(QI-A) In the tank contains oil, water, and glycerin, a mercury manometer is attached to the o bottom as illustrated. Calculate the manometer reading of h. Yay-12.4KN/m', SAE 30 O 0.1m Water (2) 0.1m Giycenie (QI- B) Derive the hydrometer equation in oil 0.1m Mercury

(QI-A) In the tank contains oil, water, and glycerin, a mercury manometer is attached to the o bottom as illustrated. Calculate the manometer reading of h. Yay-12.4KN/m', SAE 30 O 0.1m Water (2) 0.1m Giycenie (QI- B) Derive the hydrometer equation in oil 0.1m Mercury

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 450 mm 150m -0. 375 mm Mercury S = 13.6

A: Given data Diameter of inlet= 450 mm Diameter of throat = 150 mm Specific gravity of mercury =…

Q: A U-tube mercury manometer is used to measure pres- sure of oil flowing through a pipe at a point.…

A: Specific gravity of oil (So) = 0.8Oil head = 50cm = 0.5 m Mercury head = 150 cm = 1.5 m

Q: Oil of sp.gr. of 0.750 flows through the nozzle shown and deflects the mercury in the U-tube gage.…

A: The given data is shown below: Specific gravity=0.75Pressure at A=142 kPa

Q: FRESHMEN What is the value of F required to balance the weight of the cylinder if the weight of the…

Q: the discharge coefficient of a Venturi .... meter has a value ............ 0.6 0.92 to 0.99 venturi…

A: Venturi meter- Venturi meter is a type of flowmeter that works on the principle of Bernoulli’s…

Q: Home Work Example: For the system shown in Figure calculate the height H of the oil at which the…

A: Given:- The specific gravity of the oil = 0.8 The air pressure = 30 kPa The width of the gate = 0.6…

Q: A Cole pitometer is set with its orifices at the center of a 40cm pipe. For three different rates of…

A: We know that ; Discharge = Area * Velocity Q = A * V A = π4(d)2 =π4(0.4)2 = 0.126 m2 V = Velocity V…

Q: weight of water is 9810 Nm' Gasoline line is connected to a pressure gage through a double-U…

A: Given data : Acceleration due to gravity (g)=9.81…

Q: What is the SG of the liquid in the differential manometer shown below if the differentia pressure…

A: Given that PA-PB = 32.5 γw = 0.036 lb/in3 SL = specic gravity of liquid PA+ SL*γW*66.6 -…

Q: In a test to determine the the discharge coefficient of a 50-mm by 12.5-mm Venturimeter the total…

Q: 1. A venturi meter is used to measure the water flow in a pipe with the diameter of 85mm. The…

Q: 2 In Figure below, sensor A reads 1.75 kPa (gage). All fluids are at 12°C. Determine the elevations…

Q: The system shown below is released from rest. Determine the acceleration of mass A. (Hint: start by…

A: We have to determine the value of acceleration of mass A as per the given data in the question like…

Q: Stops Piston Gas m=5 A-0

A: Given: Patm=1 barm=50 kgA=0.01 m2g=9.81 m/s2

Q: To what height mercury rises in the U-tube in the figure below? Elev 6 m Elev 5 m Air pressure-30 k…

A: To find value of h

Q: Problems (5.2) Figure below shows a conical vesse! having its outlet at A to which a U-tube…

Q: A 90-Pa capacity manometer has a reading error of + 0.421 mm. Determine the ratio of d/D so that the…

Q: *5-8. The level of mercury in the manometer has the reading shown. Determine the velocity of the…

A: Determine the the velocity of the water flowing from the nozzle at B ?

Q: Gasoline line is connected to a pressure gage through a double-U manometer, as shown in Figure (1).…

A: The gasoline pressure is connected to a pressure gauge through the double U manometer. there are…

Q: 1. In Figure below, sensor A reads 3.5 kPa (gage). All fluids are at 15°C. Determine the elevations…

A: PA=3.5kPa

Q: 14 in, da measures 3 in. If SGmercury is 13.55, a) calculate the pressure difference (in psi)…

Q: 299 PROBLEM: Determine the discharge of the system shown if the loss of head between A and D is 5.40…

Q: m Given: m = 0.3 kg; v4 = 4 –;t = 0.1 s; R = 0.6 m; µ = 0.35; a = 30°; N B = 15°; h, = 60 cm; k =…

A: You have asked many questions as per guide lines we can answer first one, for rest of the questions…

Q: A cylinder of cross-sectional area 2657 mm² is filled with sand of permeability 16 cm/sec, water is…

A: Given Data Permeability of soil (K) = 16 cm/sec Time of testing (t) = 10 minute Cross sectional…

Q: 3. In Figure below, sensor A reads 2.2 kPa (gage). All fluids are at 22°C. Determine the elevations…

Q: Elev= (a+6) Elev= (a+5) Air pressure - 30kP Oil (- 082) Elev= (a+2) Water Elev= a 1.00 m Mercury ( -…

