° while T3 =…

A: T2=8(cos140i+sin(140)j)T3=12(cos295i+sin(295)j) Let,   T1=F(cosθi+sin(θ)j)

Q: Find the resultant of the three forces acting on the eye bolt.

A: Given:   Find : the resultant of the three forces acting on the eye bolt.

Q: Fis the upward force exerted by the biceps and R is the downward force exerted by the upper arm at…

A: For a system in mechanical equilibrium, the Net force and the net torque acting on the system will…

Newton's First Law of Motion

If a very smooth ball is rolled down an inclined surface with zero friction, the ball will continue to roll indefinitely for an infinite time, in an attempt to reach to the same height on the opposite hill!