Q: Determine the velocity inside the pipe 0.5-m-dlameter using the pitot tube installed. The difference…

A: Difference in head and pipe diameter have been given and it has been asked to determine velocity…

Q: A manometer is connected to a tank on the side (see below). There are two layers of different…

A: A manometer is connected to the bottom of the tank for measuring pressureSpecific Gravity of Water=…

Q: Figure 1 shows the manometer apparatus with different fluids. mercury and oil are 13.56, and 0.9…

A: Given data in question Specific gravity Depth Area ratio Volume x = Volume y To find out Delta Z…

Q: * In fig. FV = -----? If the tank width is 5 m (into the paper) Water 4m 5m C -5m- B

Q: 3. In Figure below, sensor A reads 2.5 kPa (gage). All fluids are at 10°C. Determine the elevations…

Q: 10. Which device is popularly used for measuring difference of low pressure? a) Inverted U-tube…

A: Fluid mechanics is the discipline of physics that studies the mechanics of fluids (liquids, gases,…

Q: The ligure shoWs a tank discharging through a pipe with a nozzle at Its end. Find the discharge and…

Q: Oil, S= 0.9 0.125 m Water 0.9 m B Hg (13,00 kg/m)

A: Atmospheric pressure, Patm=101.325kNm2 Unit weight of water, γw=9.81kNm3 Unit weight of mercury,…

Q: Hava 0,20 m 1,0 m Yağ Civa (1)

A: find pressure at 1 by balancing the pressure at different points density of mercury = 13.6×1000…

Q: Venturi meter is used for measuring the flow rate of fluids in pipeline ..... Compressible O…

A: ANSWER: Both Top

Concept explainers

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.

Question

(Q1-A) In the tank contains oil, water, and
glycerin, a mercury manometer is attached to the 0.1m
(1)
SAE 30 O
bottom as illustrated. Calculate the manometer
reading of h., Yaly=12.4KN/m',
0.1 m
Water
(2)
0.1 m
Gycerin
(QI- B) Derive the hydrometer equation in oil
0.1 m
Mercury

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Inclined U-tube manometer: (1)- Figure 2.12 © John Wiley & Sons, Inc. All rights reserved. 72 PA = 6.5 kPa, PB = 4.5 kPa p = 1000 kg m m³ g = 9.81 $2 h₁ and h3 are neglected Calculate 12 at 0 = 30° and 0 = 60º
M MEQ2.jpg 200mmø 690mm 300 mm 400 mmø Z Hg (13.6) A 200mm diameter venturi meter is installed in a 400mm diameter vertical main pipe as shown. If the deflection of mercury (SG = 13.6) at the manometer reads 300mm and the vertical distance between point 1 and point 2 is 690mm, determine the discharge in the system assuming a head loss of 600mm. Hide answer choices a A) 307.36 L/s B) 279.84 L/s No Answer among the choices D) 224.67 L/s 256.29 L/s O O O O C
4. In Figure below, sensor A reads 1.5 kPa (gage). All fluids are at 20°C. Determine the elevations Z in meters of the liquid levels in the open piezometer tubes B and C (Yair 12 N/m?, Yasoline x 6670 N/m2, Ygiycerin * 12360 N/m?) Air Gasoline Glyoerin
i need the answer quickly
Fluid 3
300 mme 100 mmø H20, 2) 500mm A 100mm diameter venturi meter is installed in a 300mm diameter horizontal main pipe as shown. If the deflection of mercury (SG = 13.6) at the manometer reads 500mm, determine the discharge in the system assuming a head loss of 700mm. (A) 82.84 L/S (B) 78.63 L/s No Answer among the choices (D) 87.68 L/s (E) 93.21 L/s
5. Oil, with S.G. 0. 6, flows on a pipe, with center m as shown in Figure 4. Attached on this pipe is a piezometer at point A and tubes for open type manometers at both points B and C. At the end of the tube attached to point B is a fluid, called Fluid Y, which has a height hz and a specific gravity of S.G. = 1.497. At the end of the tube attached to point C is a fluid, called Fluid X, which has a height h, and a specific gravity of S.G. 13.6. How much greater is the height of fluid Y than that of fluid X? Express this relationship in percent (%). Y h2 B Figure 4. Oil Pipeline with a Piezometer and Open Type Manometers
Q.1 (50%): Determine the pressure difference between points A and B in Fig. below. Kerosene rd.-0.82 -Air r.d. 0.0118 Trocm Benzene 21cm 90 cm 15 cm r.d=0.88- 'Water Mercury r.d.=13.6
6 PLEASE PROVIDE COMPLETE SOLUTION
نقطة واحدة * :Q 5 Q: The tank in Figure is closed at top and contains air at pressure PA. Calculate the value of PA of manometer readings shown. Air Open tube Oil(S.G-0.7 150 cm 200 cm Wat 10 cm Mercury
Please solve using MLT system. F=MLT^(-2) (Hand written and neat and clean answer )
Quick solution plz.. within 5 min.